Safety
10
2Safety
WARNING! Improper use of the device.
Danger to the operator.
The safety chapter contains important information on the safety of the device: Please read
thoroughly prior to installation and operation.
The device is built according to state-of-the-art technology and recognized safety regulations.
Nevertheless, its use could constitute a risk of injury of the user or third party or possibly cause
impairment to the device and other property.
2.1 Intended use
PrograMill One is designed for milling and grinding in wet operation in the field of dental
technology. Use PrograMill One exclusively for this purpose.
In the case of damage caused by improper use or failure to observe the Operating Instructions,
all liability and guarantee claims are void.
Please note that only the areas of use, materials and milling strategies approved by the
manufacturer ensure processing without damage to the machine.
The machine has been designed for milling the following materials:
•Glass-ceramics (IPS e.max®CAD, IPS Empress®CAD)
•Composite blocks (Tetric®CAD)
Only approved blocks and tools can be identified and thus be used by PrograMill One via a
data matrix code on the block or on the tool, which ensure that misapplication is nearly
impossible.
Basically, all Ivoclar Vivadent materials and tools in their respective categories are suitable for
processing (“Approved tools for glass-ceramic / composite blocks”, page 139).
All information regarding approved materials and areas of use corresponds to the state of
knowledge at the time of going to print. For additional details, go to http://
www.ivoclarvivadent.com.
It is not recommended to process materials or use tools from other manufacturers in this
system due to the absence of milling strategy coordination and lack of tool harmonization.
