iTechworld 1000W Manuel utilisateur
(Revised 01/2022)
USER GUIDE
Introduction:
Thank you for purchasing the iTechworld pure
sine wave inverter remote control (RC1). This
remote control will allow you to turn your
inverter on/off from a distance. The remote
control (RC1) also allows you to monitor your
battery capacity, DC power input, load being
drawn from your inverter and AC output.
Figure 1 – RC1 Remote Control
A
Remote Control Main Switch
B
Fault LED Indicator
C
AC Output Indicator
D
Inverter Load Indicator
E
DC Input Power Indicator
F
Battery Capacity Indicator
A. Remote Control Main Switch
The main switch is used for turning ON
or OFF the output of the inverter. With
the switch in the ON position, the AC
Output Indicator LED(C) will glow green
to indicate 240VAC is being produced.
B. Fault LED Indicator
Will illuminate/flash red when a fault is
detected, the 240VAC output will be
turned off. Please refer to the
troubleshooting section.
C. AC Output Indicator
Will illuminate green to show that the
inverter is outputting 240VAC power.
D. Inverter Load Indicator
Displays the approximate load being
drawn from the inverter.
E. DC Power Indicator
Will illuminate green to show that DC
power is being supplied to the inverter.
F. Battery Capacity Indicator
Displays the approximate remaining
capacity of the battery running that is
connected to the inverter.
Connecting the remote control
The remote control is connected to the inverter
with the communications cable, supplied with
the purchase of the remote control. The cable
is a 6-conductor RJ11 cable (the pinout of the
connector is a Straight Pinout and NOT
Reverse, refer to the image below). The cable
is connected to the RJ-11 ports found on the
rear of the remote and on the front panel of
the inverter (Port F in figures 1 and 2 of your
inverter’s instruction manual).
Figure 2 – RC1 Remote Control
Using the remote control
When using the remote control to turn the
inverter on or off, please make sure the Main
Switch on the inverter front panel is in the OFF
position, or the remote-control main switch will
not work.
Contact
iTechworld
281 Great Eastern Hwy
Burswood WA 6100
Phone:
1300 483 249
Website:
www.itechworld.com.au
E-mail:
Autres manuels pour 1000W
1
Ce manuel convient aux modèles suivants
2
Table des matières
Autres manuels iTechworld Onduleur
