ISP Technologies HDDS SM 650W Manuel utilisateur

IMPORTANT SAFETY INSTRUCTIONS!

Please read this very carefully before operating this unit

 Read ALL instructions carefully before using this unit.

 Do not operate this unit near water, in the rain, or where there is

moisture. If this warning is ignored a serious electrical shock or death

may occur.

 Do not attempt to service this unit. No user serviceable parts inside.

Refer servicing to qualified, ISP approved service personnel.

 Never remove or defeat the ground connection on the power cord of

this unit.

 Care should be taken to avoid spilling any foreign objects or liquid

into this unit.

 Failure to follow these instructions may void the warranty.

INTRODUCTION

Thank you for your purchase of the ISP Technologies High Definition Distributed System

SM650 Surface Mount Speaker. This product provides a new level of performance in

distributed audio systems allowing greater system flexibility and easy installation of

distributed sound. All connections are made via Cat5 RJ45 connections making

installation of systems faster and easier using the SM650.

PRECAUTIONS

NOTE: IT IS VERY IMPORTANT THAT YOU READ THIS SECTION TO PROVIDE

YEARS OF TROUBLE FREE USE. THIS UNIT REQUIRES CAREFUL HANDELING.

All warnings on this equipment and in the operation instructions should be adhered to and

all operating instructions should be followed.

Do not use this equipment near water. Care should be taken so that objects do not fall

onto and liquids are not spilled into the unit through any openings.

The power cord should be unplugged from the outlet when the unit is left unused for an

extended period of time.

DO NOT ATTEMPT TO SERVICE THIS EQUIPMENT. THIS EQUIPMENT SHOULD BE

SERVICED BY QUALIFIED SERVICE PERSONNELL ONLY. DO NOT MAKE ANY INTERNAL

ADJUSTMENTS OR ADDITIONS TO THIS EQUIPMENT AT ANY TIME. DO NOT TAMPER

WITH INTERNAL ELECTRONIC COMPONENTS AT ANY TIME. FAILURE TO FOLLOW THESE

INSTRUCTIONS WILL VOID THE WARRANTY OF THIS EQUIPMENT, AND MAY CAUSE A

SHOCK HAZZARD.

OPERATION

The HDDS Master Control Module is the Master control center for distributed sound

systems using the HDDS technology. The Master Control Module includes six zones

that can be used independently or can be linked to work together allowing the system

designer the flexibility to set up any system with the desired configuration. The block

diagram below shows the basic configuration of the SM650 Surface Mount Speaker.

The speaker receives power and audio over a Cat5 cable connected to the Master

Control Module, internally converts the AC power to plus / minus 15VDC and 30VDC to

power the amplifier. The audio signal is fed to a precision differential amplifier to

remove any common mode noise, filtered with a crossover circuit to produce a low pass

and high pass signal, equalized and fed to D-CAT power amplifier circuits to drive both

the woofer and tweeter in the speaker. The speaker includes an onboard level

adjustment that allows simple balancing of installed systems.

The HDDS SM650 is available is both black and white. Both models include a front

mounted blue power indicator LED, which illuminates when power is on.

Rear Panel

The rear panel includes two RJ45 connectors one for input and one for output. The

SM650 also includes a level control and a power jack that allows connection to an

external 18VAC power adaptor available from ISP Technologies. Connect the input to

the output connector on a HDDS Master Control Module. A Cat5 cable is used to

connect the output connector to another SM650 or to connect to any other ISP

Technologies HDDS powered speaker. The power connection on the back of the

SM650 can be used to power the speaker as a stand-alone speaker or can also be used

to add additional power if a long run of Cat5 cable is used. The system is designed to

allow both the Cat5 cable to supply power plus the external adaptor at the same time

without the risk of damage. The internal power supply will simply derive power for the

power source with the highest voltage available.

The SM650 will typically pull less than 500 milliamps of current from the output of the

Master Control Module with typical listening levels. At maximum level the SM650 can

pull in excess of 1 amp of current. If maximum output power is desired it is

recommended to limit the number of serially connected SM650 speakers on a single

50ft run of Cat5 cable to no more than 5 speakers. With longer runs of cable the limit

will be reduced in order to achieve full output power. Connect the SM650 to any of the

A,B or C outputs on the rear of the HDDS Master Control Module as shown below.

SPEAKER POWER:

The HDDS system distributes low voltage Alternating Current over the Cat5 cable plus

high level balanced audio and is capable of greater than 30 watts continuous power per

speaker SM650. Each of the three outputs A, B and C are capable of delivering up to 7

amps of output current. With a typical power per speaker of 10 watts each speaker will

consume on the order of 400mA, which means that 12 speakers would require 4,800mA

of current. Installed systems that require more output power per speaker simply

require that the number of speakers per output A, B and C be reduced so as not to

exceed the maximum of 7 amps available. The current consumption at full power (30

watt continuous) will require over 1 Amp of power per speaker. In order to allow the

full 30 watts of power where higher output levels are desirable the number of speakers

per A, B and C outputs on each zone needs to be limiting the maximum number 5.

Reducing to 20 watts of power per speaker, a maximum of 8 speakers per output can

be connected to each A, B and C zone output. With longer runs of cable exceeding 150

feet the cable voltage drop will start to become a design factor. The Cat5 cable will

start to limit the total power capability once you exceed 75 feet of cable. Where

maximum power output is critical a more precise calculation can be done by following

the speaker consumption guide.

Cat5 Connections

The figure below shows the connections for each output A, B and C of each zone output

on the Master Control Module and also connections between each SM650 speaker.

Connections are done via standard Cat5 cables where pins 1 through 8 are connected

common to the same pins 1 through 8 at each end. As shown below two wires in the

Cable are use for balanced audio and 6 wires are used for power with two providing

ground and two for each of two 22VAC power signals fed down the cable.

Mounting the SM650

Refer installation to a qualified installer to ensure proper mounting to overhead

structures. The SM650 includes a U bracket for easy install. When mounting requires

additional swivel mount capabilities use ISP Technologies SM10 swivel mount bracket

shown below.

The swivel mount bracket threads into one of the threaded inserts on the back of the

SM650 and allows wall mount or ceiling mounting of the speaker with full swivel

capabilities. The SM10 kit also includes two toggle bolts for mounting to drywall or

other structures.

HDDS SM650 SPECIFICATIONS

POWER CONSUMPTION: 400 mA typical 1.8 amps Maximum

AUDIO INPUT: Balanced 50k input impedance

LEVEL CONTROL: Maximum –Minimum level 70db

COVERAGE: 90 Vertical x 90 Horizontal

FREQUENCY RESPONES: 55Hz –20Khz

WEIGHT: 8LBS

SPEAKERS: 6-1/2 Polypropylene woofer

5/8 Polycarbonate Tweeter w ferro fluid

5/8 Piezoelectric Super Tweeter

Includes “U” Style Mounting Bracket

WARRANTY AND SERVICE

The unit, parts and workmanship are fully guaranteed to be free of defects under

normal use and service for a period of 3 years from the date of purchase.

Any damage resulting from the misuse or the failure to follow the precautions and

instructions will void the warranty.

In the event that the unit needs to be repaired, please return the unit to ISP

Technologies directly. Simply repack the unit, send a copy of the original receipt, a

note stating the problem, and send it to:

ISP Technologies, LLC

5479 Perry Drive Unit B

Waterford, MI 48329

Attn: Repair Dept.

All shipping charges must be fully prepaid.

ISP will not be responsible for any damages incurred in shipping of any unit. Any claim

will need to be settled with the shipping company.

The warranty will be voided if the serial number has been tampered with in any way.

The warranty card must also be filled out and returned in order to activate the

warranty.

Should you have any questions for the repair department prior to returning the product

please call 1-(248)-673-7790

NOTE: This Product is covered under one or more of the following patents with other

patents pending: 7,035,413; 6,944,305; 6,931,134; 6,831,514; 6,091,013

ISP TECHNOLOGIES, LLC

5479 PERRY DRIVE SUITE B

WATERFORD, MI. 48329

248-673-7790

FAX: 248-673-7696

WWW.ISPTECHNOLOGIES.COM

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels iSP Technologies Intervenants

iSP Technologies

iSP Technologies HDDS CS650 Manuel utilisateur

iSP Technologies

iSP Technologies HDDS Series Manuel utilisateur

iSP Technologies

iSP Technologies ACTIVE 3112 Manuel utilisateur

iSP Technologies

iSP Technologies VT110 Manuel utilisateur

iSP Technologies

iSP Technologies HDDS SM652-B Manuel utilisateur

iSP Technologies

iSP Technologies HDDS SM800 Manuel utilisateur

iSP Technologies

iSP Technologies VECTOR FS Manuel utilisateur

iSP Technologies

iSP Technologies VMAX 1500 Manuel utilisateur

iSP Technologies

iSP Technologies HIGH DEFINITION LINE 2208Active Series Manuel utilisateur

iSP Technologies

iSP Technologies HDDS CS651 Manuel utilisateur

Manuels Intervenants populaires d'autres marques

argon audio

argon audio IE20 Manuel utilisateur

Denon

Denon SC-N7 Manuel utilisateur

Gemline

Gemline Ace 3952 Manuel utilisateur

Focal

Focal ON WALL 300 Mode d’emploi

HEADRUSH

HEADRUSH Maximus HRSP 5024 Manuel utilisateur

SoundLogic

SoundLogic BCCS-6/6395 Manuel utilisateur

Peavey

Peavey DTH 218 Manuel utilisateur

Avantree

Avantree Pluto Air Manuel utilisateur

Morel

Morel Integra Series INTEGRA OVATION 4 Manuel utilisateur

Oppo

Oppo SONICA Manuel utilisateur

Bose

Bose SoundLink Wireless Music System Manuel utilisateur

Rocksteady

Rocksteady Stadium Manuel utilisateur

Bowers & Wilkins

Bowers & Wilkins 4 Manuel utilisateur

Sonance

Sonance SONOS OUTDOOR Series Manuel utilisateur

Electro-Voice

Electro-Voice EVID FM4.2 Manuel utilisateur

Pioneer

Pioneer XW-HTD630 Manuel utilisateur

Onn

Onn BWA16AA002 Manuel utilisateur

HP GL313AA - USB Speakers PC Multimedia Manuel utilisateur

iSP Technologies HDDS SM 650W Manuel utilisateur

Manuels Intervenants populaires d'autres marques