06-0131-EN: Installation guide
Page 2 / 2 EN-V231-0121-AA
WIRING AND SETTING A DOOR CONNECTED TO A RELAY BOARD
The power supplied to the magnet lock must be less than 42 V AC or 60 V DC. If the power supply
voltage exceeds these values, use an intermediate relay (of the correct capacity) to control the
electric lock.
IMPORTANT: The proper operation and long-life are dependent on the fitting of the varistors supplied with the central unit.
1. Varistors must be connected as close as possible to the electric lock or magnet.
2. Free access times should be avoided for doors fitted with electric locks!
3. The varistor supplied is 12 V.
IF YOU INSTALL SEVERAL POWER SUPPLIES, ENSURE THAT YOU CONNECT EACH EARTH (-) TOGETHER.
Door release
time
Door
delay
The complete pack for managing an isolated door with
1 square proximity reader (04-0106-EN)
1 relay central unit (12-0110-EN)
Power supply
Electric lock
Potentiometer
setting range
