inTouch R&B
HVAC Minder
INSTALLATION
INSTRUCTIONS
Important Safety Information
Failure to follow these warnings, cautions, and notices could
result in personal injury, damage to the vessel or device, or poor
product performance.
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
When connecting the power cable, do not remove the in-line
fuse holder. To prevent the possibility of injury or product
damage caused by fire or overheating, the appropriate fuse
must be in place as indicated in the product specifications. In
addition, connecting the power cable without the appropriate
fuse in place voids the product warranty.
To avoid possible personal injury, always wear safety goggles,
ear protection, and a dust mask when drilling, cutting, or
sanding.
To avoid possible personal injury or damage to the device and
vessel, disconnect the vessel's power supply before beginning
to install the device.
To avoid possible personal injury or damage to the device or
vessel, before applying power to the device, make sure that it
has been properly grounded, following the instructions in the
guide.
For the best possible performance, the device must be installed
according to these instructions.
When drilling or cutting, always check what is on the opposite
side of the surface to avoid damaging the vessel.
Read all installation instructions before proceeding with the
installation. If you experience difficulty during the installation,
contact inTouch R&B® Product Support.
Contacting inTouchRandB Support
• Go to inTouchRandB.com/support for help and information,
such as product manuals, frequently asked questions,
videos, and customer support.
• In the USA, call 231-468-6824.
Tools Needed (not supplied)
• Drill
• Drill bits appropriate for the surface and hardware
• Phillips screwdrivers
• Mounting screws
• Pencil
Mounting Considerations
NOTICE
This device should be mounted in a location that is not exposed
to extreme temperatures or conditions. The temperature range
for this device is listed in the product specifications. Extended
exposure to temperatures exceeding the specified temperature
range, in storage or operating conditions, may cause device
failure. Extreme-temperature-induced damage and related
consequences are not covered by the warranty.
• You must mount the device in a location where it will not be
submerged.
• You must mount the device in a location with adequate
ventilation where it will not be exposed to extreme
temperatures.
• You must mount the device at least 100 mm (4 in.) from
sources of interference.
• You must mount the device in a location that allows room for
the routing and connection of all cables.
• You must mount the device with the clear cover facing up
when mounted on a horizontal surface or out when mounted
on a vertical surface.
• For the best WiFi signal, mount the device where it is in
range of the WiFi Access Point. If it is mounted inside of a
cabin or wall, it should be must be able to receive the WiFi
signal.
1
July 1, 2020
