REMOVAL OF WASTE CLIPPINGS
The waste tray is located under the machine and is accessed from the front side. For best
results empty the tray regularly.
TROUBLESHOOTING
Problem Cause Solution
Punched holes are not central Edge guide not
Adjust edge guide until hole pattern
is correct
Machine will not punch Blockage Check waste tray is empty.
Check for blockage
Punch holes are not parallel
to edge
Debris is stuck below dies
Take stiff cardboard and slide into the
paper entry. Move the cardboard side-
ways to release any stray clippings
into the waste tray
Partial holes Sheets not correctly aligned
to punch pattern
Adjust edge guide and test punch
scrap sheets until correct
Damaged hole edges Possibly overloading the
machine
Punch plastic covers with paper
sheets.Reduce number of sheets being
punched
P/06
