Intermec 6651 Manuel utilisateur

1. Remove the keyboard hard cover. Place your fingers on the left and

right tabs (slightly jutting out), then gently lift up the keyboard hard cover

and remove.

"NOTE: Keep the keyboard hard cover, it is reusable.

Replace the cover the same way you removed it.

2. Press the POWER (On/Off) key to turn on the 6651.

3. Adjust the display contrast by tapping on the brightness icons

located on the lower right side of the display, or press the Fn key while

holding down the ← or → keys on the keyboard.

4.Follow the instructions and adjust the screen calibration, time zone set-

ting, time and date, and your name and address.

Power off the unit by pressing the POWER (On/Off) key for one second.

Intermec is a trademark of Intermec Technologies Corporation.

PN: 962-054-027

Revision A

May 2000

*962054007*

P/N 962-054-027 Revision A

6651 PEN COMPUTER

QUICK START GUIDE

Packing List

Quick Start Guide P/N:962–054–027

AC Adapter/Charger P/N:871–012–020

Serial Cable P/N:871–012–060

Battery Pack P/N:871–012–010

Pen Stylus P/N:871–012–040

Keyboard Cover P/N:871–012–050

AC Power Cable P/N:851–036–010

Installing and Charging the Batteries

1. Install the main battery, then the backup batteries.

Set the device bottom side up on a cushioned surface and then open the

display by lifting the center latch.

2. Slide the lock switches to the unlocked position.

3.Align the main battery pack with the rails of the 6651 and push it

straight in.

4.Slide the lock switched the locked position. If the lock switches cannot

be moved, pull out the battery pack, then reinsert it.

"NOTE: Both lock switches must be locked or the 6651 won’t

power on.

5.Close the display.

6.Remove the screws from the backup battery cover.

7.Lift up to remove the backup battery cover.

8.Install two CR2032 backup batteries with the plus (+) side up.

Slide the battery to the left and press down. Avoid touching the other

parts.

9.Replace the backup battery cover, and attach the screws.

10. Plug the DC power plug from AC adapter/charger into the DC input

jack on the edge of the 6651. Connect the AC power cord adapter end

into the AC adapter/charger first, then insert the AC plug into a wall outlet.

After a few seconds, charging starts and the orange LED on the 6651

starts blinking.

Charging time is approximately 2.5 hours. When charging is completed,

the LED stops blinking, but stays lit.

11. When charging is completed, disconnect the AC adapter and the

power cord.

"NOTE: Charging can be performed while the device is in

use.

"NOTE: Be sure to disconnect the DC power plug from the

6651 before opening the display fully, or you could

damage the DC power plug or the DC input jack.

Setting up the Device

Open the display.

Place your fingers on the tabs to the left and right of the 6651 center

cover latch, and open the display.

Autres manuels pour 6651

Table des matières

Autres manuels Intermec PDA

Intermec

Intermec 5020 Manuel utilisateur

Intermec

Intermec 700 Series 730B Manuel utilisateur

Intermec

Intermec PEN*KEY 6400 Manuel

Intermec

Intermec CN51 Manuel utilisateur

Intermec

Intermec 5020 Manuel

Intermec

Intermec PEN*KEY 6620 Manuel utilisateur

Intermec

Intermec CN4 Manuel utilisateur

Intermec

Intermec 4500 Manuel utilisateur

Intermec

Intermec CN51 Manuel utilisateur

Intermec

Intermec 6500 Manuel d'utilisation et d'entretien

Intermec

Intermec CN70e RFID Manuel utilisateur

Intermec

Intermec CV30 Manuel utilisateur

Intermec

Intermec 6640 Manuel de programmation

Intermec

Intermec CK30 Manuel utilisateur

Intermec

Intermec Trakker Antares 2400 Manuel utilisateur

Intermec

Intermec 6300 SERIES Manuel utilisateur

Intermec

Intermec PEN*KEY 6200 Manuel utilisateur

Intermec

Intermec 6650 Manuel utilisateur

Intermec

Intermec PEN*KEY 6632 Manuel utilisateur

Intermec

Intermec CN70G Manuel utilisateur

Intermec

Intermec Trakker Antares 2410 Manuel

Intermec

Intermec 6220 Manuel utilisateur

Intermec

Intermec 6110 Manuel d'utilisation et d'entretien

Intermec

Intermec CN3 Series Manuel utilisateur

Manuels PDA populaires d'autres marques

SPOT

SPOT SPOT Manuel utilisateur

Palm

Palm handheld Manuel utilisateur

Winmate

Winmate E500QK Manuel utilisateur

Getac

Getac PS236 Manuel utilisateur

Sharp

Sharp CE-1600P Manuel utilisateur

HTC

HTC PHAR100 Manuel utilisateur

Mindeo

Mindeo M40 Manuel utilisateur

Acer

Acer n30 Manuel utilisateur

ASCOM

ASCOM 9D24 EX Manuel utilisateur

Unitech

Unitech PA520BTNF Manuel utilisateur

HandHeld

HandHeld Nautiz X3 Manuel utilisateur

Casio

Casio PALM Manuel utilisateur

Sharp

Sharp TM-20 Guide de démarrage rapide

Atid

Atid AT870 Manuel utilisateur

AML

AML M7225 Manuel utilisateur

Audiovox

Audiovox Maestro Manuel technique

Casio

Casio PV-750 Plus Manuel d'instructions et de sécurité

Unitech

Unitech PT630 Manuel utilisateur