2Intelligent Facility Solutions
INSTALLATION INSTRUCTIONS
ALWAYS ENSURE THAT THE INSTALLATION CONFORMS TO THE CURRENT EDITION OF THE IEE WIRING
REGULATIONS BS7671(UK) OR THE APPROPRIATE STANDARDS IN YOUR COUNTRY. ENSURE THAT THE
UNIT IS SEPARATELY FUSED WITH A SUITABLY RATED FUSE AND THAT IT IS CONNECTED TO THE SUPPLY
WITH A DOUBLE POLE ISOLATING SWITCH HAVING A CONTACT SEPARATION OF AT LEAST 3mm.
CARE SHOULD BE TAKEN THAT SINGLE INSULATED CONDUCTORS CANNOT COME INTO CONTACT WITH
THE MOUNTING SURFACE.
GENERAL SAFETY
DISCONNECT POWER BEFORE INSTALLATION OR SERVICING.
THIS APPLIANCE MUST BE EARTHED.
THIS PRODUCT IS INTENDED FOR INSTALLATION BY A QUALIFIED PERSON.
MOUNTING INSTRUCTIONS
THE UNIT MUST BE FIXED TO A SOILD SUPPORTING WALL. SEE SUPPLIED MOUNTING HOLE TEMPLATE.
RECOMMENDED FIXING HEIGHTS TO TOP OF UNIT ARE AS FOLLOWS:-
a). 1.5 METRES ABOVE THE FLOOR FOR NORMAL USE.
b). 1.3 METRES ABOVE THE FLOOR WHERE AVERAGE AGE OF USER IS BELOW 16 YEARS.
THIS HAND DRYER MUST NOT BE MOUNTED ABOVE SHELVES, SINKS OR RADIATORS TO ENSURE EASE
OF INSTALLATION AND SUBSEQUENT MAINTENANCE, THE HORIZONTAL DISTANCE TO ANY ADJACENT
WALL SHOULD NOT BE LESS THAN 0.2 METRES.
1.FIX THE MOUNTING HOLE TEMPLATE TO THE WALL, TO THE HEIGHT AS STATED ABOVE.
2.DRILL 4 HOLES 8mm T O A DEPTH OF 35mm.
3.REMOVE MOUNTING TEMPLATE.
4.FIT WALL PLUGS SUPPLIED INTO THE HOLES.
5.REMOVE THE COVER FROM THE HAND DRYER BASE PLATE.
6.FIX THE BASE PLATE TO THE WALL USING THE SCREWS PROVIDED.
7.WIRE UP HAND DRYER AS DETAILED BELOW.
8.ATTACH COVER BACK ONTO BASE PLATE.
9.CHECK HAND DRYER OPERATION.
WIRING DETAILS
TERMINAL BLOCK
1.CONNECT THE LIVE WIRE (COLOURED RED OR BROWN) TO THE TERMINAL MARKED “L”
2.CONNECT THE NEUTRAL WIRE (COLOURED BLACK OR BLUE) TO THE TERMINAL MARKED “N”
3.CONNECT THE EARTH WIRE (COLOURED GREEN & YELLOW) TO THE TERMINAL MARKED “ ”
SERVICING AND MAINTENANCE
THE MINIMUM SERVICE PERIOD FOR THE DRYER SHOULD BE EVERY 3 MONTHS OR MORE FREQUENT
INTERVALS AS EXPERIENCE DICTATES.
ISOLATE THE UNIT FROM THE ELECTRICITY SUPPLY BEFORE SERVICING, REMOVE DUST, FLUFF AND
ANY OTHER BUILD UP OF FOREIGN MATTER FROM INLET AND OUTLET GRILLE AREAS
