Intelicis Cedar 880AG Manuel utilisateur

Cedar 880AG

Enterprise Dual-Radio

Access Point/Bridge

User Guide

Release 1.3

June 2007

Cedar 880AG Enterprise Dual-Radio AP/Bridge

This product and documentation are protected by copyright. No part of this product or

document may be reproduced, transmitted, transcribed and stored in a retrieval system in

any form or by any means without prior written authorization of Intelicis.

Third Party Copyright Acknowledgements

Please refer to the license.pdf on the CD distributed with the Cedar 880AG Enterprise

Dual-Radio Access Point for complete third party copyright acknowledgements.

United States and Japan 802.11a 5250 Mhz ~ 5350 MHz Usage Note:

Due to US and Japan DFS requirement, the 802.11a radio frequency usage from 5250 Mhz to 5350

MHz is temporarily disabled for US and Japan models.This band will be enabled in the future

through firmware upgrade after the product has finished and passed DFS test.

FCC Compliance

This equipment has been tested and found to be in compliance with the limits for FCC

Part 15, Class B digital device. These limits are designed to provide reasonable protection

against harmful interference when the equipment is operated in a commercial

environment. This equipment generates, uses and can radiate radio frequency energy and,

if not installed and used in accordance with instruction manual, may cause harmful

interference with radio communications. Operation of this equipment in a residential area

is likely to cause harmful interference in which case the user will be required to correct

the interference at his own expense.

The users are prohibited from making any change or modification to this product, any

modification to this product shall void the user’s authority to operate under FCC Part 15

Subpart A Section 15.21 regulations.

“This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference and, (2)

this device must accept any interference received, including interference that may cause

undesired operation.

Caution

Reader should be positioned so that personnel in the area for prolonged periods may

safely remain at least 20 cm in an uncontrolled environment from the reader’s surface.

Observe FCC OET Bulletin 56 “Hazards of radio frequency and electromagnetic fields”

and Bulletin 65 “Human exposure to radio frequency electromagnetic fields.”

Frequency Stability Statement

A carefully chosen AT-cut crystal resonator that offers tight frequency tolerance and

stability over operating temperature is used in this device so that frequency stability of

Cedar 880AG Enterprise Dual-Radio AP/Bridge

this device is ensured to be within +/- 15 ppm that an emission is maintained within the

band of operation under all conditions of normal operation as specified in this users

guide.

Cedar 880AG Enterprise Dual-Radio AP/Bridge

1Introduction................................................................................................................... 8

1.1 Wireless Network................................................................................................ 8

1.2 Wireless LAN Bridge ......................................................................................... 9

1.3 Access Point Deployment................................................................................. 10

1.4 Application Deployment................................................................................... 11

2Installation................................................................................................................... 12

2.1 Package Contents.............................................................................................. 12

2.2 Physical Description ......................................................................................... 12

2.2.1 Top Panel.............................................................................................. 12

2.2.2 Rear Panel............................................................................................. 13

2.2.3 LED Description................................................................................... 13

2.3 Install the Unit................................................................................................... 14

2.3.1 Mounting Options................................................................................. 14

2.3.2 Supplying Power to the Unit................................................................. 14

2.4 Connecting Cedar 880AG................................................................................. 14

3Initial Configuration.................................................................................................... 15

3.1 Scan Tool.......................................................................................................... 15

3.2 Default Setting.................................................................................................. 17

3.3 Web Management Interface.............................................................................. 18

3.3.1 Menu..................................................................................................... 19

3.3.2 Tool Bar................................................................................................ 19

4System......................................................................................................................... 22

4.1 System Setting .................................................................................................. 22

4.2 Change Password.............................................................................................. 23

4.3 Upgrade............................................................................................................. 24

4.4 System Configuration ....................................................................................... 25

5Network....................................................................................................................... 28

5.1 Overview........................................................................................................... 28

5.1.1 VLAN ................................................................................................... 28

5.1.2 DHCP.................................................................................................... 29

5.2 Web Interface.................................................................................................... 29

5.2.1 Network Setting.................................................................................... 29

5.2.2 VLAN ................................................................................................... 31

5.2.3 DHCP.................................................................................................... 33

5.3 Examples........................................................................................................... 34

5.3.1 Configure Static IP Address.................................................................. 34

5.3.2 Configure Management VLAN ID....................................................... 34

6Security....................................................................................................................... 36

6.1 Overview........................................................................................................... 36

6.1.1 802.1x Authentication........................................................................... 36

6.1.2 MAC Authentication............................................................................. 37

6.2 Web Interface.................................................................................................... 38

6.2.1 RADIUS Profile.................................................................................... 38

6.2.2 802.1x Profile........................................................................................ 39

6.2.3 MAC Profile.......................................................................................... 40

6.2.4 Filter...................................................................................................... 42

Cedar 880AG Enterprise Dual-Radio AP/Bridge

6.3 Examples........................................................................................................... 43

6.3.1 802.1x Authentication........................................................................... 43

6.3.2 MAC Authentication............................................................................. 44

7Wireless....................................................................................................................... 45

7.1 Overview........................................................................................................... 45

7.1.1 WLAN................................................................................................... 45

7.1.2 Bridge Link........................................................................................... 45

7.2 Web Interface.................................................................................................... 46

7.2.1 Wireless Setting .................................................................................... 46

7.2.2 WLAN................................................................................................... 47

7.2.3 Radio..................................................................................................... 51

7.2.4 Bridge Link........................................................................................... 57

7.3 Examples........................................................................................................... 58

7.3.1 WLAN with WPA and 802.1x Authentication..................................... 58

7.3.2 WLAN with WEP and MAC Authentication ....................................... 59

7.3.3 Bridge Link........................................................................................... 60

7.3.4 Bridge Link with Multiple VLANs....................................................... 61

8Management................................................................................................................ 62

8.1 Management Setting ......................................................................................... 62

8.2 SNMP................................................................................................................ 62

9Log.............................................................................................................................. 64

10 Monitor ....................................................................................................................... 65

10.1 Interfaces....................................................................................................... 65

10.2 Wireless Statistics......................................................................................... 66

10.3 Rogue APs .................................................................................................... 66

10.4 Wireless Users .............................................................................................. 67

10.5 Wireless Link................................................................................................ 68

11 Command Line Interface ............................................................................................ 71

11.1 Base Commands............................................................................................ 71

11.1.1 enable.................................................................................................... 71

11.1.2 disable................................................................................................... 71

11.1.3 config save............................................................................................ 71

11.1.4 quit ........................................................................................................ 72

11.1.5 exit......................................................................................................... 72

11.1.6 reboot .................................................................................................... 72

11.1.7 reset....................................................................................................... 73

11.1.8 up arrow................................................................................................ 73

11.1.9 down arrow ........................................................................................... 73

11.1.10 debug................................................................................................. 74

11.1.11 undebug............................................................................................. 74

11.1.12 help.................................................................................................... 74

11.2 System Commands........................................................................................ 75

11.2.1 show system.......................................................................................... 75

11.2.2 config system........................................................................................ 75

11.2.3 show sntp .............................................................................................. 76

11.2.4 config sntp............................................................................................. 76

Cedar 880AG Enterprise Dual-Radio AP/Bridge

11.2.5 upgrade.................................................................................................. 77

11.3 Network Commands ..................................................................................... 77

11.3.1 show interface....................................................................................... 77

11.3.2 config interface ..................................................................................... 78

11.3.3 show vlan.............................................................................................. 78

11.3.4 config vlan ............................................................................................ 79

11.3.5 show ip.................................................................................................. 79

11.3.6 config ip................................................................................................ 80

11.4 Security Commands...................................................................................... 82

11.4.1 show auth.............................................................................................. 82

11.4.2 config auth ............................................................................................ 83

11.4.3 show filter ............................................................................................. 86

11.4.4 config filter............................................................................................ 86

11.5 Wireless Commands ..................................................................................... 87

11.5.1 show wireless........................................................................................ 87

11.5.2 config wireless...................................................................................... 88

11.5.3 show wlan ............................................................................................. 88

11.5.4 config wlan............................................................................................ 89

11.5.5 show radio............................................................................................. 90

11.5.6 config radio........................................................................................... 91

11.5.7 show brglnk........................................................................................... 92

11.5.8 config brglnk......................................................................................... 93

11.6 Management Commands .............................................................................. 93

11.6.1 show telnet............................................................................................ 93

11.6.2 config telnet .......................................................................................... 94

11.6.3 show ssh................................................................................................ 94

11.6.4 config ssh.............................................................................................. 94

11.6.5 show web .............................................................................................. 95

11.6.6 config web............................................................................................. 95

11.6.7 show snmp ............................................................................................ 95

11.6.8 config snmp........................................................................................... 96

11.6.9 show syslog........................................................................................... 96

11.6.10 config syslog..................................................................................... 97

11.7 Miscellaneous Commands............................................................................ 97

11.7.1 ping ....................................................................................................... 97

11.7.2 traceroute............................................................................................... 97

11.7.3 show arp................................................................................................ 98

11.7.4 show memory........................................................................................ 98

11.8 Examples....................................................................................................... 98

11.8.1 System Commands................................................................................ 98

11.8.2 Network Commands ............................................................................. 99

11.8.3 802.1x Authentication......................................................................... 100

11.8.4 MAC Authentication........................................................................... 100

11.8.5 WLAN with WPA and 802.1x Authentication................................... 101

11.8.6 WLAN with WEP and MAC Authentication ..................................... 101

11.8.7 Bridge Link......................................................................................... 102

Cedar 880AG Enterprise Dual-Radio AP/Bridge

11.8.8 Bridge Link with Multiple VLANs..................................................... 102

Appendix I - Recovery Procedure................................................................................... 104

Cedar 880AG Enterprise Dual-Radio AP/Bridge

1 Introduction

This manual contains information on configuring and managing the Intelicis Enterprise

Dual-Radio Access Point – Cedar 880 product family. It is organized into the following

chapters:

•Introduction: Overview of the wireless network and access point deployment

•Installation: Description of the Cedar 880 hardware

•Initial Configuration: Description of Cedar 880 initial configuration and the

management interfaces

•System: Instructions for changing system parameters

•Network: Instructions for changing network parameters

•Security: Instructions for configuring RADIUS and authentication profiles

•Wireless Network: Instructions for configuring and monitoring wireless network

•Management: Instructions for changing management interface settings

•Log: Description of the log file

•Monitor: Description of how to monitor the system

•Command Line Interface: Description of Command Line Interface (CLI) syntax

1.1 Wireless Network

A wireless network is a flexible data communications system that extends the capability

of the existing wired network to provide connectivity for wireless devices. Unlike the

traditional wired network which relies on physical cables and wires to transmit and

receive data, a wireless network relies on radio frequency (RF) technology to transmit

and receive data.

A Wireless Access Point (AP) is a device that connects wireless communication devices.

It is usually connected to a wired network on one end, and relays data to the wireless

network on the other end.

The advent of the wireless network opens up the possibility of what a network

infrastructure can be. Without the restriction of wires, the network can move with users

and change as fast as the organization does. Figure 1.1 illustrates a sample wireless

network.

Cedar 880AG Enterprise Dual-Radio AP/Bridge

Figure 1.1 Wireless Networks

1.2 Wireless LAN Bridge

Cedar Wireless Access Point provides the capability of being configured as a regular

Access Point, a Wireless LAN Bridge or both. A Wireless LAN Bridge wirelessly

connects two ore more Ethernet LANs together. It is a very practical, easy and in most

cases inexpensive way to connect Ethernet LANs or extend the range of existing

WLANs. As illustrated in Figure 1.2 and 1.3, the access point can operate in point-to-

point or point-to-multipoint bridge topology.

Point-to-point

Point-to-point link allows you to use two access points to bridge two Local Area

Networks from different locations. Access point A serves as a base bridge while Access

point B serves as a non-base bridge. Both access points relay data between the two

Cedar 880AG Enterprise Dual-Radio AP/Bridge

networks. This is an ideal topology for connecting main office with warehouse, or

between office buildings.

Figure 1.2 Point-to-Point Bridge

Point-to-Multipoint

Point-to-Multipoint Bridge allows you to use multiple access points to bridge Local Area

Networks from different locations. Access point A serves as a base bridge while Access

point B and C serve as non-base bridges. This is an ideal topology for central office to

collect data from remote offices.

Figure 1.3 Point-to-Multipoint Bridge Mode

1.3 Access Point Deployment

The deployment of access point depends greatly on the building structure, the existing

wiring and the type of service to be deployed. For example, RF signals transmit much

easier through a wood-frame building than through a concrete one. For newly constructed

Table des matières

Autres manuels Intelicis Point d'accès sans fil

Intelicis

Intelicis Cedar 860AG Manuel utilisateur

Manuels Point d'accès sans fil populaires d'autres marques

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Manuel utilisateur

Ubiquiti

Ubiquiti NanoStation NSM2 Manuel utilisateur

Cisco

Cisco Aironet 1550 Series Manuel utilisateur

Aruba

Aruba IAP-335 Manuel utilisateur

Advantek Networks

Advantek Networks AWN-AP-54MR Manuel utilisateur

IP-COM

IP-COM AP355 Manuel utilisateur

Buffalo

Buffalo AirStation WLA-L11G Manuel utilisateur

EnGenius

EnGenius EnStationACv2 Manuel utilisateur

D-Link

D-Link DAP-3662 Manuel utilisateur

xG Technology

xG Technology xMax CN1300 Manuel utilisateur

Widelink

Widelink ezWave WAP-1100 Series Manuel utilisateur

Edimax

Edimax CAP1200 Manuel utilisateur

Ubiquiti

Ubiquiti LBE-5AC-Gen2 Manuel utilisateur

Aruba

Aruba AP-203R Manuel utilisateur

LuXout Shades

LuXout Shades LUXSHADE MOTION Manuel utilisateur

CreatComm

CreatComm TB5F Manuel utilisateur

SineDigital

SineDigital MW-1500AP(H) Manuel utilisateur

TP-Link

TP-Link AP9650 V1 Manuel utilisateur