THIS MACHINE IS DESIGNED TO BE OPERATED BY ONE OPERATOR ONLY
-
-
3
Congratulations!
Your selection of the Insta Graphic Systems® heat seal
machine is a sound business decision. Insta
Graphic Systems® equipment is the result of the highest
quality engineering and time-tested design. Your
new machine combined with Insta's reputation of
innovation in the heat sealing field, insures the
continuing capability of delivering the best
decorated garments possible.
This manual describes installation, operation, and
maintenance procedures for your new 900 series
machine, as well as easy to use instructions for on
the spot maintenance.
Your 900 series machine will have a long trouble
free life. Read this manual. Keep it with your
machine, it's your key to proper operation and
lasting service.
Installation
DOMESTIC - 900 SERIES
Use a separate 15 amp AC circuit.
Only industrial extension cords with
proper wire size should be used: size
16/3 wire for distances up to 25 feet,
and size 14/3 for distances up to 50
feet.
INTERNATIONAL - 900 SERIES
Use a designated 16 amp AC cir-
cuit. Only industrial extension
cords with proper wire size (2.5 sq.
mm) shall be used.
Limited Machine Warranty
Insta Graphic Systems (IGS) warrants this heat
seal machine, when operated under normal con-
ditions, to be free from manufacturing defects in
material and workmanship for a period of one
year on parts (lifetime on the heating element)
and 90 days on labor.
This warranty will be effective only when IGS
authorizes the original purchaser to return the
product to the factory in Cerritos, California,
freight prepaid, and only when the product upon
examination has proven to be defective.
This warranty does not apply to any machine
that has been subjected to misuse, negligence or
accident.
IGS shall not be liable for the injury, loss or dam-
age, direct or consequential, arising out of the use
or the inability to use the product.
No claim of any kind shall be greater in amount
than the sale price of the product or part to
which claim is made.
This is the sole warranty given by the company, it is
in lieu of any other warranties, expressed or implied,
in law or in fact, including the warranties of
merchantability and fitness for a particular use, and
is accepted as such by the purchaser in taking delivery
of this product.
Operation
1. It is recommended that you review the "How to
Apply Instructions" (in our Product
Information Sheet) before beginning heat
sealing operations.
2. Push ON/OFF switch (on the side of the
machine) to ON position.
3. Press the Power button on the controller.
4. Set desired temperature.
5. Allow the machine to warm up until the
selected temperature is reached.
6. Set the desired pressure by adjusting the air
pressure regulator on the back of the machine.
7. Select the desired timing cycle.
8. Place the substrate on lower platen, smoothing
out all wrinkles.
9. Position transfer or lettering on substrate.
10. Depress both start buttons, one on each side of
the machine, simultaneously (Optional foot
pedal may be used). At this point the machine
operation is fully automatic. The upper platen
moves downward, seals the transfer to the
substrate and then releases automatically at the
end of the selected timing cycle.
NOTE
For safety reasons the buttons (or pedal)
must remain depressed until the upper
platen is in contact with the lower
platen.
