INHAOS LP-2010 Manuel utilisateur
LP-2010
Document No.:DOC-UM-LP2010-V11-EN
Version:V1.1
Release Date:2011-3-29
Switching Amplif ier Measurement Low Pass Filter
User Manual
LP-2010
Switching Amplif ier Measurement Low Pass Filter
Dear Users,
Hello! Thank you for choosing LP-2010 Switching Amplifier Measurement Low Pass
Filter. For using the device correctly, please read this manual carefully , especially the
"Important Safety Tips" section.
If you have read the complete manual, we recommend that you keep this manual with
the device or in accessible place for inspection in the future.
The device is designed referenced to AES17-1998 specification. And it only provides
a low pass filter function similar to AES17-1998 specification. Please NOTE :The accuracy
of measurement is based on the entire system, rather than solely on this device.
Document No. DOC-UM-LP2010-V11-EN
Version V1.1
Release Dtae 2011-3-29
Introduction
Declare
1.Important Safety Tips
2. Packing List
3.Overall Structure
4.Device Schematic
5.Device Connection Diagram
6.Use Method
7.Extended Input Range
8.Technical Parameters (Chart 1)
9.Technical Parameters (Chart 2)
10.Technical Parameters (Chart 3)
11.TechnicalParameters (Chart 4)
12.Technical Parameters(Specifications/Dimension)
13.Warranty / Maintenance Record
14.FAQs
15.Notes
Contents
Thank you for choosing LP-2010 Switching Amplifier Measurement Low Pass Filter. The
device will help you debug and measure switching audio amplifier. Before using, please read this
manual carefully,especially the "Important Safety Tips" section below
1.Please strictly use the power supply attached in the device. Use non-attached power supply
may cause accidental damage or reduce the measurement accuracy.
2.Most switching audio power amplifier adopt bridged output, which means different channel
output can not have a common connection point, nor have any oftheoutput directly
connected to ground, or it may cause the amplifier circuit damage.
3.Rated input range of the device is 10Vp.Please NOTE: the input signal amplitude must not
exceed the rated input range or it may cause measurement error or damage the device. For
a wider range of measurement, please refer to the extended input range chapters.
4.The amplifier's output signal must have rated load resistor before it reaches the device, ormay
cause measurement error.
The device is designed referenced toAES17-1998 specification. And it provides a low pass filter
function similar toAES17-1998 specification .Please NOTE :The accuracy of measurement is based
on the entire system, rather than solely on this device.
Important Safety Tips
Packing List
1.INHAOS LP-2010 Low Pass Filter 1
2.User Manual 1
3.DC 9V 500mA Power Supply 1
4.BNC Tee connector 2
5.BNCto BNC AudioCable 1
6.RCAt oBNC AudioCable 1
7.Speaker Cable 2
CH A Input Positive CH B InputNegative
CH A Input Negative CH B Input Positive
CH B Analog output Power LED
CH A Analog output Power Input Socket
Overall Structure
R1/R2 used toextend the rangeof input signal,if you don't need extended input range,
skip R1/R2 (short R1/R2 ).
Equipment Schematic
Audio Analyzer
Table des matières
