2. Safety instructions
• The encased design of the heating panels meets the protection requirements for IP54, IP65 (protection against water jets) or, upon
special request, also for IP67 (protection against immersion up to 1 m maximum for 30 minutes maximum). If the heating panel in
protection class IP54, IP65 or IP67 is used, the connection to the mains must be made by a specialist installation company in
accordance with the relevant guidelines, directives and standards of your country (wall socket in IP54, IP65 design; for IP67
according to protection class). If the heating panel is connected to the main power supply via a conventional wall socket, the
protection requirements for IP20 apply. A wall socket of the IP20 class is not protected against water and humidity!
Note the statutory electrical protection ranges!
• The heating panel must not be mounted beneath a wall socket.
• Do not place the heating panel close to highly flammable material or anything that easily melts. The minimum distance between other
objects and the heating panel should be 50 cm (front), 2 cm (sides), 2 cm (down) and 10 cm (up).
• Mobile heating panels must not be placed close to a swimming pool, shower, bathtub or other water-filled basins.
• The heating panel must not be exposed to high humidity.
• When mounted on the ceiling, make sure the heating panel is not positioned immediately above seating or sleeping areas.
• Position the heating panel outside the reach of small children.
• The heating panel must never be covered, not even partially.
The space between the heating panel and the wall/ceiling is defined by the mounting bracket.
This space must never be obstructed to ensure full rear ventilation at all times. Otherwise there is a
risk of overheating. (Thermal cut-outs integrated in the heating panel interrupt the power supply in the
case of overheating. The heating panel will be switched on again automatically when it has cooled down.)
• The heating panel must only be connected to alternate current 230 Volt, 50Hz as specified on the rating plate. It must be possible at all
times to switch off the heating panel during operation by means of a thermostat or switch.
• Only the supplied bracket and fittings may be used for mounting the heating panel on solid masonry such as bricks and concrete.
For other wall structures please use appropriate mounting material.
• Do not leave persons with limited physical, sensory or mental abilities unattended in the area of the
heating panel, unless the person in charge of their safety instructed them on how to use the heating
panel, in cases where they are able to understand the instructions. This also applies for children.
• Always return the heating panel to the manufacturer for any repair. Do not carry out repairs yourself!
• Keep children under the age of 3 away from the panel at all time, unless they are constantly
supervised. Children between 3 and 8 years of age may only switch the heating panel on and off when
supervised or if they have been instructed in the safe use of the appliance and have understood the
resulting risks, provided the panel is placed or installed in its standard position of use.
Children between 3 and 8 years of age must not plug the appliance in, control or adjust the appliance,
clean it and/or carry out user maintenance.
• Caution – Some parts of the product may become very hot and cause burns. Special caution is
required when children and vulnerable persons are present.
• If the mains power cable of this appliance has been damaged, have it replaced by the manufacturer or its customer service or by a
similarly qualified person to avoid any risk.
• Do not use this heating system in the immediate vicinity of a bathtub, shower stall or swimming pool.
• CAUTION: This device is not equipped with a room temperature controller. The heater must not be used in small rooms inhabited
by persons who cannot leave the room themselves without help, unless continuous supervision is ensured.
3. Before putting the heater into operation
Read the operating instructions, in particular the safety instructions, before putting the device into operation. Check whether the mains
voltage at your place corresponds to the voltage on the rating plate of the heater.
4. Putting into operation
Mount the heating panel with the help of the enclosed assembly kit and connect it to the mains.
