Portable Patient Monitor Manual
4
CH PTER 1 Introduction
1.1 Profile
This manual explains how to set up and use the patient monitor. Important safety
information relating to general use of the patient monitor is introduced. Other important
safety information is located throughout the text where appropriate. Before using the patient
monitor, the user must carefully read this manual so that the user can operate the patient
monitor properly and make it reach the specific safety standard and function index.
According to custom’s order we have four types of this product: standard type,
standar&CO2, standard &IBP, standard & Inner printer.
1.2 Safety Information
Do not use patient monitor under flammable or anaesthetic condition.
Do not use the patient monitor during Magnetic Resonance Imaging (MRI)
scanning. Induced current could potentially cause burns. The patient monitor may
affect the MRI image, and the MRI unit may affect the accuracy of patient monitor
measurements.
The patient monitor is intended for use only as an adjunct in patient assessment. It
must be used in conjunction with clinical signs and symptoms.
W RNINGS
To avoid electrical hazards, never immerse the unit in any fluid or attempt to clean it with
liquid cleaning agents. Always disconnect monitor from AC Main Power before performing
cleaning of maintenance.
If monitor becomes accidentally wet during use, discontinue operation of the monitor until all
affected components have been cleaned and permitted to dry completely. Contact your
local INFINIUM representative if additional information is required.
When replace the fuse, please with the new one which the type and the rating current are
the same with the used one.
Before use the equipment, inspect whether all the cables are in good condition, the
damaged cables and connectors must be replaced. Operator should examine that whether
the system is in correct working state and operating condition.
If the equipment has not been used for a long time, please remove the batteries.
Keep the fan running when the equipment works in high temperature for long time,
otherwise the high temperature may affect the monitor function or cause the equipment
damage.
Make sure Monitor is in horizontal condition and fixed in case of falling down the road.
As with all medical equipment, carefully route patient cabling to reduce the possibility of
patient entanglement or strangulation.
Do not only depend on the alarm system, the doctor and nurse will not draw attention when
an alarm turn down or turn off.
