ImaginFires IMBF03B Guide de maintenance et de service
SAFETY and OPERATING INSTRUCTIONS
For use with all imaginfires ioethanol fireplaces
For decorative and domestic use only
PLEASE READ FULLY EFORE USING THE FIREPLACE FOR THE FIRST TIME
These Safety and Operating Instructions are part of this ioethanol Fireplace. Please keep in a safe
place for future reference. Any fireplace featuring naked flames or using flammable liquids has a
potential risk of burns or injury. These fireplaces become hot with use, especially the external surfaces.
They are safe when the user exercises common sense and reads this manual. Under no circumstances
should these products be used unless these Safety and Operating instructions have been read first.
Ensure that children, other persons or animals are adequately supervised during the use of this
product.
This ioethanol Fireplace has been tested to European Standard EN 16647:2015 and British Standard
BS 16647:2015 by a recognized independent testing agency. If used in conjunction with this user
manual this Imaginfires ioethanol Fireplace is compliant with these standards.
Please note, you have 14 days from delivery of your fireplace to report any defects or damage.
Contact us at support@imaginfires.com or call us on 01443 203994 if you have any problems.
For the latest safety advice on using our ioethanol Fires and a range of frequently asked questions
please refer to www.imaginfires.co.uk
ARNINGS BEFORE USING YOUR BIOETHANOL FIREPLACE
The following 2 important safety symbols are found on the steel burner box and mean:
*DO NOT FILL HEN ARM OR IN OPERATION*
•Restrict the use of this appliance to persons who read, understand and follow the warnings and
instructions in this manual as well as any markings on the fireplace.
•y purchasing this product, you agree to exercise common sense at all times when operating the
fireplace.
•For decorative and domestic use only.
•Ensure that children, other persons & animals are adequately supervised during the use of this
product.
•Never put petrol inside or near the biofire. This is extremely dangerous.
•Only use in an adequately ventilated rooms with a minimum volume of 45 cubic metres.
•Never leave a lit fire unattended.
•The fireplace is meant for use as a secondary heat source and is not suitable for cooking food or
boiling water.
•Do not use as a multi-burner or open fire.
•Do not use any other liquid or solid combustible materials other than bioethanol fuel.
•Always extinguish the fire fully before going to sleep.
•efore refilling the steel fuel box with the bioethanol fuel, always ensure the fuel box has returned
to room temperature (this takes approximately 30 minutes from extinguishing the fire).
•ioethanol combustion uses oxygen from the air inside the room and releases carbon dioxide (non
toxic) and water vapors. The room should be well ventilated with enough oxygen and fresh air
being supplied (e.g. partly open window/air vents).
•Do not block any existing air vents in the room.
•Do not position the fireplace where any draughts could make the flame in the fireplace behave
erratically.
•This bio fire and stainless steel fuel box should always be placed on a stable, flat horizontal surface
and away from any combustible materials.
•These fireplaces become hot with use, especially external surfaces.
•Always stay at least 1 metre from the bioethanol fireplace when lit.
•Not suitable for continuous operation.
•Keep children and pets a safe distance from the fireplace.
•We recommend that you use a “Fire screen” to keep children and pets away from the fireplace.
•Do not allow your hair or clothes to get near the lit fireplace.
•Do not blow into or fan the fire.
•Do not place paper, cardboard, fabric, clothing or any other flammable materials on or around the
fireplace.
•Do not smoke while lighting or anywhere near the fireplace.
•Do not operate if under the influence of alcohol, drugs or prescribed medication.
•The stainless steel fuel box supplied must be replaced if there are any signs of cracks, corrosion or
misshaping. Please contact us at [email protected] to discuss a replacement.
•Always observe local legislation.
•Do not use near flammable gas.
•Only use parts supplied or approved by the supplier of your bioethanol fireplace.
•Do not put any ornaments or flammable items on top of the fireplace at any time.
•Never cover or obstruct any air slots or ventilation slots.
•If your fireplace includes glass, always have it in place when the fire is lit.
•If your fireplace has a door, ensure that it remains closed during the operation of the fireplace.
•Never stand on a chair or stool etc to pour your bioethanol fuel in the fuel box.
•Never change the construction of the fireplace.
•Take care not to damage, knock or scratch the safety glass. Doing so may impair on its
performance or risk the glass shattering.
•If you need to relocate your fireplace, always ensure it is fully cooled before moving.
POSITIONING
YOUR
BIOETHANOL FIREPLACE
POSITIONING
THE ARKLE AND ANYA
BIOETHANOL FIREPLACE
S
•The ARKLE and ANYA should only be used in an existing fireplace or chimney breast and are not
suitable as freestanding models in a room. The manufacturer cannot be held responsible for any
damages resulting out of incorrect use of the product.
•This section must be read in conjunction with the next section POSITIONING YOUR IOETHANOL
FIREPLACE
•Never position the fire in a location where there is a risk of wind blowing the fire into flammable
items or materials.
•Only install in locations that are protected against cross-aeration/air draughts.
•Please be sure the wall/table/floor you are placing this appliance on can bear its weight.
•Do not use the fireplace near curtains, fabrics, furniture or other flammable materials.
•Ensure that all flammable items are as per the minimum distances below from the fire and ensure
there is a fire extinguisher nearby. The fire extinguisher should be of the alcohol resistant foam, C
powder or Carbon dioxide type. Always read the manufacturers instruction before using the
extinguisher.
Minimum distances to flammable materials are :
Top – 600mm
Side – 450mm
Front – 1000mm
•Do not use the fireplace in caravans, boats, and vehicles or in unventilated rooms.
•Only operate more than one bioethanol fireplace in the same room if the total power output from
all fireplaces is lower than 3kw/h (see PRODUCT SPECIFICATION table at end of these Safety &
Operating instructions)
•Only use parts supplied or approved by the supplier of your bioethanol fireplace.
ASSEMBLING YOUR ALDEN BIOETHANOL FIREPLACE
ASSEMBLING OTHER BIOETHANOL FIREPLACES
This section is ONLY for assembling the ALDEN Bioethanol fireplace. For all other products
please refer to the “ASSEMBLING OTHER BIOETHANOL FIREPLACES” section
Firstly, you will need the backing plate and the base unit as
shown. Remove the fuel box and put aside for later use.
Using the 8 small screws provided, connect the backing plate to
the base unit via the 8 small holes. Note : It is easier if each
screw is only partially tightened at first. Only fully tighten when
all 8 screws are positioned in the 8 holes in the base unit.
Now you can fit the brackets to the wall. See section “FITTING YOUR ALDEN . . . FIREPLACE”
DALTON WHITE (IM F04W)
DALTON LACK (IM F04 )
OSTON WHITE (IM F13W)
OSTON LACK (IM F13 )
O LOSK WHITE (IM F05W)
O LOSK LACK (IM F05 )
GLO US WHITE (IM F11W)
GLO US LACK (IM F11 )
MYLOR (IM F22)
ETON WHITE (W 1W)
ETON LACK (W 1 )
ARKLE (IM F37)
SALCOM E (IM F107)
REDON (IM F40 )
ANYA (IM F38)
STOW WHITE (IM F14W)
STOW LACK (IM F14 )
DORSET (IM F110)
HOWARTH WHITE (IM F106W)
HOWARTH LACK (IM F106 )
PEM REY (IM F103)
MALVERN (IM F67 )
IRKDALE
(IM F100)
CHISWICK (IM F101)
FITTING YOUR ALDEN, ARLINGTON,
BANCROFT, FUEGO,
HENLEY & MARLO
This section is ONLY for fitting the ALDEN, ARLINGTON, BANCROFT, FUEGO, HENLEY and MARLO
Bioethanol fireplaces.
•We recommend two persons are used to fit these fireplaces.
•Please ensure that the wall you are placing this appliance on can bear its weight.
•These instructions are for guidance only as the type of wall and required fixing can vary. Seek
advice from a local builder or DIY merchant if you are unsure.
•Ensure that there are no pipes or cables in the wall that you will be drilling into.
•Please check your fireplace for minor scratches or dents before fitting it to the wall. We can not be
held liable for any scratches or dents once fitted to the wall.
•If you need additional help, please contact us at support@imaginfires.com
ALDEN WHITE (IM F03W) ARLINGTON WHITE (IM F35W)
ALDEN LACK (IM F03 ) ARLINGTON LACK (IM F35 )
ANCROFT (IM F23) FUEGO WHITE (IM F12W)
FUEGO LACK (IM F12 )
HENLEY WHITE (IM F20W) MARLOW WHITE (IM F21W)
HENLEY LACK (IM F20 ) MARLOW LACK (IM F21 )
Hang the 2 brackets indicated by ‘ ’ onto the
bracket ‘A’. Affix to wall by using the screws
supplied. Ensure the brackets are secure.
Affix the bar indicated ‘A’ to the wall
with the screws supplied, ensure that
it is firmly fixed and horizontal.
Align the 2 holes on the rear of the
fireplace indicated by ‘C’ to the 2
hooks on bracket ‘A’
Screw the rear of fireplace with supplied screws
into the 2 protruding ‘feet’ of the brackets.
(Indicated by ‘D’). Check that your fireplace is
now securely affixed and cannot be lifted away
from brackets or wall without undoing screws.
Ce manuel convient aux modèles suivants
37
Table des matières
Autres manuels ImaginFires Cheminée intérieure
