iFan IF9012 Manuel utilisateur
iFAN 3IN1 PORTABLE AIRCON AIR CONDITIONER / FAN / DEHUMIDIFIER
IF9012
Parts & Description s
LIST OF COMPONENTS
1.
Control Panel
4.
Top Cover
2.
Front Housing
5.
Swing Leaf
3.
Omni-directional Wheel
6.
Rear Housing
Control Panel ①
Front Housing ②
360 o Wheels ③
④%%Top Cover
⑤%%Swing Leaf
⑥%%Rear Housing
7.
EVA Filter
11.
Handle
8.
Air Vent
12.
Continuous Drainage Hole
9.
Filter Screen
13.
Power Board
10.
Drainage Hole
14.
Air Inlet Grille
⑪%%Handle
⑫%%Continuous
Drainage Hole
⑬%%Power Board
⑭""Air Inlet Grille
Exhaust Pipe Assembly Window Sealing Plate Assembly
Eva Filter ⑦
Rear Housing ⑥
Air Vent ⑧%
%
%
%
Filter Screen ⑨
Drainage Hole ⑩
Omni-directional Wheel ③
INSTALLATION GUIDE s
1.
INSTALLATION
Warning: before using the portable air conditioner, keep it upright for at least
2 hours. When moving the appliance, ensure that it is kept upright on a
horizontal and dry surface.
1.1
Screw the Exhaust Pipe Assembly (exhaust fitting end) into the exhaust port
on the rear panel (Fig. 1).
Exhaust Pipe Assembly Fig. 1
1.2
Half open the window, and mount the Window Sealing Plate Assembly to
the window in either horizontal (Fig. 2) or vertical (Fig. 3) directions.
To do so, you may have pull various components of the Window Sealing
Plate Assembly open to adjust their opening distance to bring both ends of
the assembly into contact with the window frame
Window Sealing Plate Assembly Fig. 2 Fig. 3
1.3
Place the Main Body with installed Exhaust
Pipe Assembly and fittings before the
window, and the distance between the body
and walls or other objects shall be least 50
cm (Fig.4).
Fig. 4
2
Elongate the Exhaust Pipe. Snap the flat end of the Exhaust Pipe joints into
the hole of the Window Sealing Plate Assembly into place.
The Exhaust Pipe cannot be distorted nor subject to substantial turning
angle (greater than 45 °). Keep the ventilation of the Exhaust Pipe unlocked.
(Fig.5 & Fig.6).
Fig. 5 Fig. 6
Note:
The length of the Exhaust Pipe shall be between 280 ~ 1500 mm, and this
length is based on the specifications of the air conditioner DO NOT use
extension tubes or replace it with other different hoses, or this may cause a
malfunction. Exhaust Pipe must be unblocked; otherwise it may cause
overheating.
HOW TO USEs
LED CONTROL PANEL
REMOTE CONTROL PANEL
⑥④""DOWN / UP""
!
⑦ MODE
!
② FAN"
"
⑤""""""""""""""""""""""""""""""""""%%%%%%%%%%%%%%%%%%
DISPLAY ⑤"""
"
"
"
POWER ⑧%
!
TIMER ①"
!
SWING ⑨"
SLEEP ③%%%%%%%%%%%%
①""""
TIMER
When appliance is ON, press the TIMER key to exit.
When appliance is OFF, press the TIMER key to input.
Press the Timer key ® Symbol flashes ®
Press UP or DOWN key to set Timer
(adjusted UP by one hour or Down by one hour, from 1 – 24 hours)
②
FAN
Press to toggle between
COOL ® DEHUMIDIFY ® FAN modes.
③
SLEEP
In COOL mode only, pressing the FAN and UP keys simultaneously
on the LED Control Panel or SLEEP key on the Remote Control
enters SLEEP function, which turns on Energy saving operation.
Does not work in DEHUMIDIFY or FAN modes.
④
UP
Adjusts the Temperature or Timer settings Upwards.
⑤
DISPLAY
Display window on the LED Control panel.
⑥
DOWN
Adjusts the Temperature or Timer settings Downwards.
⑦
MODE
When in FAN or COOL Mode (see ②), press MODE key to toggle
between HIGH, MIDDLE or LOW wind speed.
When in DEHUMIDIFY Mode, pressing the MODE key does not work
as it is set to the LOW wind speed mode permanently.
⑧
POWER
To turn the appliance ON and OFF.
FULL
The lamp will light and buzzer will sound for several seconds to
indicate that the Water Pan inside the appliance is full on LED
Control panel only.
⑨""
SWING
(on the Remote Control only)
Press the SWING key to swing the Louvre.
SAFETY FUNCTIONS
1.
Frost Protection Function
In COOL, DEHUMIDIFY or SLEEP mode, if the temperature of the exhaust pipe is
too low, the appliance will automatically enter protection status; if the temperature of
the exhaust pipe rises to a certain temperature, it automatically reverts to normal
operation.
2.
Automatic Defrosting
The appliance has Automatic Defrosting function.
3.
Protection Function of the Compressor
To increase the service life of the compressor, it has a 3-minute delay booting
protection function after the compressor is turned off.
4.
Overflow Protection Function
When water in the Water Pan exceeds the warning level, the appliance will
automatically sound an alarm, and the "FULL" indicator light will flash. The appliance
will stop operating. Follow the instructions below.
After the water is emptied, the appliance will automatically return to the original state.
HOW TO DRAIN AND STORE
1.
Manual Drainage
a.
Turn the wall switch OFF and unplug the power cable from the wall socket.
b.
Move the ②"Drainage Pipe connecting the appliance to a toilet or other drainage area
to empty the water. You may have to carefully move the appliance, as well.
c.
Unscrew the ①"Drainage Plug from the Drainage Hole. Water will automatically flow
out of the Water Pan. During drainage, the body of the appliance can be tilted slightly
backwards
d.
Re-attach the ①" Drainage Plug securely. Restart the appliance immediately.
Otherwise, condensate water of the appliance will flow to the floor.
①""Drainage
Plug""""""""""""""""""" """"""""""""""""""""""""""""""""""""""""
Drainage Hole""""""""""""" """"""""""""""""""""""""""""""""""""""""
②""Drainage Pipe!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Table des matières
Autres manuels iFan Climatiseur
