6. 7.
Assembly
Use
1. Insert telescopic rod (2) into the recess on the top of the motor unit (5).
2. Place the hanger (1) onto the telescopic rod (2). When you do this,
make sure that the slight bend in the hanger (1) points forward. The
drip protection (3) must be located directly above the fan (4). It
prevents any water that may drip down from being able to get into
the fan (4).
3. Attach the nylon balloon:
– Pull it over the hanger (1). When you do this, make sure that the side
with the hole line points forward.
– Pull the small elastic cord at the top over the collar section on the
hanger (1).
– Pull the large elastic cord at the bottom over the motor unit.
• Always place the device with clear space above it and on all sides on a
dry, at, solid and heat-resistant surface.
• It is essential that you follow the care labels for the textiles to be dried!
NOTE!
1. Set the height you want. To
do this, open the clip
underneath the hanger and
pull out the telescopic rod
(2) and then close the clip.
3. Pull the garment which is to be pressed over
the nylon balloon and the hanger (1) and
button up the buttons if necessary. Make sure
that
– the collar is tted over the collar section
– the arms of the nylon balloon t properly
in the sleeves of the garment and are not
twisted or scrunched up,
– all buttons on the garment (including on the
sleeves) are button up.
2. The nylon balloon should
wrap around the motor
unit so that it can fully inate
4. Spread the clamps along the bottom of the garment so that it is
evenly weighed down and will not go out of shape when the nylon
balloon is inated.
5. Plug the unit into an electrical outlet.
6. Turn the timer knob (7) clockwise and set it to the length of time you
want. Each LED light represents 5 minutes.
7. Once the nylon balloon has in ated, straighten out the garment
and smooth it down.
8. When the set time is completed, the device switches o
automatically. The drying /pressing process can be interrupted at any
time by turning the timer knob (7) to the starting position.
9. Remove the garment from the nylon balloon and hanger (1).
10. Unplug the unit from the electrical outlet and allow the device to
cool down completely.
