Ice TIPPIN' BLOKS Mode d’emploi

OWNERS AND SERVICE MANUAL

INNOVATIVE CONCEPTS IN ENTERTAINMENT INC.

10123 MAIN STREET, CLARENCE, NY 14031

SERVICE: 1-716-759-0360

FAX: 1-716-759-0884

E-MAIL: [email protected]

WEBSITE: www.icegame.com

TABLE OF CONTENTS

Safety and Warnings 4

Setup

GamePlay 5

GameSetup

VolumeControls

Programming See Insert

Service

Marquee Bulb replacement 7

Lower Illumination replacement 8

Upper Illumination replacement 9

Power Supply Replacement 10

Horizontal Control Replacement 11

Tilt Control Replacement 12

Computer and I/O replacement 13

Upper monitor assembly replacement 14

Assembly Diagrams

Main cabinet components 15 & 16

Wiring Diagrams Seeinsert

Spare Parts 17

Warranty 18

REVISION Alpha 3-9-2010

BEFORE YOU BEGIN

WARNING: WHEN INSTALLING THIS GAME, A GROUNDED A.C. RECEPTACLE MUST BE USED. FAILURE

TO DO SO COULD RESULT IN INJURY TO YOURSELF OR OTHERS. FAILURE TO USE A GROUNDED RE-

CEPTACLE COULD ALSO CAUSE IMPROPER GAME OPERATION, OR DAMAGE TO THE ELECTRONICS.

DO NOT DEFEAT OR REMOVE THE GROUNDING PRONG ON THE POWER CORD FOR THE SAME REA-

SON AS GIVEN ABOVE. USING AN IMPROPERLY GROUNDED GAME COULD VOID YOUR WARRANTY.

HAVE A QUALIFIED ELECTRICIAN CHECK YOUR A.C. RECEPTACLE TO BE SURE THE GROUND IS FUNC-

TIONING PROPERLY. DO NOT WASH YOUR GAME WITH A PRESSURE WASHER.

AVERTISSEMENT: lors de l'installation de ce jeu, la terre AC récipient doit être utilisé. Ne pas le faire pourrait en-

traîner un préjudice à vous ou à d'autres. Le non-recours à la terre récipient pourrait également causer une mau-

vaise opération de jeu, ou les dommages causés à l'électronique. NE PAS détériorer ou de retirer la broche de

terre sur le cordon d'alimentation pour la même raison, comme indiqué ci-dessus. Indûment l'aide d'un jeu de la

terre pourrait annuler votre garantie. Ont un électricien qualifié de vérifier votre récipient AC pour s'assurer que le

sol fonctionne correctement. Ne lavez pas votre jeu avec une laveuse à pression.

INSTALLATION

The game comes ready to play with just a few simple things to keep in mind.

1. Plug the game into the A.C. outlet and turn on power to the game. The switch for the game is located on a

power module on the outside rear of the game.

THIS GAME IS DESIGNED TO DISSIPATE STATIC ELECTRICITY THROUGH THE GROUNDING PLANE OF THE

GAME. IF THE A.C. GROUND DOES NOT WORK, THE GAME COULD DISCHARGE STATIC ELECTRICITY

THROUGH THE GAME CIRCUITRY, WHICH COULD CAUSE DAMAGE.

2. Make sure the game is level after installation. It is necessary to make sure the game is level for safety

concerns.

3. Check that the A.C. voltage rating on the back of the game matches the A.C. voltage of your location.

THE POWER SUPPLY IS NOT VOLTAGE ADJUSTABLE. TO OPERATE THE GAME AT VOLTAGES OTHER THAN

THOSE IT WAS DESIGNED FOR. PLEASE CONTACT OUR SERVICE DEPARTMENT FOR VOLTAGE CONVERSION

INFORMATION.

WARNING

DO NOT remove any of the components on the main board (e.g. compact flash and eproms) while

the game is powered on. This may cause permanent damage to the parts and the main board. Re-

moving any main board component part while powered on will void the warranty.

Ne retirez pas l'un des composants sur la carte principale (par exemple Compact Flash et

EPROMs), tandis que le jeu est sous tension. Cette mai causer des dommages permanents aux

parties et la carte principale. Suppression de tout bord principal élément sous tension alors que an-

nulera la garantie.

NOTE: THIS GAME IS INTENDED FOR INDOOR USE ONLY.

ON THE BACK PANEL OF THE GAME: WARNING: SHOCK HAZARD - DO NOT OPEN. REFER

SERVICING TO SERVICE PERSONNEL.

REMARQUE: CE JEU EST DESTINÉ POUR USAGE À L'INTÉRIEUR SEULEMENT.

SUR LE PANNEAU ARRIÈRE DU JEU: AVERTISSEMENT: RISQUE DE CHOC - NE PAS OU-

VRIR. RÉPARATION À UN PERSONNEL DE SERVICE.

SAFETY AND WARNINGS

SETUP - INTRODUCTION

Game Play:

“Welcome to the Bloks Party!” To win the game, stack nine blocks to get the big bo-

nus. Drop three bloks and the game is over….. In this game the player attempts to

stack nine bloks. As the bloks stack up the player reaches new win zones until the fi-

nal zone is reached. If the player drops three bloks the player wins that zone’s tickets

and the game is over.

Setup:

Your game is shipped with the marquee folded down. Position the marquee back to a

up right position by lifting the marquee from the back. Insert one washer and 1/4-20

bolt to each side of the marquee and tighten all four bolts. See diagram below.

SETUP - ASSEMBLY

METERS LOCATION

The meters are located through the coin door. Both coin and ticket meters can be found there.

CHANGING THE VOLUME LEVELS DURING PLAY

There are UP and DOWN buttons located in the coin door. Pressing of these buttons will either

increase the volume level or decrease the level volume.

ADDING A TEST CREDIT WITHOUT ADVANCING THE COIN METER

Pressing the “TEST” button located in the coin door will add one credit to the game without

advancing the coin meter.

ACCESSING PROGRAMMING

Press the button “DIAG” located in the coin door to enter programming.

PROGRAMMING

To navigate through the menus, press the “UP” and “DOWN” buttons to move up and down in the

menus or to increase or decrease the values of each option. Press the “DIAG” button to select the

desired menu or the option to change.

PROGRAM OPTIONS

See insert for latest program options.

SERVICE

CAUTION

This game uses complex electronic components that are very sensitive to static electricity. Observe precau-

tions below before handling these electronics. Failure to do so may void the warranty and damage electronic

assemblies.

Before servicing electronics, turn off AC power to the game. Wait for capacitors to discharge.

DO NOT remove any of the components on the main board (e.g. compact flash and eproms) while the game is

powered on. This may cause permanent damage to the parts and the main board.

Before touching or handling electronic assemblies, discharge static electricity on your body. To discharge this

static, begin by connecting the line cord to a grounded outlet. Don’t turn on the game. Next, touch the safety

ground stud of the power supply chassis.

Store electronic assemblies in an anti-static area. Use anti-static bags to store or transport the game circuit boards.

Don’t remove or connect electronic assemblies when cabinet power is on. Otherwise, you’ll damage electronic as-

semblies and void the game’s warranty.

After you complete maintenance or service, replace ground wires, shields, safety covers and install and tighten

ground and mounting screw.

MARQUEE BULB REPLACEMENT

Remove the front panel of the marquee by removing the four 1/4-20 bolts. Press the red button on

the socket to release the bulb and remove the retaining clip (BW2017) as shown below. Replace

the bulbs with ICE part number 8312. Be sure to reinstall the bulb clip (BW2017) when replacing the

bulb or the bulb will not stay installed in light socket! Replace the front graphic panel and reinstall

the four 1/4-20 bolts.

SERVICE

LOWER ILLUMINATION REPLACEMENT

Remove the five 1/4-20 bolts that hold the sides of the lower cabinet assembly on. Once removed

you will find two blue CFL 24w bulbs (ICE Part E00272) and one yellow CFL 24w bulb (ICE Part

E00273). The diagram below only shows the left side, repeat the same on the right side to access

the right side bulbs.

SERVICE

UPPER ILLUMINATION REPLACEMENT

LED strips provide the lighting in each of the front BLOKSs and are very reliable. Before replacing

strips, test for 12 volts DC to eliminate wiring or logical board failures. To access these strips you will

need to remove the seven screws that hold the plastic bloks assembly to the front of the cabinet.

There is one on each side of the cabinet. The metal housing is held on by two 8-32 screws. You will

need to gain access to the back of the metal housing to disconnect each LED Strip Assembly.Each

strip assembly is attached to the metal housing by double sided tape. This tape is found on the back

of the new strip assembly and to remove the old assembly, you will need to scrape the strip clean off

the metal. Be careful not to take any of the white paint off the metal work. Be sure to clean the

surface before applying the new strip assembly. There is two strips per blok. The right side is

shown below.

SERVICE

POWER SUPPLY REPLACEMENT

This game has one power supply that provides 24 VDC to the monitor. The game’s I/O board uses

the PC’s built in power supply for power. To access the monitor’s power supply, open the bottom

back panel. Remove the four 1/4-20 bolts shown below to remove the upper back panel. You will

need to disconnect the AC harness that is connected to the cooling fans. The ICE part number for

the 24VDC supply is MON42/47PS.

It is important to check the function of the cooling fans located on the upper back panel. These fans

will push out the heat that will collect at the top of the game. It is recommended to replace noisy or

slow moving fans.

Table des matières

Autres manuels Ice Machine de jeu d'arcade

Ice

Ice MONOPOLY ROLL-N-GO Manuel utilisateur

Ice

Ice MONOPOLY ROLL-N-GO Manuel utilisateur

Ice

Ice TAITO PANIC MUSEUM DELUXE Manuel utilisateur

Ice

Ice Harpoon Lagoon Marquee Manuel utilisateur

Ice

Ice SUPERCHEXX Manuel utilisateur

Ice

Ice EXTREME AIR FX Manuel utilisateur

Ice

Ice Hoopla Manuel utilisateur

Ice

Ice Free Fallin Standart Manuel utilisateur

Ice

Ice SNOWBALL TOSS Manuel utilisateur

Manuels Machine de jeu d'arcade populaires d'autres marques

Universal Space

Universal Space COCONUT BASH Manuel utilisateur

Bay-Tek

Bay-Tek EVOLVE Manuel utilisateur

Global VR

Global VR America's Army Instructions d'installation et d'utilisation

Atronic

Atronic Cashline Manuel utilisateur

Universal Space

Universal Space Checky Monkey Manuel utilisateur

Bay-Tek

Bay-Tek Skee Ball 1908 Alley Manuel utilisateur

Aristocrat Technologies

Aristocrat Technologies Mars X Upright Manuel utilisateur

Family Fun Companies

Family Fun Companies Reactor Guide de démarrage rapide

Universal Space

Universal Space FRUIT MANIA Extreme Manuel utilisateur

falgas

falgas CARRUSEL FIESTA Manuel utilisateur

Konami

Konami DanceDanceRevolution Manuel utilisateur

Bay-Tek

Bay-Tek quik drop Manuel utilisateur

Bandai Namco

Bandai Namco PAC-MAN BATTLE ROYALE CHOMPIONSHIP DELUXE Manuel utilisateur

Adrenaline

Adrenaline Flying Tickets Instructions d'installation et d'utilisation

Swinks

Swinks Stern Pinball Ghostbusters Manuel utilisateur

Innovative Concepts in Entertainment

Innovative Concepts in Entertainment MONOPOLY ROLL-N-GO Manuel utilisateur

jakar

jakar SPEED CARS Manuel utilisateur

Carmelli

Carmelli HAT TRICK NG1015H Manuel utilisateur