9700 SERIES - BASIC OPERATION
Pump 1 Key: Press this key once to turn Pump 1 on. A second press will turn it off. For dual speed pump operation;
Press this key once to turn Pump 1 onto Low speed, press this key a second time to turn Pump 1 onto High speed, a third
press will turn the pump off. A built-in timer will shut the pump off after 20 minutes of operation unless done so manually.
The Pump 1 Icon will appear on the LCD while the pump is running in High speed and flash while it is in Low speed. If the
filter icon appears, a filtration cycle has begun and you will not be able to turn the pump off.
Pump 2 Key: Press this key once to turn Pump 2 on. A second press will turn it off. For dual speed pump operation;
Press this key once to turn Pump 2 onto Low speed, press this key a second time to turn Pump 2 onto High speed, a third
press will turn the pump off. A built-in timer will shut the pump off after 20 minutes of operation unless done so manually.
The Pump 2 Icon will appear while the pump is running in High speed and flash while it is in Low speed.
Air Blower Key: Press this key once to turn blower onto High speed, a second press will turn the blower onto Low
speed and a third press will turn the blower off. A built-in timer will shut the pump off after 20 minutes of operation unless
done so manually. The Accessory Icon will appear while the blower is running in High speed and flash while it is in Low
speed.
Light Key: Press this key to turn the light onto its highest intensity, a second press will turn the light onto low and a
third press will turn it off. The light will automatically shut off after 2 hours. The Light Icon will appear while the light is on.
Temperature Set Keys: Press the Up arrow key to increase the desired temperature. Press the
Down arrow key to decrease the temperature. The temperature can be adjusted in 1F increments from 59F to
104F (5C to 40C). The new setting will remain on the display for 5 seconds as a confirmation. During this time the
Set Point icon will be appear to let you know this is the desired and not the actual temperature. After 5 seconds the display
will return to the current temperature reading. When the temperature drops to 1F below the set temperature, the heater
will be turned on until the temperature is 1F above the set temperature. The heater icon will appear while the heater is on
and flash when there is a call for heat and the heater has not yet been activated.
Programming Parameters: There are several Filtration parameters that may be programmed. Follow these
procedures to set each parameter: Press and hold the Program Key for 5-seconds, the Program icon ( ) will appear.
You may continue to press the Program key to access the desired Filtration parameter to be modified. Once you have
reached the parameter to be modified, press the Enter (Light) key. Use the Up & Down Arrow keys to adjust the value. If
no key has been pressed for 15-seconds the programming mode is exited. During programming all keys other than the
Program, Enter (Light) and Up & Down Arrow keys will be ignored. Refer to the owners manual for specific filtration and
economy programming details.
85-0066-E REV.03 11/11
PUMP 2 ICON
HEATER ON ICON
PUMP 1 ICON
PROGRAM KEY
ECONOMY/NORMAL
MODE KEY
UP/DOWN ARROWS
LCD WINDOWS
FILTERING ICON
TEMPERATURE SET ICON
ECONOMY MODE ICON
LIGHT/ENTER KEY
AIR BLOWER KEY
PUMP 2 KEY
PUMP 1 KEY
PANEL LOCK
AIR BLOWER ICON
PROGRAM MODE ICON
LIGHT ON ICON
2
3
