Hydro systems Maestro Manuel utilisateur
108319 _Macros
Maestro Waste and Overflow installation instructions
Overflow Installation
Loosen 2 screws from
overflow mounting bracket
Install overflow backing
plate on angle on side at
Center overflow backing
plate with overflow
2
a time mounting bracket
Using Phillips head
screw driver tighten
screws evenly
Insure that center holes
align. Place small
amount of silicone to
overflow face plate stud
crew in overflow cover
leaving approx. 3/16 gap
from tub wall to
overflow plate
Drain Installation
Install to bath, Insure that
holes on drain are not
Apply Plumbers putty or
silicone to the bottom side
3
holes on drain are not
obstructed
silicone to the bottom side
of the flange on strainer
While holding pressure
inside tube, install rubber
gasket over brass threads
Continue holding pressure
inside tube while threading
on A.B. . Direct drive shoe
hand tighten ¼ turn past
hand tight
Autres manuels Hydro systems Produits de plomberie
