HYBRID POWER BATT PACK Manuel utilisateur
1Batt Pack Pro - User manual - English
BATT PACK User Manual
Manufactured by:
hybridps.ca
288 Judson St #5
ON M8Z 5T6
2 Batt Pack Pro - User manual - English
SHOCK HAZARD:
Possible shock or death if used improperly,
when damaged or used by untrained
personnel.
FLAMMABLE HAZARD:
Lithium ion batteries contain flammable
liquid electrolyte that may vent, ignite and
produce sparks when subjected to high
temperatures (> 150 °C (302 °F)), when
damaged or abused (e.g., mechanical
damage or electrical overcharge). Burning
cells can ignite other batteries in close
proximity.
Vapors or mists from a ruptured battery
may cause respiratory irritation.
4Batt Pack - User manual - English
Manual
INDEX
CONTENT PAGE
Introduction 06
Safety Information 08
Configuration 11
Operation 22
Solar Panel Purchasing + Wiring Guide 27
Hardwire Instructions for Backup Power 33
Troubleshoot 35
Multipurpose DC Input Manual 37
Warranty 42
6Batt Pack - User manual - English
INTRODUCTION
Section 1
7Batt Pack - User manual - English
1.1. Product Description
Thank you for choosing this portable power supply from Hybrid Power Solutions (HPS).
We hope you enjoy and use the Batt Pack to its full potential.
Please unpack your Batt Pack carefully and check the delivery for completeness and
obvious damage. In case of damage inform us immediately.
The Batt Pack is delivered to you in a ready to use state with 30% energy (+/-5%).
However, please make sure you read through this user manual carefully. If you have
further questions regarding the Batt Pack, please contact HPS.
1.2. Contact Details
Hybrid Power Solutions Inc.
Customer Service/ Technical Support
288 Judson St Unit #5, Toronto, ON M8Z 5T6
Canada
Phone: +1 (647) 347-6000
Website: hybridps.ca
SAFETY
INFORMATION
Section 2
9Batt Pack - User manual - English
2.1. General Safety Instructions
Before operating the Batt Pack, carefully read and fully understand the instructions
including all the cautions and safety notices shown on the second page of this
manual. Following all instructions for proper operation and troubleshooting will
reduce the risk of personal injury, death and/or property damage.
These instructions are not intended as a complete list of all details for operating and
troubleshooting, although reading and following them will aim to keep you safe. If you
have any questions or concerns about procedures or safety that are not covered by
these instructions, do not hesitate to contact HPS.
2.2. Operator Responsibility
Treat the Batt Pack system with general care, by closing the output plugs and input
plugs and turning the system off when not in use.
If an unfamiliar sound or smell is noted to come from the unit, please turn off the unit
and notify HPS immediately. Leave in a well-ventilated area, away from flammable
sources.
WARNING: Do not put fingers and/or any other object into the units plugs.
Never open the unit case.
Do not expose to temperatures outside the range of -30°C to 50°C.
To minimize any adverse effects on battery performance it is recommended that the
system be kept at room temperature (25°C +/- 5°C). Low or elevated temperatures
can result in shortened cell life.
Keep out of reach of children.
GFCI WARNING: Although the Batt Pack does have circuit interruption built into
the design, we highly recommend the use of a GFCI adapter in certain situations.
This adapter can be supplied by HPS or other reputable suppliers. We do not include
a GFCI as the Batt Pack may be used in various scenarios that either do, or do not
require this device. The following is a general outline from the National Electrical Code
(NEC). Please review the entire NEC documentation pertaining to this matter to help
with your decision-making process.
10 Batt Pack - User manual - English
Commercial GFCI Requirements (NEC 2014 Excerpt)
• All 125-volt, single-phase, 15- and 20-ampere receptacles installed in bathrooms,
kitchens, rooftops and outdoors, 6’ from a sink, indoor wet locations, locker rooms,
garages, service bays, and similar areas.
• All vending machines.
• All pool motors, spas, and pumps.
• All electric drinking fountains.
• Exceptions:
• In industrial laboratories, receptacles used to supply equipment where removal
of power would introduce a greater hazard shall be permitted to be installed
without GFCI protection.
• For receptacles located in patient bed locations of general care or critical care
areas of health care facilities other than those covered under 210.8( B)( 1), GFCI
protection shall not be required.
• Receptacles that are not readily accessible and are supplied by a branch circuit
dedicated to electric snow-melting, deicing, or pipeline and vessel heating
equipment shall be permitted to be installed in accordance with 426.28 or
427.22, as applicable.
• In industrial establishments only, where the conditions of maintenance and
supervision ensure that only qualified personnel are involved, an assured
equipment grounding conductor program as specified in 590.6( B)( 2) shall
be permitted for only those receptacle outlets used to supply equipment that
would create a greater hazard if power is interrupted or having a design that is
not compatible with GFCI protection.
2.3. Condition of Use
If system is in abnormal physical condition, do not use.
Critical Errors
If power button is pushed ON and the unit does not turn ON, please plug in to grid
power and allow to recharge for a minimum of 10h. If the unit does not turn ON, please
contact HPS technical support for further assistance.
If internal components are heard/ believed to be loose inside/ rattling, please call HPS
technical support.
Ce manuel convient aux modèles suivants
2
Manuels Bloc de piles populaires d'autres marques
IOGear
IOGear GBP24V Series Manuel utilisateur
Inventus Power
Inventus Power PROTRXion S-12V100-TRX-HD Manuel utilisateur
Clas Ohlson
Clas Ohlson PW-290A Manuel utilisateur
EINHELL
EINHELL MULTI-Ah Power X-Change Plus Manuel utilisateur
Samsung
Samsung EB-U3300 Manuel utilisateur
ECTIVE
ECTIVE LC Series Manuel utilisateur