The leader in hunting communication ™
Hunter Electronic AB Phone: +46 8 184000
Vågögatan 8 E-mail: info@hunterelectronic.se
164 40 Kista / Stockholm Home page: www.hunterelectronic.se
SWEDEN Page 3 of 4 Webshop: www.huntercom.se
Start scanning:
1. Press FUNC 1 second, [SCAN is displayed].
2. Press ENTER for starting scanning function.
Stop scanning:
Press CLR.
Adding/Deleting a channel from the Scanning list:
1. Select operating channel with the rotary selector.
2. Press FUNC 1 second then turn the rotary selector clockwise one step, [SCAN L is displayed].
3. Press ENTER for displaying the channels current setting.
4. Turn the rotary selector and select ON for adding or OFF for removing the channel from the list.
5. Press ENTER for saving the selected list setting, [selected setting and ois displayed].
6. Press CLR once for returning to Function Mode, twice for returning to start position.
Change Output Power on selected channel:
1. Select operating channel with the rotary selector.
2. Press FUNC 1 second then turn the rotary selector clockwise two steps, [POW is displayed].
3. Press ENTER for displaying the channels current setting.
4. Turn the rotary selector and select HI for high or LO for low output power.
5. Press ENTER for saving the selected power setting, [selected setting and ois displayed].
6. Press CLR once for returning to Function Mode, twice for returning to start position.
Change radio Squelch level:
1. Press FUNC 1 second then turn the rotary selector clockwise three steps, [SQ L is displayed].
2. Press ENTER for displaying the current radio setting.
3. Turn the rotary selector and select new level from L 1 to L 9.
5. Press ENTER for saving the selected level, [selected level and ois displayed].
6. Press CLR once for returning to Function Mode, twice for returning to start position.
Note!
If selecting L 0, squelch will be constantly open and the Squelch key operation (6) will be disabled.
Enable/Disable radio Beep tone function:
1. Press FUNC 1 second then turn the rotary selector clockwise four steps, [BEEP is displayed].
2. Press ENTER for displaying the current radio setting.
3. Turn the rotary selector and select ON for enabling or OFF for disabling the beep tone.
4. Press ENTER for saving the selected beep tone setting, [selected setting and ois displayed].
5. Press CLR once for returning to Function Mode, twice for returning to start position.
