Humanscale CPU600 Manuel utilisateur
CPU600
Installation
Instructions
Step 3:
Slide Quick Track Cover into Track.
Step 4:
Use Thumb Screws to secure Quick Track Cover to Track. Your
Quick Track system is now installed.
Removal:
To remove CPU600 from the Track, loosen Thumb Screws,
remove Quick Track Cover, and slide unit off the Track.
Track
Quick Track
Cover
Thumb Screws
CPU600 Track Installation
HSI-CPU600-207
Step 1:
Loosen Width Knob and slide Side
Bracket outward. Loosen Height Lock and
slide Upper Assembly to highest position.
Center CPU on the Base.
Step 2:
Lower Upper Assembly until it lightly touches
top of CPU. Tighten Height Lock. Push Side
Bracket inward until it fits tightly against
CPU. Center Mounting Rails above CPU.
Tighten Width Knob.
CPU600 Installation Instructions
Side Bracket
Base
Width Knob
Height Lock
Mounting Rails
Upper Assembly
Height Lock
Width Knob
5/8" Long
Tapping Screws
Track
Mounting Tape
1/4” back
from desk edge
Tabs
Step 1:
Position track approximately 1/4” from edge of desk
with folded tabs facing away from desk edge. Using
Mounting Tape, affix Track to underside of desk.
Attach Track to desk using Tapping Screws.
CPU Installation Track Installation
Track Installation, continued on back
Step 2:
Align Mounting Rails of the CPU600 with front edge of
Track and slide unit into Track.
Table des matières
Autres manuels Humanscale Accessoires informatiques
