HRT UV1-S-16X Manuel utilisateur
UV-16X Family of Mini-Cat Senders for Transmission
of 16 Independent PC or HD Video Plus Audio or
RS232 or Power on Twisted Pair Cable
(Cat5/5e/6 or Zero-Skew UTP)
MODEL U
UV
V1
1-
-S
S-
-1
16
6X
XUTP VGA/POWER 16-PORT SENDER
MODEL U
UV
VA
A-
-1
16
6X
XUTP VGA/AUDIO 16-PORT SENDER
MODEL U
UV
V2
23
32
2-
-1
16
6X
XUTP VGA/RS232 16-PORT SENDER
H
Ha
al
ll
l
R
Re
es
se
ea
ar
rc
ch
h
T
Te
ec
ch
hn
no
ol
lo
og
gi
ie
es
s,
,
I
In
nc
c.
.
Order toll-free in the U.S. 800-959-6439
FREE technical support, Call 714-641-6607 or fax 714-641-6698
Mail order: Hall Research Technologies, 1163 Warner Ave, Tustin, CA 92780
Web site: www.hallresearch.com • E-mail: info@ hallresearch.com
CUSTOMER
SUPPORT
INFORMATION
UMA1135, Rev 2
UV-16 Family of Mini-Cat®Senders
1
TRADEMARKS USED IN THIS MANUAL
Hall Research, HRT, and (logo) are trademarks of Hall
Research Technologies, Inc. Any other trademarks mentioned in this
manual are acknowledged to be the property of the trademark owners.
FCC & CANADIAN DEPARTMENT OF COMMUNICATIONS
RADIO FREQUENCY INTERFERENCE STATEMENTS
This equipment generates, uses, and can radiate radio frequency energy
and if not installed and used properly, that is, in strict accordance with
the manufacturer’s instructions, may cause interference to radio
communication. It has been designed and found to comply with the
limits for a Class A computing device in accordance with the
specifications in Subpart B of Part 15 of FCC rules, which are intended
to provide reasonable protection against such interference when the
equipment is operated in a commercial environment. Operation of this
equipment in a residential area is likely to cause interference, in which
case the user at their ownexpense will be required to take whatever
measures may be necessary to correct the interference.
This digital apparatus does not exceed the Class A limits for radio
noise emission from digital apparatus set out in the Radio Interference
Regulation of the Canadian Department of Communications.
Le présent appareil numérique n’émet pas de bruits radioélectriques
dépassant les limites applicables aux appareils numériques de la classe
A prescrites dans le Règlement sur le brouillage radioélectrique publié
par le ministère des Communications du Canada
EUROPEAN UNION DECLARATION OF CONFORMITY
This product has been tested and shown to comply with the
requirements of the European EMC directive 89/336/EEC
Compact CAT5 Audio/Video Splitters and Receiver
2
Contents
1. Introduction ....................................................................................... 3
1.1 General......................................................................................... 3
1.2 Features........................................................................................ 4
2. Installation ......................................................................................... 5
3. Configuration & Operation................................................................ 7
3.1 Sender .......................................................................................... 7
3.2 Receivers ..................................................................................... 7
3.2.1 Adjusting the video quality for long cable runs........................ 8
3.2.2 UTP Cable Recommendations.................................................. 9
4. Troubleshooting............................................................................... 10
4.1 Problem Solving FAQ ......................................................... 10
4.2 Calling Hall Research Technologies.................................... 11
4.3 Shipping and Packaging ...................................................... 11
5. Specifications................................................................................... 12
UV-16 Family of Mini-Cat®Senders
3
1. Introduction
1.1 General
This User’s Manual covers several models of Mini-Cat®Senders. The
senders can be any of the following models: UV1-S-16X, UVA-16X or
UV232-16X. For these units, the number after the dash represents the
quantity of RJ45 outputs.
The transmission system is comprised of one Rack-Mount Sender unit
and one or more Receiver units (Sold Separately). There are 3
variations of the basic sender which can transmit Video along with
either Phantom Power (UV1-S-16X), Video along with Line-Level
Audio (UVA-16X) or Video along with unidirectional (TX Only)
RS232 (UV232-16X).
The senders convert the video inputs and either power, audio or RS232
signals into a format that can be transmitted using a single inexpensive
and commonly available Unshielded Twisted Pair (UTP) cable with
RJ45 connectors. Both UTP and STP (shielded) cables can be used. In
addition you can use Cat5, 5e, 6, or higher. However, for runs of over
250 feet, HRT recommends using “Skew-free” or “Zero-skew” Cat5
cables for best performance.
At the receiving (remote) end, a compatible receiver (sold separately)
is used to convert the UTP signal back to VGA and either power, audio
or RS232.
The product is housed in a 2 RU, 19” Rack mount enclosure and has
connectors for up to 16 video inputs and either Audio or RS232
depending on the model, as well as multiple RJ45 output connectors
for connection to the remote systems.
The RJ45 outputs on the Sender can drive CAT5 LAN cables to 1000
feet (305 meters) with little to no degradation of video quality (500 feet
on some models) depending on resolution of the VGA signal (see table
3.2). The receiver can compensate for video signal losses in long cable
runs.
Compact CAT5 Audio/Video Splitters and Receiver
4
1.2 Features
•Distribute 16 Video Sources in one easy to use rack mount
unit to remote locations
•Supports resolutions up to 1920x1440 at 60Hz, and HD
resolutions up to 1080p
•Amplifies the signal for clean and crisp transmission using
HRT’s proven technology
•Drives standard CAT5 cables up to 1000 feet (500 feet on
some models)
•Transmit video and either Power, Audio or RS232 signals on
one cable
•Built-In Universal Power Supply
•Model UV1-S-16X provides Phantom Power for Receivers up
to 500 feet away so the receivers don’t need a power
connection
•2RU, 19” Rack Mount Enclosure
•Perfect for Matrix Racks and Digital Signage
UV-16 Family of Mini-Cat®Senders
5
2. Installation
1. Connect the video source to the PC/HDTV connectors. For Model
UVA-16X, connect the audio source to the AUDIO connectors.
For Model UV232-16X, connect the RS232 source to the audio
connectors using the supplied DB9 to 3.5 mm Cables.
2. Connect the included power cord to the power input connector on
the unit.
3. Using Category-5 or higher UTP cable, connect one or more
compatible receivers to the sender’s RJ45 outputs.
4. Connect the remote display/projector and possibly speakers or
RS232 to the receiver unit.
If using the Model UV1-S-16X, the receivers can be powered from
the CAT5 cabling if desired and the cables are less than 500 feet
from the sending unit.
CAUTION
Before plugging in the remote monitor, verify that the AC line is properly
wired and that a protective ground (green) wire is established with NO
potential difference between both the sender and receiver locations. The
splitter can tolerate up to 5 v peak-to-peak ground potential between the
two locations. Failure to ensure good grounding can result in erratic
operation and possible shock hazards or damage to your equipment.
Compact CAT5 Audio/Video Splitters and Receiver
6
NOTICE
Do not connect this unit to any LAN device such as network cards or hubs
as this may damage the UVA/URA and/or the LAN device. Use EIA/TIA 568B
standard straight-through patch wiring as shown below. Do not use
crossover cables.
EIA/TIA 568B WIRING STANDARD
PIN Wire Color
1 White w/ Orange Stripe
2 Orange
3 White w/Green Stripe
4 Blue
5 White w/Blue Stripe
6 Green
7 White w/Brown Stripe
8 Brown
UV-16 Family of Mini-Cat®Senders
7
3. Configuration & Operation
3.1 Sender
At the sending end the video signal from the source is fully terminated.
On the UVA-16X, the transmitted audio in the CAT5 cable to the
remote receiver is monaural. The audio output on the receiver is “line-
level” (powered speakers are required).
3.2 Receivers
Several receiver types are available that are compatible with this family
of products (See table for compatible receivers). All Receivers have a
single COMPENSATION potentiometer (pot) adjustment to recover
high frequency signal loss for long runs of the cable.
Model # Compatible Receivers
UV1-S-16X *
UV1-R
UV1-R-WP (Wall Plate)
UVB1-CP-R
UVA-16X URA
URA-X2
UV232-16X UR232
UR232-X2
* IMPORTANT
The UV1-S-16X sends 9 vDC via the CAT5 cable and is only
compatible with the UV1-R, UV1-R-WP and UVB1-CP-R.
Other types of receivers (Such as a URA) can sustain damage if
connected to the UV1-S-16X
Compact CAT5 Audio/Video Splitters and Receiver
8
3.2.1 Adjusting the video quality for long cable runs
The video quality at the remote station depends on: (1) the length of the
CAT5 cable, (2) video resolution setting, (3) refresh rate setting and the
model of the receiver.
In general, at low and mid resolutions, excellent image reproduction is
provided at up to 1000 feet for UVA-16X and UV232-16X models
(500 feet for model UV1-S-16X). At high resolution and refresh rates
perfect image reproduction can be achieved at shorter distances (see
table below). Using longer cables or higher resolution rates will still
produce an image, but the reproduction quality will be reduced.
Refresh Rate
60 Hz 75 Hz 85 Hz
800x600 1000 ft 1000 ft 1000 ft
1024x768 1000 ft 800 ft 750 ft
1280x1024 750 ft 650 ft 600 ft
Resolution
1600x1200 650 ft 600 ft 500 ft
Refresh Rate
60 Hz 75 Hz 85 Hz
800x600 500 ft 500 ft 500 ft
1024x768 500 ft 450 ft 400 ft
1280x1024 400 ft 350 ft 300 ft
Resolution
1600x1200 300 ft 300 ft 300 ft
Maximum
Recommended
Cable Lengths
For URA &
UR-232
Receivers
Maximum
Recommended
Cable Lengths
For UV1 &
UVB1
Receivers
Table 3.2
Ce manuel convient aux modèles suivants
2
Table des matières
Autres manuels HRT Extenseur
