HP D7171A - NetServer - LPr Manuel utilisateur

Microsoft Cluster Installation

Documentation

To assist you in installing your HP NetServer Microsoft Cluster, this file contains three

separate documents combined into one pdf file.

•Configuration Guide - This guide provides configuration information specific to your

cluster configuration that you will need during the installation of your cluster.

•HP NetServer Microsoft Cluster Installation Guide - Use this document to install

the cluster.

18 November 1998

(See next page)

Version History

18 November 1998 Revised the Configuration Guide to add, “6 maximum per NetRAID adapter” to

Logical Disks in Shared Storage.

15 September 1998 Revised the Configuration Guide to add, “Logical Disks – 1 per RAID array” to

Shared Storage.

10 June 1998 Package released

HP NetServer LH Pro

with

NetRAID (HP Storage System/6)

Cluster Configuration Guide

17 November 1998

Introduction

This document defines the supported HP NetServer LH Pro configurations for Microsoft Cluster Server.

These configurations minimize single points of failure, provide maximum availability, and have been

certified by Hewlett-Packard and Microsoft. This guide is prescriptive; it describes the HP NetServer LH

Pro configurations supported by HP. Any configuration not expressly allowed by this guide will not be

supported by HP.

What’s Defined

•Cluster

•SPUs

•Local and Shared Storage

•Intra-cluster and Client LANs

Cluster

Type of SPUs HP NetServer LH Pro 6/200 Model 1

Each node must be the same model SPU, but may have different size main

memory and cache.

Number of nodes 2

Shared Storage HP Storage System/6 with HP NetRAID controller and HP disks. See

Shared Storage below.

LANs:

Client LAN Any NIC that is HP and Microsoft approved. See Client LAN below.

Intra-cluster

(Heartbeat) LAN HP D5013A or J3171A only with crossover cable. See Intra-cluster LAN

below.

Power source Direct from power mains, power conditioner or uninterruptable power

supply (UPS) using any power conditioner or UPS.

System software:

Navigator version G.00.80 or later

Operating System Microsoft Windows NT Server 4.0, Enterprise Edition or later.

Service pack SP3 and hotfix "clusfixi", or later. The hotfix is not required but is

recommended for clusters using 9.1GB and higher capacity drives.

SPU

Model HP NetServer LH Pro 6/200 Model 1

Clock speed 200 MHz

No. of CPUs 2 (at least two are required)

BIOS version 4.05.14 PF or later

CPU cache Any size

RAM 128 MB minimum. Must be HP.

No. of power supplies 2

Hot swap cages May use for local storage; but not use for shared storage.

Local storage Internal or external, using any controller. Must use HP disks. See

Local

Storage below.

I/O slots: P9 - Shared storage controller (P8 if using NetRAID for local storage.)

P7 - Intra-cluster (Heartbeat) LAN

P6 - Client LAN

All others - Any other plug-in cards.

Storage

Local

Physical drive location SPU internal drive bays, or HP external drive cabinet (e.g., HP Storage

System/6), or any combination.

Disk drives Must be HP

Cables Must be HP and < 3 m total length for external drive cabinet.

Controller SPU embedded controller or any controller (any number, manufacturer or

driver) in any available I/O slot. Use P9 for NetRAID local storage. See

SPU I/O slots above.

Shared

Controller

Model HP NetRAID D4943A

Use with HP Storage System/6 and HP Cluster Adapter only.

No. of controllers 1 maximum

Firmware S.01.00

Driver 2.03

NetRAID Assistant A.01.09

SPU I/O slot P9 (P8 if using NetRAID for local storage.)

SCSI ID 6, 7

Channels 0 and 1 only

Do not use channel 2 for any purpose.

RAID level 1, 5, 10, and 50 only

Logical disks 1 per RAID array

6 maximum per NetRAID adapter

Configuration

options: Cluster mode on (cache write-through, no hot spare)

Ultra SCSI disabled

Termination: wide channel or automatic

Set any other options as you prefer

Cabinet

Model HP Storage System/6 D3604B

No. of cabinets 1, 2

A cluster with a single storage cabinet has only one SCSI bus connected to

HP NetRAID channel 0. A cluster with 2 storage cabinets must have one

cabinet connected to NetRAID channel 0 and the other cabinet connected to

NetRAID channel 1.

SCSI IDs Any SCSI IDs except 6 or 7

SPU hot swap cages May not be used for shared storage.

Disk drives: HP 2.1 GB Hot-Swap Ultra SCSI Disk Module D3582B or D3582C

HP 4.2 GB Hot-Swap Ultra SCSI Disk Module D3583C

HP 4.2 GB 10K rpm Hot-Swap Ultra SCSI Disk Module D4903A

HP 9.1 GB Hot-Swap Ultra SCSI Disk Module D4289A

HP 9.1 GB 10K rpm Hot-Swap Ultra SCSI Disk Module D6019A

HP 18.2 GB Hot-Swap Ultra SCSI Disk Module D5039A

Cables HP Cluster Adapter D5957A

RAID arrays A RAID array (logical disk) must be composed of all the same disk model.

Different size or speed disks are not allowed in the same RAID array. Any

combination of disk models is allowed on a SCSI channel. Any

combination of disk models is allowed in a cluster.

LANs

Intra-cluster (Heartbeat) LAN Client LAN

LAN connection HP D5954A crossover cable or any

equivalent only Any LAN

The intra-cluster LAN may only be

used for cluster node communication

via a crossover cable. It may not be

used for client communication.

NIC:

Model HP D5013A (10/100TX PCI)

(or HP J3171A )

Any that is on both the HP

Tested Products List and the

Microsoft Hardware

Compatibility List.

Driver 2.24.00.0000 or later Any driver

SPU I\O slot P7 P6

This page intentionally left blank.

HP NetServer LH Pro Microsoft Cluster

Installation Guide

1 October 1997

HP NetServer LH Pro Microsoft Cluster Installation Guide - 1 October 1997 ii

Notice

The information contained in this document is subject to change without notice.

Hewlett-Packard makes no warranty of any kind with regard to this material, including, but not limited to, the implied

warranties of merchantability and fitness for a particular purpose. Hewlett-Packard shall not be liable for errors

contained herein or for incidental or consequential damages in connection with the furnishing, performance, or use of this

material. Hewlett-Packard assumes no responsibility for the use or reliability of its software on equipment that is not

furnished by Hewlett-Packard.

This document contains proprietary information that is protected by copyright. All rights are reserved. No part of this

document may be photocopied, reproduced, or translated to another language without the prior written consent of

Hewlett-Packard Company.

The use of trademarks or other designations is for reference purposes only. The following trademarks are used in this

manual:

Microsoft and MS-DOS are U.S. registered trademarks of Microsoft Corp. Windows and Windows NT are trademarks of

Microsoft Corp

Network Server Division

5301 Stevens Creek Boulevard

P.O. Box 58059

Santa Clara, CA 95052-8059, USA

HP NetServer LH Pro Microsoft Cluster Installation Guide - 1 October 1997 iii

Table of Contents

Overview of an HP NetServer LH Pro Cluster Installation...............................................1

Part 1: Installing Additional Hardware Components........................................................5

Part 2: Setting Up the HP Storage System/6 ..................................................................9

Part 3: Configuring the HP NetRAID Adapter................................................................12

Part 4: Installing Microsoft Windows NT and Configuring the LAN Adapters................14

Part 5: Installing HP NetRAID Software and Configuring the Disk Arrays.....................16

Part 6: Installing and Testing Microsoft Cluster Server Software ..................................25

APPENDIX A Obtaining HP NetRAID Utilities..............................................................33

APPENDIX B Updating HP NetRAID Firmware ...........................................................34

APPENDIX C RAID Array Configuration......................................................................35

HP NetServer LH Pro Microsoft Cluster Installation Guide - 1 October 1997 1

Overview of an HP NetServer LH Pro Cluster

Installation

NOTE

Hewlett-Packard does not support nor recommend the installation of clustered HP NetServer systems using

Microsoft Cluster Server software unless installed by an HP Cluster Certified Installer.

An HP NetServer LH Pro cluster provides a reliable low-cost, increased-availability solution for critical

applications. The basic cluster consists of two HP NetServer LH Pro systems coupled to one (or two) HP Storage

System/6 using HP NetRAID adapters. Both HP NetServers run Microsoft Windows NT Server, Enterprise Edition,

which includes Microsoft Cluster Server software.

The operating system files, application files, and any other files local to one system are stored on a hot swap disk on

each system. Both the LH Pro cluster "nodes," referred to throughout this document as System A and System B (see

the following illustration), share the drives located in the HP Storage System/6. The two HP NetServers share the

drives using an HP NetRAID adapter housed in each system.

Base Configuration for an HP NetServer LH Pro Cluster

Required Hardware and Software

In addition to the required hardware and software components listed below, you will, during the course of cluster

installation, be required to supply the following:

•Minimum of three IP addresses, one for each System (A and B), and one for the HP NetServer cluster

•Cluster and node names (limited to 15 or less alphanumeric characters)

•Subnet mask

•MS domain account name and password

Autres manuels pour D7171A - NetServer - LPr

117

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels HP Serveur

HP T5125 - Compaq Thin Client Manuel d'utilisation et d'entretien

HP BL480c - ProLiant - 4 GB RAM Manuel utilisateur

HP ProLiant BL20p Instructions d'utilisation

HP Integrity rx1620 Guide de démarrage rapide

HP ProLiant SL335s G7 Instructions de montage

HP Moonshot 1500 Manuel

HP LC2000r - NetServer - 128 MB RAM Manuel utilisateur

HP ProLiant ML310e Generation 8 (Gen8) Instructions d'utilisation

HP 3000 99x Family Manuel utilisateur

HP ProLiant 8500 Manuel utilisateur

HP Integrity Superdome SX1000 Manuel utilisateur

HP Integrity Superdome 2 16-socket Manuel utilisateur

HP ProLiant DL385p Gen8 Manuel utilisateur

HP ProLiant series Manuel utilisateur

HP ProLiant ML110 Gen9 Manuel

HP ProLiant DL160 Gen9 Manuel

HP BL685c - ProLiant - 4 GB RAM Manuel utilisateur

HP Elite t655 Instructions de montage

HP ProLiant DL20 Gen10 Plus Manuel

HP T5135 - Compaq Thin Client Instructions d'utilisation

HP StoreOnce 4900 Backup Guide d'installation et d'utilisation

HP PROLIANT DL160 G5 Instructions d'utilisation

HP P4535A - Web Cache Server Appliance Manuel utilisateur

HP ProLiant ML100 Series Manuel utilisateur

Manuels Serveur populaires d'autres marques

Dell

Dell PowerEdge R410 Manuel utilisateur

PowerNAS

PowerNAS CMA Manuel utilisateur

Supero

Supero FatTwin F617R3-FT Manuel utilisateur

MSI

MSI P1-109N-L70 Manuel utilisateur

Dell

Dell PowerEdge XE9640 Manuel

Dell

Dell PS4100 Instructions de montage

EtroVISION

EtroVISION EV3151 Manuel utilisateur

NEC

NEC Express5800/T110j Manuel utilisateur

Compaq

Compaq ProLiant 3000 Manuel

Dell

Dell PowerEdge 3YPMN Manuel utilisateur

iRobo

iRobo IPC2U Manuel utilisateur

Nortel

Nortel 1000 Con?guration guide Manuel utilisateur

Asus

Asus AP7500 Manuel d'utilisation et d'entretien

Avid Technology

Avid Technology AirSpeed 5000 Manuel utilisateur

Milestone

Milestone Husky IVO 350T Manuel utilisateur

Planet

Planet NAS-7410 Manuel utilisateur

Lenovo

Lenovo ThinkSystem SR635 V3 Manuel utilisateur

Dell

Dell PowerEdge HS5610 Manuel