HP D Series Manuel d'installation et d'exploitation

System Memory Upgrade Guide

D Class and R Class

HP 9000 Enterprise Servers

Part No. A3262-90003

Edition 6

October 1998

E1098

Printed in: USA

Legal Notices

The information in this document is subject to change without notice.

Hewlett-Packard makes no warranty of any kind with regard to this manual,

including, but not limited to, the implied warranties of merchantability and fitness

for a particular purpose. Hewlett-Packard shall not be held liable for errors

contained herein or direct, indirect, special, incidental or consequential damages in

connection with the furnishing, performance, or use of this material.

Restricted Rights Legend. Use, duplication or disclosure by the U.S. Government

is subject to restrictions as set forth in subparagraph (c) (1) (ii) of the Rights in

Technical Data and Computer Software clause at DFARS 252.227-7013 for DOD

agencies, and subparagraphs (c) (1) and (c) (2) of the Commercial Computer

Software Restricted Rights clause at FAR 52.227-19 for other agencies.

HEWLETT-PACKARD COMPANY 3000 Hanover Street Palo Alto, California

94304 U.S.A.

reserved.

Reproduction, adaptation, or translation of this document without prior written

permission is prohibited, except as allowed under the copyright laws.

Trademark Notices. UNIX is a registered trademark in the United States and other

countries, licensed exclusively through X/Open Company Limited.

Contents

iii

Who Should Use this Guide. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . vi

1. D Class System Memory Upgrade

Overview of Memory Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1

Memory Installation Procedure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-3

Memory Upgrade Verification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-24

Memory Upgrade Verification Procedure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-25

Troubleshooting Memory Configuration Error Symptoms . . . . . . . . . . . . . . . . . 1-30

Obtaining the Correct Firmware Patch. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-32

Downloading the Firmware Patch via the World Wide Web . . . . . . . . . . . . 1-33

Downloading the Firmware Patch using FTP . . . . . . . . . . . . . . . . . . . . . . 1-34

2. R Class System Memory Upgrade

Overview of Memory Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-1

Memory Installation Procedure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3

Memory Upgrade Verification . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-20

Troubleshooting Memory Configuration Error Symptoms . . . . . . . . . . . . . . . . . 2-24

Obtaining the Correct Firmware Patch. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-25

Downloading the Firmware Patch via the World Wide Web . . . . . . . . . . . . 2-26

Downloading the Firmware Patch using FTP . . . . . . . . . . . . . . . . . . . . . . 2-27

Contents

Printing History

The manual printing date and part number indicate its current edition. The printing

date will change when a new edition is printed. Minor changes may be made at

reprint without changing the printing date. the manual part number will change

when extensive changes are made.

Manual updates may be issued between editions to correct errors or document

product changes. To ensure that you receive the updated or new editions, you should

subscribe to the appropriate product support service. See your HP sales

representative for details.

First Edition: December, 1995

Second Edition: May, 1996

Third Edition: November, 1996

Fourth Edition: August, 1997

Fifth Edition: August 1998

Sixth Edition: October 1998

NOTE Reader Comments. We welcome your comments about our documentation. If you

have editorial suggestions or recommended improvements for this document, please

write to us. You can reach us through e-mail at: hardwaredocs@cup.hp.com or by

sending your letter to: Documentation Manager, M/S 5657, Hewlett-Packard

Company, 8000 Foothills Blvd., Roseville, CA 95747-6588 USA. Please include the

following information in your message:

• Title of the manual you are referencing.

• Manual part number (from the title page).

• Edition number or publication date (from the title page)..

• Your name.

• Your company’s name.

SERIOUS ERRORS, such as technical inaccuracies that may render a program or a

hardware device inoperative, should be reported to your HP Response Center or

directly to a Support Engineer.

Who Should Use this Guide

The procedures in this guide are intended to be performed by a person who is

qualified in the installation and servicing of computer equipment, and is trained to

recognize the hazards involved. Memory is installed in an area of the product where

energy levels considered hazardous may be produced.

1-1

D Class System Memory Upgrade

Overview of Memory Installation

The memory installation procedures are organized as follows:

A. Check existing system memory.

B. Turn off power to the system.

C. Remove the front bezel.

D. Remove the side panel.

E. Remove the EMI cover.

F. Remove the Processor/Memory card.

G. Plan the memory configuration.

H. Install memory modules.

I. Replace the Processor/Memory card.

J. Replace the EMI cover.

K. Replace the side panel.

L. Replace the front bezel.

After completing all installation procedures, proceed to the Memory Upgrade

Verification procedure (located after the installation procedures) for instructions on

how to verify correct installation. If the memory verification is not successful, refer

to the section titled Troubleshooting Memory Configuration Error Symptoms at

the end of this manual.

1-2

D Class System Memory Upgrade

Overview of Memory Installation

Required Tools To perform the procedures in this upgrade guide, the following tools are required:

• Small flat-bladed screwdriver

• Torx driver, #15

• Phillips screwdriver.

Safety

Considerations

WARNING The installation procedures in this guide require opening the system cabinet,

which may expose you to high-energy (high-amperage) circuits, possible

ejection of molten metal, and exposed sharp edges in equipment chassis. Be

sure to remove all rings, watches, and other jewelry from fingers, wrists, and

arms before opening the system cabinet.

Electrostatic

Discharge

Precautions

Electrostatic discharge can damage the integrated circuits on printed-circuit boards.

To prevent such damage from occurring, be sure to observe the following

precautions when handling and installing boards:

1. Use a grounding mat and an anti-static wrist strap, such as those included in the

ESD Field Service Kit (HP P/N A3024-80004).

2. Wear the anti-static wrist strap to ensure that any accumulated electrostatic

charge is discharged from you body to ground.

3. Keep uninstalled printed-circuit boards in their protective anti-static bags until

you are ready to install them.

4. Handle printed-circuit boards by their edges after you have removed them from

their protective anti-static bags.

1-3

D Class System Memory Upgrade

Memory Installation Procedure

A. Check Existing

System Memory To check the memory configuration on your system:

Reboot the system by typing /etc/shutdown -r at the HP-UX system prompt:

/etc/shutdown -r

When prompted, halt the boot process by pressing any key on the keyboard:

Processor is booting from first available device.

To discontinue, press any key within 10 seconds.

Boot terminated.

Main Menu ----------------------------------------------------

Command Description

------- -----------

BOot [PRI|ALT|<path>] Boot from specified path

PAth [PRI|ALT|CON|KEY] [<path>] Display or modify a path

SEArch [DIsplay|IPL] [<path>] Search for boot devices

TOC Soft boot the system

COnfiguration [<command>] Access Configurationmenu/commands

INformation [<command>] Access Information menu/commands

SERvice [<command>] Access Service menu/commands

DIsplay Redisplay the current menu

HElp [<menu>|<command>] Display help for menu or command

RESET Restart the system

-------

Main Menu: Enter command >

1-4

D Class System Memory Upgrade

Memory Installation Procedure

At the Main menu of the Boot Console Handler, type “in me” to display memory

information.

Note the amount of memory listed in the memory information display. After

installing additional memory, you will check this memory information display again

to verify that the system recognizes the newly installed memory

Example Memory Information Display (Models D200/D210/D310)

Main Menu: Enter command > in me

MEMORY INFORMATION

Slot Card Size Amount Enabled

---- --------- --------------

0 16 MB 16 MB

1 16 MB 16 MB

Physical Memory: 32 MB (0x02000000)

Configured Memory: 32 MB (0x02000000)

Main Menu: Enter command >

Example Memory Information Display (all other D2xx and D3xx Models)

Main Menu: Enter command > in me

MEMORY INFORMATION

MEMORY STATUS TABLE

Slot Size(a+b) Status

---- -------- ------

0a/b 128MB Configured

1a/b 32MB Configured

2a/b 32MB Configured

--------

TOTAL 192MB

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels HP Serveur

HP ProLiant ML110 Instructions d'utilisation

HP LC2000r - NetServer - 128 MB RAM Manuel utilisateur

HP P5389A - Intel Pentium III-S 1.4 GHz Processor... Manuel technique

HP 9000 rp3410 Guide d'installation

HP ProLiant BL460c Gen8 Manuel utilisateur

HP ProLiant ML350p Gen8 Manuel utilisateur

HP ProLiant MicroServer Gen8 Manuel utilisateur

HP D7171A - NetServer - LPr Manuel d'installation et d'exploitation

HP Integrity BL860c Manuel utilisateur

HP A4500A - VMEbus Single Board Computer 744... Manuel utilisateur

HP Cluster Platform Hardware Kits v2010 Manuel utilisateur

HP D7171A - NetServer - LPr Manuel utilisateur

HP t5740e - Thin Client Manuel utilisateur

HP ProLiant DL560 Manuel utilisateur

HP ProLiant DL980 Manuel utilisateur

HP ProLiant DL560 Gen11 Manuel utilisateur

HP ProLiant DL380 G5 DPSS Instructions d'utilisation

HP ProLiant DL370 Generation 6 Guide d'installation

HP D5970A - NetServer - LCII Manuel utilisateur

HP NetServer E60 Manuel utilisateur

HP ProLiant ML115 G5 Guide de démarrage rapide

HP CB900s i4 Instructions d'installation

HP D7171A - NetServer - LPr Manuel utilisateur

Manuels Serveur populaires d'autres marques

Dell

Dell PowerEdge R410 Manuel utilisateur

PowerNAS

PowerNAS CMA Manuel utilisateur

Supero

Supero FatTwin F617R3-FT Manuel utilisateur

MSI

MSI P1-109N-L70 Manuel utilisateur

Dell

Dell PowerEdge XE9640 Manuel

Dell

Dell PS4100 Instructions de montage

EtroVISION

EtroVISION EV3151 Manuel utilisateur

NEC

NEC Express5800/T110j Manuel utilisateur

Compaq

Compaq ProLiant 3000 Manuel

Dell

Dell PowerEdge 3YPMN Manuel utilisateur

iRobo

iRobo IPC2U Manuel utilisateur

Nortel

Nortel 1000 Con?guration guide Manuel utilisateur

Asus

Asus AP7500 Manuel d'utilisation et d'entretien

Avid Technology

Avid Technology AirSpeed 5000 Manuel utilisateur

Milestone

Milestone Husky IVO 350T Manuel utilisateur

Planet

Planet NAS-7410 Manuel utilisateur

Lenovo

Lenovo ThinkSystem SR635 V3 Manuel utilisateur

Dell

Dell PowerEdge HS5610 Manuel