HP Model 735 - Workstation Manuel utilisateur

ServiceHandbook

HPApollo9000Series700

Model735Workstations

Thisisanunreleased,correctedversionof

OrderNo.A2095–90602,

producedforonlineaccess.

00893

P!l HEWLETT

PACKARD

Click to go to the Table of Contents

300ApolloDr.,Chelmsford.MA01824

NOTICE

The information contained in this document is subject to change without notice

HEWLETT-PACKARD MAKES NO WARRANTY OF ANY KIND WITH REGARD TO THIS MANUAL, lNCLUD-

ING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A

PARTICULAR PURPOSE, Hewlett-Packard shall not be liable for errors contained herein or direct, indi-

rect, special, incidental or consequential damages in connection with the furnishing performance or use of

this material,

WARRANTY

Acopy of the specific warranty terms applicable to your Hewlett –Packard product and replacement parts

can be obtained from vour local Sales and Service Office.

This document contains information which is protected by copyright. All ri:g,ts are reserved. Reproduction, adaptation,

or translation without prior written permission is prohibited, except as allowed under the copyright laws.

Restricted RiL@t Legend

Use, duplication or disclosure by the U.S. Government Department of Defense is subject to restrictions as set forth in

paragraph (b)~3j(ii) of the Ri@ts in Technical Data and Software clause in FM 52.227–7013.

This software and documentation is based in part on the Fourth Berkeley Software Distribution under licence from the

Regents of the University of California.

Printing History

New Editions of thismanual incorporate all material updated since the previous

edition. Update packages may be issued between editions and contain replace-

ment and additional pages to be merged into the manual by the user.

The manual printing date and part number indicate its current edition. The print-

ing date changes when anew edition is printed. (Minor corrections and updates

which are incorporated at reprint do not cause the date to change.) The manual

part number changeswhen extensive technical changes are incorporated.

Edition 1Original service handbook for Model 735

●mm

111

Emissions Regulations

Federal Communications Commission (FCC)

The Federal Communications Commission of the U.S. government regulates the

radio frequency energy emanated by computing devices through pubhshed regula-

tions. These regulations specify the limits of radio frequency emission to protect

radio and television reception. All HP Apollo nodes and peripherals have been

tested and comply with these limits. The FCC regulations also require that com-

putin~ devices used in the U.S. display the agency’s label and that the related docu-

ment~tion include the following statement:

WARNING: This equipment has been tested and found to comply with the

limits for aClass Adigital device, pursuant to part 15 of the

FCC rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is

operated in acommercial environment. This equipment

generates, uses, and can radiate radio frequency enerb~and, if

not installed and used in accordance with the instruction

manual, may cause harmful interference to radio

communications. Operation of this equipment in aresidential

area is likely to cause harmful interference in which case the

user will be required to correct the interference at his own

expense.

Compliance to these regulations requires the use of shielded cables.

Canadian Department of Communications (DOC)

This digital apparatus does not exceed the Class Alimits for radio noise emissions

from d;gital apparatus as set out in the Radio Interference Requirements of the

Canadian Department of Communications.

Compliance to these regulations requires the use of shielded cables.

Emissions Regulations Compliance

Any third–party 1/0 device installed in HP Apollo system(s) must be in accor-

dance with the requirements set forth in the preceding Emissions Regulations

statements. In the event that athird–party noncompliant 1/0 device is installed,

the customer assumes all responsibility and liability arisingtherefrom.

Compliance to these regulations requires the use of shielded cables.

DECURATION OF CONFORMITY

according toEWIEC Guide22and EN 45014

Manufacturer’s Name:

Hewlett-Packard

100 DomainDrive

IMe@r,

NW U.S.A.

declares, that the product

Product: ComputerWorkstation

Model Numbe~ 735

Product Number: A1946A

conforms to the folluwing Product Specifications:

Safety IEC 9S&1986/EN60950 (1988)

EMC: CISPR 221985/EN 55022 (1988) Chss A

lEC 801-2:1991 /pr EN55101-2 (1990): 3kV CD, 8kVAD

IEC 801-31984/ pr EN554)24-3(1991~ 3V/m

Supplementary Information: The prodwt was tested in atypical Hewlett-Packard

Workstationmnfiguration.

Zxeter, Date Nov. 12,1992

James H. Kelly

Division Quality Manager

European Comtac& lbur heal Hewlet-Packard Saks and Service OffIce or Hewlett-

Packard GmbH, Department ZQKMm@wds EUIWW Hernmberger X)0, D-7030 Boeblingen

(FAX+ 49-7031-141623)

This is aClass Aproduct. In adomestic environment this product may cause radio

interference in which case the user may be required to take adequate measures.

Electrostatic Discharge (ESD) Precautions

Electrostatic charges can damage the integrated circuits on printed circuit boards.

TO prevent such damage from ckxming, &bservethe following precautions when

unpacking and installing the board.

●Stand on astatic–free mat.

●Wear astaticstrap to ensure that any accumulated electrostatic charge dis-

charges from your body to ground.

●Connect all equipment together, including the static–free mat, staticstraps,

routing nodes, and peripheral units.

.Keep uninstalled printed circuit boards in their protective antistaticbags.

●Once you have removed the printed circuit boards from their protective an-

tistatic bags, handle them by their edges.

Table of Contents

Product Information 1

Product Description ................................ 1–2

System Unit Controls ............................OO. 1–3

Power Switch ..................................... 1–4

Power LED ...................................... 1–4

TOCSwitch ...................................... 1–4

Service/NormalModeSwitch... .................... 1–4

UnderstandingtheL Ems...... ...................... 1–5

System Unit Rear Panel Connectors ................... 1–7

SystemI/OConnectors ............................ 1–8

HP–HIL connector ............................... 1–8

HPParallelI/Oconnector .......................... 1–8

Network connectors ............................... 1–8

RS–232SerialInput/Outputconnectors .............. 1–9

Audio connectors ................................ 1–10

SCSII/OConnectors ............................. 1–11

GraphicI/OConnector ........................... 1–12

EISAI/OConnector ............................. 1–12

Monitor Controls, Connectors, and Indicators ......... 1–13

Environmental/Installation/PM 2

Environmental Specifications ........................ 2–1

Regulatory Requirements ............................ 2–2

Installation ........................................ 2–2

Preventive Maintenance ............................. 2–2

Configuration 3

Workstation and System Unit Configurations ........... 3–1

FRU Configurations ................................ 3–1

Mass Storage Configurations.. ....................... 3–1

InstallingAdditonal Memory... ..................... 3–12

vii

.’

‘lloubleshooting 4

LED Error Codes .............. ................... 4–2

Dealingwith aBoot Failure ......................... 4–12

Boot Administration Environment .................. 4–13

Stable Storage ................................... 4–14

Boot Command Notations ........................ 4–15

Supported Foot paths ............................4–15

Invoking the ISLEnvironment froma SCSI Device . . . 4–15

ISLEnvironment ................................ 4–17

ISLUser Commands ............................. 4–17

Running the Disk–BasedISL Diagnostics ........... 4–18

Verifying the System Operation with SupportWave ..... 4–19

Field Replaceable Units 5

Pedestal Feet ...................................... 5–4

Top Cover ......................................... 5–5

Power Supply ........ o...... ....................... 5–7

Backplane/FanAssembly ............................ 5–8

Disk Drives ...................................... 5–10

CoreI/OandProcessorBoard.. ..................... 5–12

System EEPROM ................................ 5–13

Memory ........................................ 5–14

Calendar Battery .................................. 5–16

LANSliderModule ............................... 5–17

Graphics Board ................................... 5–18

FrontControlPanel ............................... 5–19

Diagrams 6

Reference 7

Installation Manual ................................. 7–1

Service Manuals ................................... 7–1

Reference Manuals ................................. 7–1

Service Notes 8

●00

Figures

. .

1–1

1–2

1–3

1–4

1–5

1–6

1–7

1–8

3–1

3–2

3–3

3–4

3–5

3–6

3–7

3–8

3–9

3–lo

3–11

4–1

5–1

5–2

5–3

5–4

5–5

5–6

5–7

5–8

5–9

5–lo

5–11

5–12

Power Switch Location ......................... 1–3

TOC and Service/Normal Mode Switch Locations . . 1–4

System LEDs ................................. 1–5

Troubleshooting System LEDs .................. 1–6

Mode1735Rear Panel Connectors ............... 1–7

Audio Connectors ............................ 1–10

19–Inch, Color Monitor (ModelA2094) ......... 1–14

19–Inch, Grayscale Monitor (ModelA2088A) . . . 1–15

DefaultSCSIIDs ............................. 3–2

Quantum 210–MB Winchester Drive Jumpers ..... 3–3

Hewlett–Packard 420–MBWinchester Drive Jumpers

(Early Model) ................................ 3-4

Hewlett –Packard 420–MB Winchester Drive Jumpers

(Late Model) ................................. 3–5

Quantum 525–MB Winchester Drive Jumpers ..... 3–6

Seagate 525–MB Winchester Drive Jumpers ...... 3–7

Hewlett –Packard 1– GB Winchester Drive Jumpers

(Single–Ended) .............................. 3-8

Micropolis 1– GB Winchester Drive Jumpers

(Single–Ended) .............................. 3–9

Hewlett –Packard 1– GB Winchester Drive Jumpers

(Fast/Wide) ................................. s–10

Floppy Address Jumper Settings ................ 3–11

Installing Memory Cards ...................... 3–13

Front Panel LEDs ............................. 4–2

Removing Pedestal Feet ........................ 5–4

Removing Top Cover Screws .................... 5–5

Lifting Top Cover .............................5–6

Removing the Power Supply .................... 5–7

Backplane/Fan Removal ........................ 5–8

Removing the Fans and Backplane Assemby ....... 5–9

Removing the First Disk Drive ................. 5–10

Mounting the Disk Drive Assembly on the Disk Tray5– 11

Connecting Cables tothe Disk ................. 5–11

Removing the Core I/Oand Processor Boards .... 5–12

Component Locations ........................ 5–13

Removing Memory Boards .................... 5–14

5–13 Removing the Calendar Battery ................ 5–16

5–14 LAN Slider Module Removal .................. 5–17

5–15 Removing the Front Control Panel .............. 5–19

6– 1 System Unit Functional Block Diagram ........... 6–2

Tables

1– 1 LED Display During Normal System Activity ...... 1–6

l–~ Serial I/O Pins eeo. oo. eo. oo. oeoao . .. O.O.OOO...O 1–9

2– 1 Environmental Specifications for Model 735 SPU . . 2– 1

4–1 Selftest LED Codes ........................... 4–3

4–2 PDCLEDCodes coooe. oo. ..e. ..e . . .. O. . . . .. O.. 4–7

4–3 ISLLED Codes ............................... 4–9

4–4 HP–UXKernel LED Codes ................... 4–11

5–1 FRUList .................................... 5–2

❑n

❑o

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels HP Ordinateur de bureau

HP Compaq dc7800 Series Instructions d'utilisation

HP ENVY Recline 27-k050xt TouchSmart Mode d’emploi

HP Compaq Presario Manuel utilisateur

HP HP 9000 Series 500 Manuel utilisateur

HP dx7400 - Microtower PC Manuel utilisateur

HP Compaq 8200 Elite Series Instructions d'utilisation

HP Xw4200 - Workstation - 1 GB RAM Manuel utilisateur

HP Net Vectra Manuel du produit

HP Z210 Series Manuel utilisateur

HP Compaq Presario Fiche technique

HP D7171A - NetServer - LPr Manuel utilisateur

HP T1000 Manuel utilisateur

HP Presario SR1200 - Desktop PC Manuel utilisateur

HP Compaq Microtower Business PC dx2300 Instructions d'utilisation

HP s7600n - Pavilion Media Center Fiche technique

HP Presario SA4000 Manuel utilisateur

HP Spectre One 23-e000 Manuel utilisateur

HP Compaq d330 ST Manuel utilisateur

HP Pavilion w1000 - Desktop PC Manuel utilisateur

HP i2000 Instructions de montage

HP dx7500 - Microtower PC Manuel utilisateur

HP Pavilion d1000 - Desktop PC Manuel utilisateur

HP Net Vectra n30 Manuel

HP dx2420 - Microtower PC Manuel d'utilisation et d'entretien

Manuels Ordinateur de bureau populaires d'autres marques

Asus

Asus E210 Series Manuel utilisateur

Dell

Dell Inspiron 600m Manuel utilisateur

Dell

Dell Inspiron 3662 Manuel utilisateur

TotalFlow

TotalFlow uFLO Manuel utilisateur

Logitech

Logitech MK320 Manuel utilisateur

Dell

Dell XPS 730 H2C Manuel utilisateur

Sony

Sony Vaio Series Manuel utilisateur

Sony

Sony VGC-LT32E - Vaio All-in-one Desktop Computer Manuel utilisateur

Alto

Alto MD 250 Manuel utilisateur

Lenovo

Lenovo ThinkCentre Edge 72 Manuel

Lenovo

Lenovo ThinkStation D20 Manuel

Arbor Technology

Arbor Technology FPC-7800 Series Manuel utilisateur

Sony

Sony VAIO VGX-TP1 Series Manuel utilisateur

Asus

Asus Eee Box B204 Manuel utilisateur

Dell

Dell Optiplex 9010 All In One Manuel utilisateur

Everex

Everex eXplora Manuel utilisateur

Lenovo

Lenovo ThinkCentre M75e Manuel utilisateur

Dell

Dell Alienware Area-51 R4 Manuel utilisateur