HP F150 Manuel utilisateur

f150

Wireless Mini Camcorder

User Manual

Preface

About this Manual

This manual is designed to demonstrate the features of your HP

Wireless Mini Camcorder f150. All information presented is as

accurate as possible but is subject to change without notice.

HP shall not be liable for technical or editorial errors or omissions

contained herein.For the latest reversion, visit www.hp.com/support.

This manual contains proprietary information protected by copyright.

All rights are reserved. No part of this manual may be reproduced by

any mechanical, electronic or other means, in any form, without prior

Federal Communications Commission notice

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

· Reorient or relocate the receiving antenna.

· Increase the separation between the equipment and receiver.

· Connect the equipment to an outlet on a circuit different from that

to which the receiver is connected.

· Consult the dealer or an experienced radio or television technician

for help.

Modifications:

The FCC requires the user to be notified that any changes or

modifications made to this device that are not expressly approved by

HP may void the user's authority to operate the equipment.

Trademark Recognition

Windows XP/Vista/Windows 7/Windows 8 are registered trademarks

of Microsoft Corporation in the United States and/or other countries.

Macintosh and Mac OS are registered trademarks of Apple Inc. In

addition, all other companies or product names are trademarks or

registered trademarks of their respective companies.

Safety and Handling Precautions

WARNING:

Follow these instructions to prevent damage to the camcorder:

· DO NOT USE UNPROTECTED IN RAIN OR WATER. PREVENT CONTACT

WITH ANY KIND OF LIQUIDS

· USE RECOMMENDED ACCESSORIES ONLY

· DO NOT DISASSEMBLE OR ATTEMPT REPAIRS ON YOUR OWN.

DISASSEMBLING THE CAMCORDER MAY VOID THE WARRANTY

· THERE ARE NO PARTS OR COMPONENTS INSIDE THAT NEED TO

BE MAINTAINED

· REPAIRS WILL BE MADE BY AUTHORIZED SERVICE CENTERS ONLY

· Do not touch the camcorder lens

· Do not use abrasive chemicals, cleaning solvents or strong

detergents to clean the product. Wipe the product with a clean

slightly damp soft cloth.

ATTENTION!

· ELECTROSTATIC DISCHARGE OR STRONG ELECTROMAGNETIC

FIELDS CAN AFFECT THE CAMCORDER. RESTART THE CAMCORDER

IN THIS CASE.

| 1

English

HP Wireless Mini Camcorder f150

Clip Mount Magnet Mount

Tripod Mount

Strap Mount

Record Button

Status LED

Microphone

Micro SD

memory

Card Slot

Micro USB

Port

Strap Hook

Speaker

Video Mode

Photo Mode

Direct Mode

Cloud Mode

Mode Button

Power Button

Mode Indicators:

2 | English

Getting Started

Charging the camera

•

Before first use, charge the battery using AC adapter or PC USB.

• While charging the Status LED will flash. Upon completion, it

will turn off.

Mode Selection

• Press Power button to turn on camera.

• Press Mode button to switch between the two camera modes

(Video, Photo) and the two wireless modes (Direct, Cloud).

Two Camera Modes

Insert a micro memory SD card. (not included/accessory)

Video

• Press the Mode button to select the Video Mode.

• Press the Record button to capture video, press again to stop.

Photo

• Press the Mode button to select Photo Mode.

• Press the Record button to take still photos.

Two Wireless Modes

Before using the wireless modes, install the HP Ucam application:

•

Mobile: Download the

HP Ucam

AP from Google Play or Apple Store.

• PC: Install HP Ucam for Windows. (see page 6)

Direct Mode - local

Connect your f150 to your mobile unit or PC directly for remote

control, live view, managing albums, and camera & cloud setup.

Cloud Mode - Internet

Connect the f150 to a Cloud server via Access Point (AP) or mobile

Hotspot for Internet live video streaming or monitoring.

| 3

English

Cloud Mode (Internet)

Cloud Server

Cloud AP

Mobile Hotspot

Mobile / PC

USTREAM

3G/4G

The f150 can broadcast live streaming video to the Internet

on Ustream. You must first establish an account on Ustream

(www.ustream.tv) After you have established a Ustream account you

will use the HP Ucam AP on your PC or mobile device in Direct Connect

mode to enter your Ustream account information into the f150.

Anyone with a web browser will be able view your video streams.

Mobile users can install the Ustream AP on their mobile devices.

(Search YouTube for videos about the f150 that explain this in greater

detail.)

Getting Started

Direct Mode (Intranet)

Mobile / PC

Wireless Connection

Direct Mode (Connect to a Mobile unit or local PC)

Cloud Mode (Connect to the Internet)

Live Streaming Internet broadcast using Ustream:

4 | English

Direct Mode (to Mobile or PC)

You will setup your f150 using the HP Ucam mobile (or PC) AP.

Each f150 has a unique Camera ID. ( U2-xxxxxx) A password

is not required for first use. You may use the Setup function in

HP Ucam to enter a device password once you are connected.

Cloud Mode (stream to Internet)

Android users:

• Set camera to Direct Mode .

• On mobile, activate WiFi

connection.

• Start the HP Ucam AP.

• Explore the functions.

iOS users:

• Set camera to Direct Mode .

• On mobile, go to [Settings]

[Wi-Fi] Choose U2-xxxxx.

• Start the HP Ucam AP.

• Explore the functions.

Connect directly to your f150 -

Android:

iOS:

Zoom In Zoom Out Invert Image

Take Photos (SD card required) Capture Video (SD card required)

Loop Recording (SD card required)

• Retaining the last 10 minutes of recording.

Talk to your f150 (half-duplex voice communication)

• Press the mic icon and speak into your mobile - to the camera!

• The f150 microphone is mute while you are are speaking.

Quad View (multiple cameras)

• Press to enable Quad View. (view up to four cameras)

• Select "1" to return to single camera view.

| 5

English

Before using Internet Cloud Mode, you must setup your f150 camera.

You must enter your wireless network and Ustream (Cloud AP/Cloud

Service) parameters into the camera using HP Ucam. To do so, connect

to your f150 using Direct Mode (see page 4).

• Start HP Ucam. Go to setup. Scroll down to "Cloud Setting."

1. Select the preferred WiFi network you wish to use and enter

its WiFi password, if any. This step enables the f150 camera to

get on the local WiFi wireless network for Internet access.

Next, you must enter your Cloud Server (Ustream) information.

• Press then enter your Username (and/or email address)

and password for the Cloud AP you wish to use, such as Ustream.

When completed press [Save to Camera]. This will store your WiFi

and Cloud AP information to the camera.

Once you have setup your camera there are two ways to connect

it to a Cloud server:

1. Power on the camera. It will go to Direct Mode. Connect

your mobile to the f150 in Direct Mode. Start HP Ucam. Press

on Setup. Press [Camera to Cloud]. The camera will switch from

Direct Mode to Clous Mode for live streaming to the Cloud.

2. Power on the camera. Press the mode button to select Cloud

mode. The Cloud LED will flash red while connecting to the Cloud.

When the camera has sucessfully connected to the Cloud, the LED

will flash green, slowly. If the connection is unsucessful the Cloud

LED will flash fast-red. In that case, check your Cloud AP settings

Once your camera is connected to the Cloud you may view

your Live Video

at:

www.ustream.tv

Cloud Mode (stream to Internet)

6 | English

Using the f150 with your PC

There is a HP Ucam application for Windows. Install HP Ucam on

your wirelessly-connected PC and then note that the functionality

on the PC application is very similar to the mobile AP.

Install HP Ucam for PC from the Camera

• Connect your camera to your PC bu USB.

• HP Ucam will AutoRun (if AutoRun activated automatically.)

• If AutoRun is not activated Go to [My computer] search the f150

drive icon for the HP Ucam installation executable.

• Once installed, HP Ucam will run. (If not double-click program icon)

• Unplug the camera from USB for WiFi application, or keep it

connected via USB for additional USB applications.

Additional utility when connect by USB:

Note: While connected by USB, The [View] function on HP Ucam

is disabled. Press camera Mode button to switch between Mass

Storage Mode and Webcam Mode.

Mass Storage Mode (default): (LED indicator is orange)

1. You may transfer Video and Photo files from camera to your PC

• Go to [Album] Select video/photo Press [Save to PC].

2. Upload Videos/Photos to YouTube, Facebook or Youku

• Go to [Setup] [Upload Setting].

• Enter Email/Username and Password.

• Press [Save to PC].

• Go to [Album] Select video/photo Press [Upload].

Webcam Mode: (LED Indicator is green)

• Close (exit) the HP Ucam program.

•

For video Instant Messaging (Skype or QQ), select "U2 video device"

and "U2 audio device". (For Win XP, select "video device")

| 7

English

Control, Audible & Visual Indicators

Camera Control Functions

Power Off

Press Power button for 5 sec. to turn off.

Restore

Default

Setting

Press both Mode and Record buttons for

5 seconds to restore default settings.

Dashboard

Recording

Press the Record button for 3 sec. to start

loop recording

and to

invert the image.

Condition LED Status Indicator # Beeps

Recording Slow flash, Green One

Loop Recording Slow flash, Orange One

Charging Slow flash, Red

Fully Charged Two

Low Battery Flash Red every 5 sec (Warning) Five, then

shutdown

Power Off Two

Auto Power Off

(5 mins idle) Slow flash, Red Two

Memory Full

SD Card Error Slow flash, Red Three

No Cloud AP

No Cloud Account Fast flash, Red Three

Direct-Mode Ready Steady Green

Connecting Wireless Fast flash, Green

Streaming Video Slow flash, Green

Autres manuels pour F150

Table des matières

Manuels caméscope populaires d'autres marques

Toshiba

Toshiba CAMILEO Z100 Manuel utilisateur

Panasonic

Panasonic NV-VS40B Manuel utilisateur

Canon

Canon RC 260 Manuel utilisateur

Sony

Sony Handycam DCR-DVD7E Manuel utilisateur

Brinno

Brinno TimeLapse TLC200 Manuel utilisateur

JVC

JVC GR-SXM68AC Guide de démarrage rapide

Panasonic

Panasonic AG-HMC152EN Manuel utilisateur

Insignia

Insignia NS-DCC5HB09 - Camcorder - 720p Manuel utilisateur

MYDLINK

MYDLINK DCS-6100LH Manuel utilisateur

Sony

Sony video Hi8 Handycam CCD-TR555 Manuel utilisateur

SECURECOM

SECURECOM V-5014B Manuel utilisateur

Panasonic

Panasonic HDC-SD100 Manuel utilisateur

Sharper Image

Sharper Image U-VIDEO Manuel utilisateur

JVC

JVC AA-V15EG Manuel utilisateur

Canon

Canon LEGRIA HV40 Manuel utilisateur

Sony

Sony Handycam DCR-VX2000 Manuel utilisateur

RCA

RCA CC616 Manuel utilisateur

Panasonic

Panasonic NVM40 Manuel utilisateur