Hoyles Dado Panic Strip Manuel d'installation
Dado Panic Strip Additional Information
1.Installation
When installing dado panic strip the space between the edge of the aluminium channel and
the edge of the wall must be taken into consideration. If using a standard end as illustrated in
Figure 1.1, a minimum gap of 33mm must be left between the end of the aluminium channel
and the wall as in Figure 1.2.
If using a corner piece as in Figure 1.3, the minimum required gap between the aluminium
channel and the edge of the wall/corner are as follows;
•55mm for an external corner (Figure 1.4).
•70mm for an internal corner (Figure 1.5).
Figure 1.1: Panic strip with end cap.
33mm
Figure 1.2: Distance from aluminium
channel to wall for use with end cap.
Figure 1.3: Panic strip with Corner.
55m
m
55m
m
Figure 1.4: External Corner.
70mm
70mm
Figure 1.5: Internal Corner.
2.Ordering
When the dado panic strip is delivered to site it cannot be altered in length, therefore it is of
vital importance to ensure the sizes are correct when placing the order, please measure from
corner to corner. To ensure the order is placed correctly please include a sketch of the area
the dado is required for as illustrated in Figure 2.1, a hand drawn sketch will suffice.
As well as the measurements, when
placing an order colour preference is
also required as is whether the strip is
to be illuminated or not.
Table 2.1 is a quick checklist of the
requirements to place an order.
Order Checklist
Measurements
Sketch
Dado Colour
LED Illumination
3.Fitting the switch
When fitting the dado panic strip, there are two grooves on the aluminium channel, these
denote the top and therefore should be facing upwards when attached to the wall.
Only when the channel is correctly orientated and attached to the wall can the switch be
inserted. The switch must be inserted under the upper lip of the aluminium channel then
pressed in at the bottom as shown on above.
If the switch is installed in any other manner, including pulling in from the side or forcing it
under the bottom lip first, it will suffer damage.
Figure 2.1. Sketch to order dado panic
strip.
Table 2.1
3496mm
3496mm
2154mm 1127mm
Corner Piece Corner Piece
Corner Piece
Corner Piece
Endcap
Endcap
1301mm 1301mm
550mm
551mm
1499mm
INT Corner
EXT Corner
EXT Corner
INT Corner
Autres manuels Hoyles Système de sécurité
Hoyles
Hoyles EXITGUARD EX125i Manuel utilisateur
Hoyles
Hoyles EXITGUARD EX204 Manuel utilisateur
Hoyles
Hoyles MAYDAY Manuel utilisateur
Hoyles
Hoyles EXITGUARD Manuel utilisateur
Hoyles
Hoyles EXITGUARD EX125iS-H Manuel utilisateur
Hoyles
Hoyles EXITGUARD EX200 series Manuel utilisateur
Hoyles
Hoyles A600WKITB Manuel utilisateur
Manuels Système de sécurité populaires d'autres marques
EDM
EDM Solution 6+6 Wireless-AE Manuel utilisateur
Highway Safety Group
Highway Safety Group EA401 Manuel utilisateur
Siren
Siren LED GSM Manuel utilisateur
Detection Systems
Detection Systems 7090i Instructions de montage
Se-Kure Controls
Se-Kure Controls MicroMini SK-4841 Manuel utilisateur
Siemens
Siemens FDM273 Manuel utilisateur