Hotpoint E320SKIX Manuel utilisateur

Index

Instructions for use

Installation, 4

Use, 4

Maintenance, 4

Instructions for the installater

Installation, 6

Positioning, 6

Electrical connection, 6

Assistance, 7

THIS APPLIANCE IS CONCEIVED FOR

DOMESTIC USE ONLY.THE MANUFACTURER

SHALL NOT IN ANY WAY BE HELD

RESPONSIBLE FOR WHATEVER INJURIES

OR DAMAGES ARE CAUSED BY INCORRECT

INSTALLATION OR BY UNSUITABLE,WRONG

OR ABSURD USE.

English

Dear customer,

We thank you and con-gratulate you on your

choice. This new carefully de-signed product,

manu-facturedwiththehighestqualitymaterials,

has been carefully tested to satisfy all your

cooking demands. We would therefore request

you to read and follow these easy instructions

which will allow you to obtain ex-cellent results

right from the start. May we wish you all the

very best with your modern appliance!

THE MANUFACTURER

Electrical Cooking Hob

E320SKIX

Instructions for use

USE OF ELECTRICAL PLATES

quick-normal intensity of heat

1 Weak

2 Gentle

3 Slow

4 Medium

5 Strong

6 Bright

Fig.1

Fig.2

Installation

All operations relative to installation (electric connection)

should be carried out by skilled personnel in conformity

with the rules in force. As for the speciﬁc instructions see

part pertaining to installer.

Use

Electric plates (Fig. 1 - 2 - 3)

Rotate the knob to the position correspondent to the

needs of cooking taking into consideration that to a

higher number a higher heat supply corresponds,

see table “use of electric plates”. “Quick and normal

plates”: clockwise and anticlockwise rotation with

7 ﬁxed position (0÷6). The pilot lamp on indicates

when plate is connected.

Some types of pilot lights will maintain some slight

luminescence even after disconnection. That is quite

normal.

N.B.:

- When one makes use of electric plates, we advise

receptacles with ﬂat bottom having same diameter or

lightly higher than that of the plate;

- avoid overﬂows of liquid, therefore when boiling

has happened or in any case when liquid is heated,

reduce the heat supply;

- don’t leave the electrical plates on without receptacles

on the top or with void pots and pans;

- at the end of cooking take again the knob to position “0”.

Maintemace

Before every operation it’s necessary to disconnect the

apparatus. To obtain a higher life of the apparatus concerned

it’s indispensable to carry out at regular intervals a carefully

general cleaning bearing in mind the following:

- the s/s and/or enameled parts should be cleaned by

means of suitable not abrasive or corrosive products

(available on the market). Avoid cloride-base products

(bleach, etc.)

- avoid leaving on the top acid or alkaline substances

(vinegar, salt, lemon-juice, etc.)

- the electric plates have to be cleaned by means of a wet

rag and lightly oiled with lubricant when they are still tepid.

DO NOT USE STEAM CLEANERS

HO5RR - F3 x 1.5

HO5RR - F4 x 0.75

Apparatus class I (type Y): it can be brought near furniture being higher than the work-top

ELECTRIC PLATES

SUPPLY

TYPE

WREGULATION

~ 230 V • QUICK Ø 145 1500

CLOCKWISE AND ANTICLOCKWISE ROTATION

• QUICK Ø 180 2000

• red pointFig. 4

Fig. 5

1 - Ø 145

2 - Ø 180

Fig. 3

Instructions for the installer

Installation

These instructions are turned to the skilled installer as

a guide toinstallation, regulationand maintenance in

compliance with the lawsand the rules in force. Any of

these operationsmust always be carriedout when the

appliancehas been disconnected from the electric

system.

Positioning (Fig. 4)

The apparatus isprovided to be built-in awork-top

as shown in thespecial ﬁgure.Present the sealing

agentalong all the perimeter.

Electrical connection (Fig. 5)

Before carrying out theelectrical connection be sure that:

- the characteristics of the system are such as tosatisfy

what indicated onthe part number plateapplied to the

bottom ofthe work-top;

- that the system is provided with the effective ground

in compliance with the rules and the provisions of law

in force. The ground is binding according to the law.

In case the apparatus isn’tprovided with cable and/or

with relative plugmake use of material suitable for the

absorption indicated inthe part number plate andfor

the workingtemperature. The cableshould reach in

no point atemperature higher 50°Cthan of the room

temperature.

If connecting directly to the mains power supply, ﬁt a multi-

poles witch of a suitable size for the rated capacity with

a clearance distance which completely disconnects the

power line under over voltage category III conditions,

consistently with the rules of installation (the yellow/green

earth wire must not be interrupted).

The plug on the omnipolarswitch should be easilyreachable

with apparatusinstalled.

N.B.:-Themanufacturerdeclinesallresponsibilityincase

the above and the usual safety rules aren’trespected.

To avoid all risk, if the powercable becomes damaged,

it mustonly be replaced bythe manufacturer, byan

authorised service centre, or by aqualiﬁed electrician.

The manufacturer declines all responsibility for possible inaccuracies contained in this pamphlet, due to printing or

copying errors. We reserve the right to make on our own products those changes to be considered necessary or useful,

without jeopardizing the essential characteristics.

Assistance

Before contacting After-Sales Service:

1. See if you can solve the problem yourself.

2. Switch the appliance on again to see if the problem

has been solved. if it has not, disconnect the

appliance from the power supply and wait for about

an hour before switching on again.

3. If the problem persists after this course of action,

contact After-Sales Service.

Specify:

• the nature of the fault,• the model• the service number (the number after the word SERVICE on the rating plate on the rear of the

appliance)

• your full address,• your telephone number and area code.Never call on unauthorized technicians and always

refuse to purchase non-original spare parts.

Notes

Morley Way, Peterborough, PE2 9JB, Englandwww.hotpoint.co.uk

Cod. 1.007.23.0

Table des matières

Autres manuels Hotpoint Plaque

Hotpoint

Hotpoint E604 Manuel utilisateur

Hotpoint

Hotpoint PAN 642 IX/H Manuel utilisateur

Hotpoint

Hotpoint TD 641S (BK) IX/HA TR Manuel utilisateur

Hotpoint

Hotpoint PH 640 M/HA Manuel utilisateur

Hotpoint

Hotpoint PHC 961 TS/IX/H Manuel utilisateur

Hotpoint

Hotpoint GF640 Manuel utilisateur

Hotpoint

Hotpoint PH 930 MST/HA Manuel utilisateur

Hotpoint

Hotpoint PK 640 R GH /HA Manuel utilisateur

Hotpoint

Hotpoint KEC 635 T C Manuel utilisateur

Hotpoint

Hotpoint 6344 Manuel du propriétaire

Hotpoint

Hotpoint G310 Manuel utilisateur

Hotpoint

Hotpoint PK 750 R GH /HA Manuel utilisateur

Hotpoint

Hotpoint E6005 Manuel utilisateur

Hotpoint

Hotpoint E6004 Manuel utilisateur

Hotpoint

Hotpoint HR 724 B H Manuel utilisateur

Hotpoint

Hotpoint BG05 Manuel utilisateur

Hotpoint

Hotpoint PAS 642 /H(WH) Manuel utilisateur

Hotpoint

Hotpoint GB 630 R T X Manuel utilisateur

Hotpoint

Hotpoint GF941 Manuel utilisateur

Hotpoint

Hotpoint KIO 632 CC Manuel utilisateur

Hotpoint

Hotpoint KIB 644 C E Manuel utilisateur

Hotpoint

Hotpoint KSB 640 X Manuel utilisateur

Hotpoint

Hotpoint HR 619 CH Manuel utilisateur

Hotpoint

Hotpoint E6011 Manuel utilisateur

Manuels Plaque populaires d'autres marques

Siemens

Siemens EX875KYV1E Fiche technique

AEG

AEG CERAMIC HOB 6010 K Manuel utilisateur

VALERA

VALERA CT 70A Manuel utilisateur

Zanussi

Zanussi ZGF 6420 Manuel utilisateur

Gaggenau

Gaggenau CI 273 Manuel utilisateur

G3 Ferrari

G3 Ferrari Energy Manuel utilisateur

Pkm

Pkm IN4B Manuel utilisateur

Award

Award H903BG Manuel utilisateur

Zanussi

Zanussi VCH 5005 RZ Manuel utilisateur

Miele

Miele KM 523 Manuel utilisateur

AEG

AEG HK854870XB Manuel utilisateur

Cookology

Cookology SEP600BK Manuel utilisateur

Bauknecht

Bauknecht Hob Manuel utilisateur

Zanussi

Zanussi ZGM 782 Manuel utilisateur

dipo INDUCTION

dipo INDUCTION DIBK218S Manuel utilisateur

Miele

Miele KM 5987 Manuel utilisateur

Miele

Miele KM 360 G Manuel utilisateur

Blomberg

Blomberg MKN 24201 W Manuel utilisateur