Honeywell 5816 WMWH Manuel utilisateur

www.FoxGuardSecurity.com

INSTALL WIRELESS DOOR & WINDOW CONTACTS

INSTRUCTIONS - INSTALLING A WIRELESS CONTACT - HONEYWELL 5816

1- Carefully open the Honeywell 5816 WMWH wireless contact package and lay out all of the

included parts. Locate the gray 3M mounting tape, if purchased.

2- Open the cover of the wireless contact by gently depressing the thumb tab on the one end and

gently pull the cover up.

3- Insert the supplied lithium CR123 battery carefully observing the

polarity, keeping the (+) oriented towards the thumb tab used to

rrelease the contact cover previously removed.

4- Using a #1 ﬂat head or smaller screwdriver, gently depress the

small tab visible on the underside of the contact, to allow the plastic

mounting base to slide off of the Honeywell contact. This mounting base will mount to the door

or window ﬁrst.

5- The contact assembly consists of two (2) main components - the contact itself which contains

a small magnetic reed style switch located near the battery, and a magnet which activates the

switch wswitch when in close proximity. When the switch is activated it is CLOSED The contact itself will

be mounted to either the door or window, and the supplied magnet will be installed on the door

frame/trim or window trim/upper window lip.

6- Using either the supplied double sided tape (GOOD) or 3M gray

double sided tape (BETTER) , attach the appropriate sized

mounting tape to the underside of the mounting base (Approx. 90%

the size of the base) being sure to leave the exposed tape area still

pprotected until you are ready to install.

7- Locate a suitable area on the door or window to be protected,

keeping in mind a few important items:

a) Door- The contact should be mounted on the upper corner of the door, vertically at the

edge so the magnet will be within 1/2” of the contact when mounted on the door trim.

b) Window - On double hung windows the contact can be mounted on the top ledge of the

bottom window, away from the locks or tilting releases, and the magnet can be mounted

Continued...

www.FoxGuardSecurity.com

INSTALL WIRELESS DOOR & WINDOW CONTACTS

INSTRUCTIONS - INSTALLING A WIRELESS DOOR OR WINDOW CONTACT - continued.

b) Window - (continued) on the lower frame of the upper window, aligned with the

mounting base magnet alignment tab.

a) Optional - For a more permanent mounting of the contact, run a small bead of GE

silicone around the base and wipe bead with a wet sponge or paper towel for a clean,

professional ﬁnish.

a) Optional - For a more permanent mounting of the magnet,

run a small bead of GE silicone around the outside and wipe

bead with a slightly wet sponge or paper towel for a clean,

professional ﬁnish.

8- Once a suitable location is determined, remove the protective layer

from the double sided tape on the mounting base, and place the

base on a clean, grease free surface with the magnet

alignment tab facing the direction the magnet will be placed. Optimal

gap between contact and magnet is less than 1/2”. Tap the base

with moderate pressure to help the adhesive ﬁrmly take hold of the surface.

9- Install the cover on the contact by aligning the two tabs on the end opposite of the thumb

release and closing the cover until it locks positively over the release tab.

10- Install the contact on the previously installed base, by aligning the two female mounting

holes with the two male tabs on the base and sliding the contact up or down 1/4” until it locks

over the base plate.

11- Install the supplied magnet on the door frame/trim or window trim by applying the supplied

mounting tape (GOOD) or 3M gmounting tape (GOOD) or 3M gray mounting tape (BETTER) to the bottom of the magnet

mounting base, align with the two small marks on the contact and keep within 1/2” of contact

itself. Be sure magnet or contact will not interfere with opening or closing of the door or window.

12- Be sure to place the small sticker from the side of the contact with

the RFID # a___-_____ on the next page, and keep that page accessible for programming.

DO NOT mix this up with any other contacts RF numbers.

www.FoxGuardSecurity.com

INSTALL WIRELESS DOOR & WINDOW CONTACTS

INSTRUCTIONS - INSTALLING A WIRELESS DOOR OR WINDOW CONTACT

Window 1_______________

Window 2_______________

Window 3_______________

Window 4_______________

Door 4_______________

Door 3_______________

Door 2_______________

Door 1_______________

1- Wireless door & window documentation - use back of page if more zones are needed.

Table des matières

Autres manuels Honeywell Système de sécurité

Honeywell

Honeywell VISTA-128FBPT Manuel utilisateur

Honeywell

Honeywell Lynx Plus Series Manuel utilisateur

Honeywell

Honeywell Friedland HISK1 Manuel utilisateur

Honeywell

Honeywell Galaxy 8 Manuel utilisateur

Honeywell

Honeywell Lynx Plus Series Mode d'emploi

Honeywell

Honeywell LYNX Touch L7000 Series Manuel utilisateur

Honeywell

Honeywell ADEMCO VISTA-40 Mode d'emploi

Honeywell

Honeywell Galaxy Dimension Manuel utilisateur

Honeywell

Honeywell Galaxy 2-44+ Manuel utilisateur

Honeywell

Honeywell ADEMCO LYNXRIEN-EA Manuel utilisateur

Honeywell

Honeywell S-Quad Manuel d'instructions

Honeywell

Honeywell ADEMCO VISTA-10P Instructions de montage

Honeywell

Honeywell Ademco Lynx Touch Manuel utilisateur

Honeywell

Honeywell Notifier P700N Manuel utilisateur

Honeywell

Honeywell Lynx Plus Series Manuel utilisateur

Honeywell

Honeywell ADE ACCENTA Gen4 Manuel utilisateur

Honeywell

Honeywell VISTA-32FBPT Manuel utilisateur

Honeywell

Honeywell Galaxy Flex V3 Series Guide de l'utilisateur

Honeywell

Honeywell Domonial Manuel utilisateur

Honeywell

Honeywell HS321S Manuel utilisateur

Honeywell

Honeywell 4219 Manuel utilisateur

Honeywell

Honeywell MA-2000 Manuel utilisateur

Honeywell

Honeywell Ademco VISTA-32FB Manuel utilisateur

Honeywell

Honeywell Lyric SIXSIREN Manuel utilisateur

Manuels Système de sécurité populaires d'autres marques

Inner Range

Inner Range Concept 2000 Manuel utilisateur

Climax

Climax Mobile Lite R32 Instructions de montage

CADDX

CADDX NX-6 Manuel utilisateur

FBII

FBII XL-31 Series Manuel utilisateur

Johnson Controls

Johnson Controls PENN Connected PC10 Manuel utilisateur

Aeotec

Aeotec Siren Gen5 Manuel utilisateur

Blaupunkt

Blaupunkt SA 2700 Manuel utilisateur

IDEAL

IDEAL Accenta Manuel du propriétaire

AJAX

AJAX DoubleButton Manuel utilisateur

Swann

Swann SW-P-MC2 Manuel utilisateur

Ecolink

Ecolink Siren+Chime Manuel utilisateur

Digital Monitoring Products

Digital Monitoring Products XR150 Manuel utilisateur

EDM

EDM Solution 6+6 Wireless-AE Manuel utilisateur

Highway Safety Group

Highway Safety Group EA401 Manuel utilisateur

Siren

Siren LED GSM Manuel utilisateur

Detection Systems

Detection Systems 7090i Instructions de montage

Se-Kure Controls

Se-Kure Controls MicroMini SK-4841 Manuel utilisateur

Siemens

Siemens FDM273 Manuel utilisateur