Honeywell IS-215T Manuel utilisateur

❶Select the mounting location.

❹Wire the unit.

❸Mount the unit.

Mounting Location Guidelines

• 2.3 m (7’6”) mounting height

• Avoid direct or reflected sunlight

• Aim sensor away from windows or heating/

cooling devices

• Sensor must have a clear line-of-sight to

protected area

• Push outward on the

PCB latch and lift the

PCB out of the hous-

ing.

• Slide the wire through the wire channel and wire

access in the back housing.

• Mount the back housing flat against a wall or in a

corner.

• Replace the PCB.

• Connect wires as shown using 0.64 - 1.63 mm2

(14 to 22 AWG) wire size. Observe proper

polarity.

Corner

Mount

Wire Channel

Wall Mount

IS-215T Passive Infrared Motion Sensor Installation Instructions

❷Separate the sensor housings and re-

move the printed circuit board (PCB).

Corner

Mount

Wiring Knockouts

POWER

12VDC

10mA

ALARM

16VDC

90mA

TAMPER

30VDC

0.5A

❺Configure the sensor sensitivity.

• Configure the IS-215T for the sensitivity best

suited to the application.

OFF

SENSITIVITY SWITCH SW2 POSITION

High (pulse count 1)

Low [Normal] (pulse count 2)

❻Walk-test the sensor.

High Sensitivity: 2-4 Steps

(Pulse Count 1)

Switch

• Use a small screwdriver to

push in the housing latch

at the bottom of the sensor,

and gently pull apart the

housings.

Alarm

LED

Low [Normal] Sensitivity: 3-5 Steps

(Pulse Count 2)

IS-215T Passive Infrared Motion Sensor Product Information

ALARM LED DISABLE

After walk-testing the sensor, disable the alarm

LED by turning Switch S1 to the OFF position.

SPECIFICATIONS

Range:

12 m x 12 m

40' x 40'

Power requirements:

10 - 14 VDC, w/LED - Alarm:

10mA max.; w/o LED - Alarm:

7mA max.; 12 VDC

3V peak-to-peak at nominal

12 VDC

Alarm relay:

Form A SPST,

90 mA, 16 VDC,

15 Ohm protective resistor

Tamper switch

Closed with cover in place

0.5 A, 30 VDC

RFI immunity:

30 V/m

10 MHz - 1000 MHz

PIR White light immunity:

6,500 Lux

PIR sensitivity:

Switch selectable

low [normal] (pulse count 2)

3-5 steps

high (pulse count 1) 2-4 steps

PIR fields of view:

dual element,

44 long range zones

14 intermediate, 8 lower,

4 look-down

Operating temperature:

-10oC to +55oC (14° F to 131° F)

Relative humidity:

5% to 95% noncondensing

Dimensions:

8.57 cm x 6.03 cm x 3.81 cm

(3-3/8" H x 2-3/8" W x 1-1/2" D)

Weight:

66.62 g (2.35 oz)

Packaged Product is 92.14 g

(3.25 oz)

Approvals/listings:

cULus

C-Tick

EN 50131-1

Security Grade 2

Environmental Class II

Important: For UL Certificated installations, the IS215T must

be connected to a UL listed power supply or UL listed control

unit capable of providing a minimum of four hours of standby

power.

Suitable for connection to an EN 60950 Class II Limited Power

Source.

TOP VIEW

Wide Angle Lens

DETECTION PATTERNS

SIDE VIEW

Wide Angle Lens

5-051-680-40 Rev C

Autres manuels Honeywell Capteur de sécurité

Honeywell

Honeywell C7076D1027/U Manuel utilisateur

Honeywell

Honeywell Miller Manuel utilisateur

Honeywell

Honeywell Vitoject 890 Manuel utilisateur

Honeywell

Honeywell C7961E Manuel d'utilisation

Honeywell

Honeywell Ex-Or LS3043DR Manuel utilisateur

Honeywell

Honeywell krom schroder DGS Manuel utilisateur

Honeywell

Honeywell Fire-Lite Alarms SD365T Manuel utilisateur

Honeywell

Honeywell ADEMCO 5821 Manuel utilisateur

Honeywell

Honeywell SC100 Manuel utilisateur

Honeywell

Honeywell CLLRF2OCR2BP Manuel utilisateur

Honeywell

Honeywell NFPA 1951 Manuel du propriétaire

Honeywell

Honeywell C7061A1020 Manuel utilisateur

Honeywell

Honeywell Sensepoint XCD Manuel utilisateur

Honeywell

Honeywell Miller DuraHoist Manuel de l'opérateur

Honeywell

Honeywell Ex-Or MLS2000DF Manuel d'installation et d'exploitation

Honeywell

Honeywell Lyric YCHW4000W4004 Guide d'installation

Honeywell

Honeywell FG8M Manuel utilisateur

Honeywell

Honeywell C7024E Manuel utilisateur

Honeywell

Honeywell IRV800M Manuel utilisateur

Honeywell

Honeywell Friedland FGGA08 Series Manuel utilisateur

Honeywell

Honeywell IS2535T Manuel utilisateur

Honeywell

Honeywell FSL100-IR3 Note de version

Honeywell

Honeywell Satronic IRD 1020 Manuel utilisateur

Honeywell

Honeywell Lyric W1 Manuel utilisateur

Manuels Capteur de sécurité populaires d'autres marques

THORLABS

THORLABS PDA10JT Manuel utilisateur

Waeco

Waeco UV-DETECT Manuel utilisateur

Intermatic

Intermatic IOS-DSIMF Manuel utilisateur

urmet domus

urmet domus 1083 Manuel utilisateur

Siemens

Siemens AZL66 Series Manuel utilisateur

BTI

BTI Profiline Multi Finder Manuel utilisateur

Challenger

Challenger SL01 Manuel utilisateur

DMP Electronics

DMP Electronics 1122INT Manuel utilisateur

Rielta

Rielta Ladoga MK-RK Manuel utilisateur

Mirion Technologies

Mirion Technologies ACCURAD PRD Manuel utilisateur

Bosch

Bosch DS835 Manuel utilisateur

DBI SALA

DBI SALA EZ Stop Manuel de l'opérateur

Lamptime

Lamptime ST05C Manuel utilisateur

Ubiquiti

Ubiquiti MFI-MSC Manuel utilisateur

Subsite

Subsite 910R Instructions d'installation

Satel

Satel OPAL Pro Manuel utilisateur

Aleph

Aleph XC-1XTEU Manuel utilisateur

Pima

Pima LARIS QUAD Manuel utilisateur