12. Find a safe and open area.
2.Charge fl ight battery.
3.Read this instruction manual thoroughly.
4.Fully assemble model.
5.Install the flight battery in the aircraft ( once it has been fully charged ).
6.Bind aircraft to your transmitter.
7.Make sure linkages move freely.
9.Perform the Control Direction Test with the transmitter.
10. Adjust light controls and transmitter.
11. Perform a radio system Range Check.
1. Remove and inspect contents.
8. Make sure the rubber ring has been properly slide on the clevis.
First Flight Preparation
Take off and landing tips
1. Take off using full power, as soon as you have taken off retract the landing gear.
2. Use the flaps to give a steeper landing approach, increase throttle slightly to offset the
increased drag.
3. Ensure that you set a timer and land with plenty of battery power in reserve.
4. It's difficult to landing the plane perfect from the speedy flying state when the flaps
keep in the contour.
5. Never exceed 3 minutes to fly with the maximum power others.
6. Never exceed the limited flying weight.
Please read the following instructions and fully understand it.
3. Children under the age of 12 should have an adult guide. Never recommend for the children
under the age of 14.
4. Never leave the charger in wet conditions.
1. Do not fly in strong wind or bad weather.
2. Never fly the model in crowded areas, where there are lots of people, automoblies on the
road or power lines overhead . Also do not to fly around the airport. Please make yourself
enough room for the flying and operating, as the plane can travel at high speed. Remember
you are responsible for the safety of others.
9
Flying Tips
5. The is made from PA and polythene which are tinder. When it meets the heat,
transfiguration can easily happen, so you must keep it away from heat.
ME-163
6. Do not attempt to catch the while flying, please do not touch the propeller.ME-163
7. Never leave this system unattended around children with battery in the unit, as injury may
be caused due to children's turning on the transmitter or the plane.
8. During the preparation for the flight, please remember to turn on the transmitter before
connecting the battery pack.
9. Close the throttle on the transmitter before connecting battery otherwise the motor may operate.
