Two times independent channels
Two for the normal channel,
Two for the bright channel
This amp has a specially designed
linked input system, where the volume
of each channel can be blended/altered
to suit different musical styles. (E.g.
allowing for a brighter sound without
losing lower frequencies etc.)
The standby switch is used when
turning the amp on and off. In
order to heat and also protect the
valves to operate the amplifier
you should leave the standby off
for at least 2 minutes.
The Presence dial is like the Treble
dial but on a higher frequency.
Controlling this dial would enable
you to boost the upper mid-range
frequencies. Refer to the graphs for
more detailed information on
The Bass dial is for enhancing
the bass given out from the amp
And manipulating the lower
frequencies, refer to the graphs
for more detailed information
on frequencies
The Middle dial is for controlling
the middle frequency’s given
sound. Refer to the graphs for
more detailed information on
frequencies
The normal volume dial is to control
the volume given out from the
normal inputs.
The Master Volume controls the
overall volume of the amplifier. If
the master is turned all of the way
down, no sound will come out of
the amplifier. You should always
have the volume on zero when
turning on or off the amplifier.
The Mains Switch is used to turn
the amplifier on/off.
Please note, the mains switch
works in conjunction with the
standby switch and the amplifier
will not work without also using
the standby switch.
The Treble dial is for increasing
the treble given out from the amp
To manipulate the higher
frequencies, refer to the graphs
for more detailed information on
The bright volume dial is to control
the volume given out from the bright
inputs.
