Hitachi S211 Manuel utilisateur

MN1-5843 Rev. 5

S211 Probe

Instruction Manual

Specication

MN1-5843 Rev. 5

Notes for operators and responsible maintenance personnel

★

Please read through this Instruction Manual as well as the separate Instruction

Manual “Safety (MN1-5980)” and “Cleaning, Disinfection and Sterilization

(MN1-5998)“ carefully prior to use.

★

Keep this Instruction Manual together with the ultrasound diagnostic instru-

ment for any future reference.

MN1-5843 Rev. 5Q1E-EP1475-

MN1-5843 Rev. 5

iii

MN1-5843 Rev. 5

Introduction

This is the instruction manual for S211 probe. The probe is available by connecting to Hitachi's ultrasound diagnostic

instrument and can be mainly used for observation of cardiovascular.

Prior to use, read this manual as well as the separate instruction manual “Safety” in which information for safe use is

provided.

The probe bears the CE mark but the mark is valid only when the probe is connected to the ultrasound diagnostic

instrument bearing the CE mark.

Symbols used in this document

Safety information is classied into Danger, Warning, Caution, and Note according to the level of hazard. Those terms

are used in safety information provided to prevent hazards and injuries to the operator or patient.

Danger

Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury to the

operator or patient.

Warning

Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury to the

operator or patient.

Caution

Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury to

the operator or patient, or property damage only.

Note

Indicates a strong request concerning an item that must be observed in order to prevent damage or

deterioration of the equipment and also to ensure that it is used efciently.

The type of safety information is indicated by the symbols below.

This symbol means that attention is required.

This symbol means that the described action is prohibited.

This symbol means that the described action is mandatory.

MN1-5843 Rev. 5

CONTENTS

1. General Information...................................................................................................................................1

1-1. Intended use...................................................................................................................................................................1

1-2. Classication of ME equipment....................................................................................................................................1

1-3. Standard components ....................................................................................................................................................1

2. Specications and Parts name....................................................................................................................3

2-1. Specications.................................................................................................................................................................3

2-2. Name of each parts........................................................................................................................................................4

3. Preparations before use .............................................................................................................................5

3-1. Visual check ..................................................................................................................................................................5

3-2. Conrmation of cleaning, disinfection, and sterilization.............................................................................................5

3-3. Operation check.............................................................................................................................................................5

4. Operation....................................................................................................................................................7

This instruction manual contains 4 pages of front matter and 8 pages of the main content.

-1-

MN1-5843 Rev. 5

1. General Information

General information for the probe is provided below.

1-1. Intended use

This probe is intended to be used by doctors or other qualified operators. The probe is placed on the body for

observation of surrounding organs.

Please refer to the ultrasound diagnostic instrument instruction manual used with this probe for the probe intended use

information.

Regarding with the connectable instrument, please refer to section 2-1. Specications of this manual.

Warning

Do not use this equipment for other than its intended use.

Otherwise it could cause burns or other injuries to the operator or the patient.

1-2. Classication of ME equipment

This probe is classied as follows according to IEC60601-1.

Please refer to the section 2-1 for the applied part, the part treated as the applied part, and the range of IPX7.

• Classication based on the degree of protection against electric shock ........ Type BF applied part

• Classication for protection against ingress of liquids .................................. IPX7 (Watertight equipment)

• Operation mode............................................................................................... Continuous operation

• Method of sterilization.................................................................................... Refer to the separate instruction manual

“Cleaning, Disinfection and Sterilization”

1-3. Standard components

The standard components of S211 probe are as follows.

S211 Probe ···························································· 1 set

Storage case ··························································· 1 set

Instruction Manual

• Specication (MN1-5843)········································ 1 copy

• Safety (MN1-5980)················································ 1 copy

• Cleaning, Disinfection and Sterilization (MN1-5998) ······ 1 copy

-2-

MN1-5843 Rev. 5

-3-

MN1-5843 Rev. 5

2. Specications and Parts name

The specications and the name of each part are provided below.

2-1. Specications

Application: Cardiovascular

Type of patient contact: Surface

Connectable instruments: ARIETTA 60, Noblus, ARIETTA Prologue

NOTE:

At the time of publication of this manual, the connectable diagnostic

ultrasound instrument or instrument software version available with this

probe is different for each country, please refer to the instrument instruction

manual or contact your local Hitachi representative.

Field of view: 90°

Frequency: 3.0 MHz

Cable length: 2.2 m

Service life: 3 years

Applied part: Probe tip including ultrasonic radiation part, see the section 2-2

Part treated as Applied part: Cable up to 1 m length from the probe tip

IPX7 range: See Figure 1

Measurement accuracy: Refer to the instruction manual of the ultrasound diagnostic instrument

External dimensions: See Figure 1

Remark: The tolerance for the dimensions is ±10%.

Figure 1 External View

Unit: mm

 





Cable length

IPX7 range



-4-

MN1-5843 Rev. 5

2-2. Name of each parts

The name of each part is shown in Figure 2 and the explanation for each part is listed in Table 1.

Orientation mark

Connector

Ultrasonic radiation part

Cable

Probe tip

Figure 2 Name of each parts

Table 1 Name of each part and its explanation

Name Explanation

Ultrasonic radiation part Ultrasound is radiated from this part. The electronic

sector transducer is integrated underneath this part.

Orientation mark The side of the orientation mark corresponds to the side

of the orientation mark on the image.

Probe tip This part is gripped during operation.

Cable Cable transfers electric input/output signals.

Connector The connector is the part which is connected to the

ultrasound diagnostic instrument.

Caution

Do not pull, bend, twist, or apply excessive force to the cable.

The probe may malfunction due to cable disconnection.

Do not subject the ultrasonic radiation part to hard impact.

The impact may cause damage to the transducer, and that results in noise or no echo in the image.

In most cases, the ultrasonic radiation part itself is not damaged because the part is made of elastic

material.

-5-

MN1-5843 Rev. 5

3. Preparations before use

This chapter describes preparations needed to use the probe safely. Please prepare the probe prior to each use by

following the instructions below.

3-1. Visual check

Visually check the probe tip, ultrasonic radiation part, cable, and connector.

If any holes, indentations, abrasion, cracks, deformation, looseness, discoloration, or other abnormalities are found, do

not use the probe.

3-2. Conrmation of cleaning, disinfection, and sterilization

Conrm that the probe is certainly cleaned, disinfected, and sterilized. The degree of reprocessing depends on the

intended use. Please refer to the separate instruction manual “Cleaning, Disinfection and Sterilization“ for cleaning,

disinfection, and sterilization procedure.

3-3. Operation check

Connect the probe to the ultrasound diagnostic instrument and check that the displayed scan type and frequency

correspond to those of the probe. Check also that there is no abnormality in the image.

Remark: Please refer to the documentation supplied with the ultrasound diagnostic instrument for how to connect the

probe and information displayed on the monitor.

If the probe is operated in still air, brightness on the top of the image may be non uniform, but this does not

affect the performance of the probe.

Warning

Make preparations prior to each use.

The operator and the patient may be injured if the equipment has any abnormality.

If any abnormality is found in the equipment, stop using it and contact our ofce written on the back

cover.

Caution

Do not use the probe if the displayed scan type and frequency do not correspond to those of the probe.

Incorrect acoustic output can result in burns or other injuries to the patient. Contact our ofce written

on the back cover.

-6-

MN1-5843 Rev. 5

Table des matières

Autres manuels Hitachi Équipement médical

Hitachi

Hitachi EUP-B512 Manuel utilisateur

Hitachi

Hitachi VC35 Probe Manuel utilisateur

Hitachi

Hitachi VC34A Probe Manuel utilisateur

Hitachi

Hitachi C42T Manuel utilisateur

Hitachi

Hitachi L441 Manuel utilisateur

Hitachi

Hitachi C41RP Manuel utilisateur

Hitachi

Hitachi EUP-OL334 Manuel utilisateur

Hitachi

Hitachi EUP-C715 Manuel utilisateur

Hitachi

Hitachi CC41R1 Manuel utilisateur

Hitachi

Hitachi S12 Manuel utilisateur

Hitachi

Hitachi UST-5417 Manuel utilisateur

Hitachi

Hitachi S31KP Manuel utilisateur

Hitachi

Hitachi EUP-CC531S Manuel utilisateur

Hitachi

Hitachi AP 720S Manuel utilisateur

Hitachi

Hitachi EUP-L65 Manuel utilisateur

Hitachi

Hitachi EUP-VV531 Manuel utilisateur

Hitachi

Hitachi UST-9135P Manuel utilisateur

Hitachi

Hitachi UST-5710-7.5 Manuel utilisateur

Hitachi

Hitachi EUP B715 Manuel utilisateur

Hitachi

Hitachi SCENARIA Manuel utilisateur

Hitachi

Hitachi L43K Manuel utilisateur

Hitachi

Hitachi EUP-L73S Manuel utilisateur

Hitachi

Hitachi UST-5412 Manuel utilisateur

Hitachi

Hitachi UST-9124 Manuel utilisateur

Manuels Équipement médical populaires d'autres marques

TekTone

TekTone Tek-CARE160 Manuel utilisateur

NeuroMetrix

NeuroMetrix Quell 2.0 Manuel utilisateur

AMT

AMT XLR8 Manuel utilisateur

Medipost-Nutristoma

Medipost-Nutristoma MD300K2 Manuel utilisateur

EDAN

EDAN SONOTRAX Pro Manuel utilisateur

Restorative Therapies

Restorative Therapies RT300 Manuel utilisateur

Gendex

Gendex Expert DC Manuel utilisateur

Dexcowin

Dexcowin ADX4000W Manuel utilisateur

Libelium

Libelium MySignals Manuel utilisateur

Acelity

Acelity V.A.C.ULTA 4 Manuel utilisateur

Caputron

Caputron ActivaDose II tDCS Manuel utilisateur

FujiFilm

FujiFilm Sonart Manuel du propriétaire

Plinth 2000

Plinth 2000 93CDT Manuel utilisateur

GE SENOGRAPHE 800T Manuel utilisateur

GE Definium 5000 Manuel utilisateur

Kanmed

Kanmed GE-1380 Manuel utilisateur

Huntleigh

Huntleigh FD1 Manuel utilisateur

Stryker

Stryker SPR Plus Manuel utilisateur