When storing this heater, be sure that you store
it in a dry place indoors instead of in a hot and
humid environment.
(Otherwise, it gets rusty or goes into trouble.)
You must take the plug out of the outlet if
there is a flash of lightening or thunder or if
you haven't used it for a long time.
(Otherwise, it is exposed to the danger of electrical shock, a
short circuit, or a fire.)
Do not put an excessive physical shock on
the remote controller, and do not disassem-
ble it arbitrarily.
Call your local after-sales service agent in
case the power cord is damaged.
(Otherwise, it is exposed to the danger of electric shock, a
short circuit, or a fire.)
Do not put this heater on an unstable surface of
the ground, such as an inclined or bumpy
surface.
(The heater may not work.)
Do not shower water on the heater directly, nor
use benzene, thinner, or alcohol for cleaning.
(Otherwise, it is exposed to the danger of electrical shock, a
short circuit, or a fire.)
If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent,
or a similarly qualified person in order to avoid a
hazard.
(Otherwise, it is exposed to the danger of electrical shock, a
short circuit, or a fire.)
Do not operate this heater in a place where it
gets wet from the humidity, such as a bathroom.
(It may cause an electrical short circuit or an electrical shock
accident.)
1. Make sure the safety in the place where you
wish to use this heater ensured.
■ The ground surface and surrounding area should
be plain, non-flammable, and solid.
■You need to have sufficient space surrounding
the heater, at least 15cm from the wall and the left
and right sides, and at least 1 meter from the
ceiling and the front side, without any obstacles.
■ You need to use an exhaust duct when operating
in small spaces.
(Recommended duct specification: 75mm or more
(diameter)
(Be sure there are no raindrops entering the
exhaust duct end.)
(You must ventilate frequently with fresh air by
opening a window or fan.)
■ You must put an extinguisher beside the heater.
■There must not be direct sunlight or excessive
heat near the heater.
■ After you fix the installation, lock the caster to
avoid unexpected movement.
■ Do not use this heater near a fabric, carpet, plastic,
or vinyl curtain that may cover the heater in case of
falling down, but in the wind or by any physical force
that may cause a fire.
■ The heater must not be located immediately below
a socket outlet.
■ Positioned so that the plug is accessible.
2. You must use diesel or kerosene as fuel.
If you use other fuel, it may cause excessive soot or
malfunction.
■ In the case of refueling, make sure the heater is
turned off.
■ To be made by the manufacturer or his service
agent, who should be contacted if there is an oil
leakage.
■Regulations concerning the disposal of oil when
scraping the appliance have to be followed.
3. The proper electricity is 220/230V, 50 Hz. It will be
applied and adjusted as per the customer's request.
You must supply power as per its requirements only
once they are adjusted.
- 5 -
