HIGH FORMAT KODAH Manuel utilisateur
QUICK INSTALL GUIDE
KODAH® FIRE PIT
Your safety is important to us. When appropriate, please follow OSHA guidelines and utilize safety
toe boots, hard hats and gloves, as well as eye, ear, and respiratory protection.
For more detailed information on the Kodah® Fire Pit, visit our Technical Guide at www.highformat.
com or contact HIGH FORMAT® technical support.
Required:
·Level
·Tape Measure
TOOLS AND SUPPLIES
INSTALLATION TIPS
HIGHFORMAT.COM
(877) 777-6558
• Patio Top Installation: Fire pits should never be installed atop a patio surface. Rather, the re
pit should be “cut in” to the patio surface to avoid damage to the patio.
• Base Preparation: Build re pit, on level ground, as shown in the assembly detail.
• Check Squareness: After completing the rst layer of block, check squareness by measuring
the diagonals with a tape measure. Adjust block as necessary.
• Block Pattern: Alternate block direction with each layer. Place the square liner into the
completed assembly.
• Steel Liner Alignment: In the completed installation, the steel liner should rest evenly on the top
layer of block.
INSTALLATION NOTES
1. Familiarize yourself with the construction details shown on this page.
2. Mark out the location for your re pit. Note dimensions shown are nominal so mark an area
slightly larger than shown.
3. Excavate for drain stone base (approx. 6”)
4. Fill excavated area with drain stone, level, and compact.
5. Place blocks according to the installation detail (measure across the diagonals to ensure
squareness)
6. Once all blocks are laid out, place the steel liner into the center opening. It will rest atop the
blocks.
7. Fill the the repit opening with additional drainstone 1” above the bottom of the liner to secure
it into place.
8. WARNING! Do not place the re pit directly atop a patio surface. Instead, the re pit should be
“cut in” to the patio surface to avoid damage to the patio caused by conductive heat transfer.
Gas conversion kits are available.
HIGHFORMAT.COM
(877) 777-6558
KODAH® FIRE PIT DETAILS
INSTALLED PLAN VIEW
Finished
Dimensions: 51”L X 51”W X 12”H
TYPICAL INSTALLATION
A.
B.
C.
Kodah® Wall Blocks (overlap at corners as shown, and abut matching
block tapers)
12-gauge steel ring (28”x28” opening), 12” tall, hangs directly on blocks
6” minimum drainstone base underneith
A
B
C
Table des matières
Autres manuels HIGH FORMAT Cheminée extérieure
