Web-Based Access Control Solution
ACW2-XN
4 Installation Preparation
System Requirements
•Compatible browser (See details on page 14)
•Access to a mains power outlet.
•Access to an Ethernet Network point or a router/switch that will allow network connectivity.
•In the absence of any network, HID Access Manager can be set up and administered by
connecting a desktop/laptop PC directly to the Controller Module with an (uncrossed) network
cable.
Suggested Tools
•Electric drill
•Drill bits (Masonry / steel – to suite the site wall materials)
•Screwdriver, small, flat
•Wire strippers
•Side cutters
•Site plan (to lay out door and reader locations)
Additional Hardware
•Electric strike locks and/or mag locks
•Power supply with sufficient capacity to power the locks (see calculations on page 19)
•Push buttons for Request-to-Exit (REX)
•Door Position Sensor (DPS) switches (if not built into the locks)
•Mains power cable with a plug on one end
•Cable for Wiegand Readers, sufficient for the site (measure the site)
•Cable for Door Position Sensor and Request-to-Exit, sufficient for the site (measure the site)
