–Do not connect this product to any power supply outside the power supply voltage and
frequency range indicated on the main unit and in this User’s Manual. Otherwise, this
product may be damaged.
–Do not place anything on the controller or block the air vents around this product to
prevent the occurrence of burns due to overheating.
–When handling the LED head, do not touch the lens or LED with bare hands. If a
foreign substance adheres to the lens or LED, it can cause the UV intensity to
decrease and the curing performance to degrade. If contaminations are applied to the
lens or LED, wipe it clean with alcohol and a lint-free cloth.
–Be careful not to drop or apply shock to the LED head. Doing so may damage this
product.
–Do not repeatedly bend the connection cables of the LED head, as this may result in
breakage. If any part of the LED head is broken, the whole LED head must be
replaced.
–Set the rubber feet of this product on a flat horizontal surface. Do not tilt this product or
put it on its side or upside down during use. The product may overheat and be
damaged.
–Do not use any other cable than the supplied connection cable to connect the LED
head to the controller.
–Ensure that the connection cable approx. 80 mm from the connector is kept free from
flexing stress and the joint between the connector and the cable is kept free from
tension. Otherwise, the cable may be broken.
–If the connection cable is longer than 2 m, or if the product is installed inside a larger
equipment, set up a display near the LED head so that the “LED radiation warning” can
be seen immediately. If you use OUTPUT terminals “+5V” (23) and “COM” (24) at the
rear of the controller, these will output a signal when the power is switched ON.
–Never connect any LED head, connection cable, AC adapter, or UV sensor to the main
unit, other than those designated by Henkel. Otherwise, any failure, loss, or damage
that may occur will not be covered under warranty.
–Never try to disassemble or modify the product, or to alter its internal settings. Any
failure or damage that occurs after disassembling or modifying the product will not be
covered under warranty.
