Helvei Smartmove Longboard Manuel utilisateur
EN
2
Before you get started, please make sure to
read the User Manual. It is highly recommended
to start your rst skateboard experience with a
friend. Having a spotter during initial use will in-
crease your condence and help you become
acclimated to your skateboard. Always wear the
proper safety gear before operating.
ENJOY YOUR SKATEBOARD!
PLEASE NOTICE:
The motorized skateboard is an Intelligent Per-
sonal Mobility Device. Before riding, please read
the User Manual carefully, and follow all Safety
Precautions.
Improper use of this product can lead to property
damage, serious bodily injury, and/or death.
The information in this User Manual will help
you better understand, enjoy and maintain your
skateboard.
For more information or questions regarding the
skateboard, please contact your local dealer.
WARNING!
IMPROPER USE OF THE SKATEBOARD AND/OR FAILURE TO READ THIS INSTRUC-
TION MANUAL MAY CAUSE SERIOUS BODILY INJURY AND DEATH!
EN
3
PREPARATION
Wear Safety Gear
Always wear proper protective gear such as: ap-
proved safety helmet, elbow pads and knees,
long sleeved shirt and pants, gloves, and lace
up shoes with rubber soles.
CHECK THE HARDWARE
Wheels: Inspect the wheels for excess wear
and replace if necessary.
Battery: Always make sure the power is in the
“o” position whenever the skateboard is not in
use. Never store the product in freezing or below
freezing temperatures. Those low temperatures
will permanently damage the battery.
Remote Controller: Check if the remote needs
charging.
CODE-MATCHING FOR INITIAL USE
The skateboard is controlled by remote con-
trol, which is wireless connected to the skate-
board. At the initial user of the skateboard,
code-matching between remote controller and
skateboard need to be completed. The connec-
tion will be automatically completed after initial
code-matching. New code-match need to be
executed when new remote controller or new
skateboard is used. .
CODE MATCHING:
Power o both skateboard and remote control-
ler, press ON-OFF switch both for 5 seconds
in the meantime. Beep of the remote controller
after the 5 seconds indicates the start of code-
matching, and another beep later for successful
code-matching. Restart remote controller and
skateboard and play.
EN
4
1. Button 2. Stick 3. Low speed indicator light 4. High speed indicator light
5, 6, 7 Battery indicator light 8. Charging port
EN
5
USE OF REMOTE CONTROL TO DRIVER
SKATEBOARD
1. POWER ON: Press POWER button 3 sec-
onds to start remote controller, and press POW-
ER button on skateboard to start skateboard;
2. CODE MATCHING: Match code and make
sure remote controller is connected with skate-
board;
3. SPEED MODE SELECT: Power OFF then
power ON, press Button n.1 shortly to select the
speed mode you prefer in LED indicator n.3 and
n.4: button n.3 in green stands for LOW SPEED
mode, which is good for beginner; button n.3 in
red stands for HIGH SPEED mode, which can
be selected by experienced user.
It is highly recommended for beginner to use
LOW SPEED mode only for safety.
4. SPEED CONTROL: Push driving stick n.2 for-
ward to drive forward, push driving sticker n.2
backward to brake skateboard, leave stick n.2
without push will get the skateboard slowing
down slowly at a controllable speed. Push driv-
ing stick n.2 forward to the end will help to accel-
erate fast, loosen driving stick n.2 backward will
reduce speed, push driving stick n.2 backward
to the end will brake the skateboard. Please try
to avoid urgent brake to avoid accident.
5. Direction shift: The skateboard is designed
with dual direction mode. In working status,
press power button n.1 shortly to shift in dier-
ent driving direction, one press stands for one
direction shift.
6. LED indicator Indicators n. 5. 6. 7. give battery
capacity indication to the skateboard. Indicator
n. 5. 6. 7. all on stands for full battery capacity,
indicator n. 6. 7. stands for half battery capacity,
indicator n. 7. stands for low battery capacity be-
low 30%. Indicator n. 7. ashing stands for low
battery of the skateboard. Indicator n. 7. slow
shine (slowly shines and slowly fades) stands
EN
6
for low battery capacity of remote controller.
7. Charging Connect micro USB charging cable
to the USB charging port n.8., connect USB
head to a USB charger to make charging to re-
mote controller.
BATTERY CHARGING
Please use original power adapter to charge
the skateboard.
● Skateboard: Insert charger head into charg-
ing port. It is fully charged when the indicator of
charger turn from red to green after generally 3
to 4 hours.
● Remote Controller: connect micro USB charg-
ing cable with remote control, powered by a
normal USB charger. It generally takes 2 hours
to complete charging. During charging, indica-
tor n.3. 4. 5. 6. 7. indicate battery capacity of
skateboard. It is fully charged when indicator
n.3 keeps ON while indicator n. 4. 5. 6. 7. are
OFF..
Please pay attention to follow instruction for
charging:
● Charging environment should be kept as clean
and dry.
● DO NOT charge with a wet charging port.
● During charging, do NOT turn on the power to
driving.
● Please charge after power switch get turned
o.
● During charging, it is dangerous to perform
any operation for skateboard.
● Please only user the original charger to charge
skateboard.
● Please charge at least 10 hours at the rst
time.
● Fully charge skateboard every month if it is left
unused, to make sure battery is in good condi-
tion.
EN
7
IMPORTANT HINT:
It will help to increase battery life to charge bat-
tery when it is not in low level ONLY. Frequent
charging before battery come to low level will
help a lot for you to have a long-life battery of
better condition.
Please avoid to charge the skateboard ONLY
when it is in low power.
RIDING PREPARATION
Following preparation is needed before riding
the skateboard.
●Check if the remote controller and motor runs
well.
●Check if the battery capacity is enough or not.
●Inspect the wheels for excess wear and re-
place if necessary.
●Inspect the motor belt to see if it in good condi-
tion.
EN
8
Issue Possible Reasons Solution
Failed to starting up Battery runs out
Skateboard: Please charge
immediately. It generally takes
3 to 4 hours.
Remote controller : please
charge immediately. It
generally takes 2 hours
Cruise duration gets shorter Battery are not fully charged Please fully charge the battery.
It generally takes 3 to 4 hours
Battery doesn’t accept charge
Plug gets loosen Make sure power outlet is on
Socket is not available Check if the socket is available
Battery need to be replaced
The average of rechargeable
battery life is 1 to 2 years
depending on condition
and use. Replace only with
skateboard replacement
batteries
TROUBLE SHOOTING
EN
9
Skateboard doesn’t run
Indicator n. 3 or n. 4 ashing
on remote controller indicates
no connection to skateboard Restart skateboard
Indicator n.3 and n.4 ashing
on remote controller indicates
a fault in skateboard
Restart skateboard and
remote controller. If indicator
n.3 and n.4 still ash, please
turn o them and consult
dealer or manufacturer
Indicator on skateboard
ashing(not match code)
indicates a fault in skateboard
Please consult dealer or
manufacturer
A ashing indicator n.7
indicates a low battery
capacity Please charge immediately
When indicator n.7 shines like
a breathing light(slowly shines
and slowly fades), it indicates
a low battery capacity of
remote controller
Please charge immediately
EN
10
Auto power-o
Battery runs out Please charge immediately
It will auto power-o without
any operation on skateboard
and remote controller Start it up
SAFETY AND WARNING:
● At any time in driving, it is possible to lose bal-
ance and cause a collision or fall. You must learn
how to drive safely to avoid danger while driving.
● User need necessary protection and practice
to ride skateboard safely. Low speed is a must
for new user or beginner. High speed mode is
prohibited for any beginner to avoid injury.
● Skateboard is strictly prohibited to drive in mo-
tor vehicles driveway and the sidewalk.
● Skateboard is just for single person to drive. It
is strictly prohibited to be ride by more persons.
● Skateboard is for the groups more than 13
years old.
● It is strictly prohibited to drive in the dangerous
situation, such as ammable gas, vapour, liquid,
dust, ber and other reasons may cause re or
explosion.
● Please observe the local trac regulations
strictly to avoid violence to the local law.
● It is not a toy for children. It is not allowed to be
driven by children, the elder or low-driving-ability
person.
● Do not drive after alcohol or dose.
● Please drive on the at and open ground.
● Do not drive on pits, sand, gravel, mud, rug-
ged or ramp ground.
Table des matières
Langues :
