6Heatsail BEEM® with misting
EN
1. Safety regulations & requirements
The use of the misting system requires an an electrical outlet and a water
connection with tap. The electrical safety of the device is only assured if
it is correctly connected to a grounding system built in accordance with
safety regulations. It must be inspected before use. If anything is unclear,
a qualified and authorised person must be consulted. Heatsail is not
responsible for damage caused by an ungrounded device.
The installation of the misting system of the BEEM requires a mains
connection of 110-120V: the connection must be properly implemented in
accordance with the applicable IEC-CEI standards.
Please note: This product must by installed by a licensed electrician
and the power supply connection should be in accordance with the
requirements of NFPA 70 and OSHA Regulations 29 CFR 1910.304(b)(2)
Statutory and other local regulations may apply.
If the engine is defective and/or unsafe, switch o the machine and do not
let it run. Have the machine repaired or replaced.
2. Safety
The user should carefully read and understand this manual before any
installation and/or operation of the misting system. The user need to
follow the installation procedure, working procedure, safety measures and
maintenance as standard.
Use only clean water. It is forbidden to use spring water, river water, pond
water and other dirty water. Once dirty water has been used the nozzles
may block or it may cause blockage this can lead to a shortening of life
expectancy.
The misting system must be connected directly to a water tap. The misting
system has a self-priming function, prevent air from entering the machine.
The number and size of the nozzles must be within a related range.
Otherwise there will not be enough pressure for the misting. It is strictly
forbidden to touch machine, thread, machine valve and replace or touch
other related parts when the machine is turned on.
