4
Revised 2013
INSTALLING & ADJUSTING THE FILM AXLE
INSTALLING COMPLETE AXLE ASSEMBLY (625-A)
Position the complete axle assembly on the rear of the
wrapper with the removable end cap (1) on the left side and
the bearing blocks (2) on the outside of the sides of the
machine base (3) as shown in the drawing.
Fasten the bearing blocks to the sides of the machine base
with the four bolts (4), lock washers (5) and hex nuts (6)
provided in the bearing block set.
INSTALLING COMPLETE AXLE ASSEMBLY (825-A/875-A)
Position the complete axle assemblies between the side
plates of the wrapper with the removable end cap on the
left side and the bearing blocks and mounting brackets on
the inside of the plates.
Fasten bearing blocks, mounting bracket and axle to the
side plates with the fasteners provided in the bearing block
set
REMOVING THE AXLE
Remove the protective caps from the ends of both bolts
located in the slotted holes of the upper bearing blocks (7).
Remove the wing nuts on both bolts with the protective
caps removed and loosen the wing nuts on both bolts lo-
cated in the other holes of the upper bearing blocks.
Swing the upper bearing blocks toward the outside of the
machine base until the ends of the axle (8) are exposed.
Lift the axle out of the lower bearing blocks (9).
INSTALLING THE AXLE
Place the ends of axle into the grooves on lower bearing
blocks with the removable end cap positioned on the left
side as shown in the illustration.
Swing the upper bearing blocks toward the inside of the
machine base until they align with the lower bearing blocks.
Thread the wing nuts onto both of the bolts located in the
slotted holes of the upper bearing blocks and tighten all of
the wing nuts on all four of the bolts in the bearing block
assemblies.
Replace the protective caps on the ends of both bolts lo-
cated in the slotted holes of the upper bearing blocks.
CHANGING THE AXLE END CAP WIDTH
Pull pin (10) out of the outer flange of hub (11) until the end
of pin clears the inner flange of hub. Do not completely
remove the pin from the hub.
Slide the hub to the new position and align the hole on the
inner flange on hub with the nearest hole in the axle.
Push the pin completely through the inner flange of hub and
the axle until the top of the pin is flush with the outer flange
of hub.
