HYPERSPEC®INSPECTOR
2-8
Figure 2-2. SWIR Connected cHDPU.
(1) Remove the Inspector from the storage case and set it onto a secure work surface.
(2) Remove the cHDPU from its storage case and set it onto a secure work surface within a few feet of the Inspector.
(3) Remove the cables and power supply from the cases.
(4) Set up the keyboard, monitor and mouse in the work area.
(5) Connect the mouse and keyboard to the cHDPU through the USB ports on the back of the unit.
(6) Connect the monitor to the VGA port on the cHDPU.
(7) Connect the CameraLink cable to the Link 1, port A on the cHDPU. Connect the other end to the CameraLink
port A on the Inspector, shown in Figure 2-1. Secure both connectors with the thumbscrews.
(8) Connect the serial control cable to the Serial port on the cHDPU and the other end to the Camera Control port on
the cHDPU, shown in Figure 2-1. Secure both connectors with the thumbscrews.
(a) Alternatively, if applicable, connect the serial to USB cable’s serial connector to the serial cable, secure it
with thumbscrews and connect the USB connector to the cHDPU and then the serial connector to the Serial
Control port on the Inspector.
(9) Connect the power cable to the power brick and the connector end to the cHDPU. Secure the connector with the
locking ring.
(10)Locate Inspector to final operating position and ground device using one of the side metal brackets.
(11)Connect the power brick to the appropriate power source.
(12)Power ON the cHDPU with the switch. Power ON the monitor.
(13)Connect the thermo-electric cooler cable of the Inspector to the appropriate power source. The cooler will
immediately start.
