Page: 5 of 9
Setting the Memory Preset Buttons
设置记忆预设按钮
1. Pressing UP/DOWN button to the desired height,
then press “M” button , the display will change to “S”.
使用“上” 、“下”按钮将底座调整至所需高度，然
后按下“M”按钮，显示屏将变为“S”。
2.Then select and press one of the memory buttons”1”,
“2”, “3” or “4”.The position has been saved.
按下任一记忆按钮“1”、“2”、“3”、“4”。位置已保存。
3. Using the UP/DOWN buttons, move the base to the
next desired position and repeat the process to set
another desired height.
使用“上” 、“下”按钮将底座调整至下一个所需高
度，然后重复上述步骤，以设置新的所需高度。
HAT Elements
User Manual
升降桌用户手册
Setting the LED Retracted Height
(or known as Starting Height)
设置LED缩回高度（或“起始高度”）
Press the DOWN button on the Control Panel until
the base reaches its lowest position. Measure the
distance from floor to the top surface of the desktop.
If the number on the LED display does NOT match
your measurement, follow these steps:
按下控制面板上的向下按钮，将底座调整至最低位
置。测量地板至桌面距离。如果LED显示屏上的数字
与您的测量值不一致，请执行以下操作：
1. Press and hold the DOWN button until the LED
display reads "RST".
按住向下按钮，直到LED显示屏显示“RST”。
2. Press and hold the "M" button (about 5 seconds)
until the LED displays the flashing height. (If the
display returns to "RST" before the next step is
taken, repeat this step.)
按住“M”按钮（约5秒），直到LED闪烁高度显示。
（若执行下一步之前显示屏再次出现“RST”字样，
则重复此步骤。）
3. Use the UP/DOWN buttons to change the value
of the starting height so that it matches your
measurement.Wait about 5 seconds and the display
will return to “RST”.
根据您的测量值，使用“上”、“下”按钮调整起
始高度。然后等待约5秒，显示屏将再次出现“RST”
字样。
4. Finish the reset process by pressing and holding the
DOWN button again until the desk lowers a little bit
more, slightly rises and stops. Release the button.The
new starting height value is saved and your desk is now
ready to use.
按住向下按钮，完成设置过程，直到桌面稍微降低，
然后稍微上升并停止。松开按钮。新的起始高度已保
存，您现在可以正常使用办公桌。
Note: the LED display has a 0.1 tolerance.
备注：LED显示屏公差为0.1。
