Havis-Shields C-B1 Manuel utilisateur

INSTALL INSTRUCTIONS C-VS-1300-TBZ

VEHICLE SPECIFIC CONSOLE

2006-2008 CHEVROLET TRAILBLAZER

TOOLS REQUIRED:

 Phillips screwdriver

 T-15 Torx driver

 T-20 Torx driver

 7/16 wrench

 Ratchet wrench

 7/16” socket

 15mm socket

 Jig Saw or plastic cutting tool

 Eye goggles

HARDWARE:

QTY DESCRIPTION PART #

1 Trailblazer vehicle specific console C-VS-1300-TBZ-H

1 Bail bracket C-B1

1 Rear hump bracket set C-B27

1 Duct block off plate CM001516

2 Side “L” brackets CM93594

1 Console hardware kit C-HK

1 Torx screw kit C-HK-1

1 #10x1/2 PPHSMS (Block off plate screw) GSM33194

Always!

 Read all instructions before installing any Havis-Shields Equipment Corp products.

 Disconnect the vehicle battery. Removing seat bolts on some vehicles may give the vehicles

computer a false reading, causing a warning light on the instrument cluster. This requires the

vehicles’ computer to be reset with a vehicle diagnostics tool.

 Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!

 Use only hardware provided with install kit.

 For product support, visit the Install Instructions Section of our website at

http://havis.com/Installation/Installation.html, email [email protected] or call

1-800-524-9900 and ask for technical support.

C-VS-1300-TBZ_INST_9-07

Remove six phillips screws that hol

inner storage pocket. Remove

storage pocket and arm rest

assembly.

Remove main console screws.

Unplug wires for rear controls.

Remove shift lever “T” knob.

(T15 Torx)

Measure approximately 3 ½” back

from shift lever boot.

Mark Measurement with tape.

Position shift lever in drive or

further back. Remove entire

console assembly.

Note: In order to remove console,

you must reach up inside the shifter

boot and disconnect the traction

control plug.

Remove front trim to aid in running

additional wiring.

C-VS-1300-TBZ_INST_9-07

Extend cut line on console sides.

Carefully cut off back console

section. (Jig saw, Air saw, Dremel

or Air drill)

Carefully reinstall front console

section.

(Reattach Traction Control Plug)

Reattach shift lever “T” handle.

Remove inboard rear seat nuts.

(15mm) Place new rear hump

brackets on seat studs under seat

brackets.

Attach bail bracket onto rear hump

brackets with ¼ x ¾ bolts.

Note: You may need to bend hump

brackets slightly forward.

Place duct block off plate in duct

opening and screw down with #10 x

½” sheet metal screw.

Attach “L” mount brackets to new

console lower side tracks with ¼ x

½ bolts and washers.

**Leave loose to aid in

ositionin

Place new console between seats

and position “L” mount brackets

onto OEM bracket. Attach with

1/4” x 3/4” bolts.

Position console housing as desired

and tighten all mount hardware.

**Check shift lever in rear position.

C-VS-1300-TBZ_INST_9-07

Finish wiring and complete installation

Ce manuel convient aux modèles suivants

Autres manuels Havis-Shields Accessoires automobiles

Havis-Shields

Havis-Shields C-TCB-27 Manuel utilisateur

Havis-Shields

Havis-Shields C-VS-0812-CHGR Guide de configuration

Havis-Shields

Havis-Shields C-VS-1200-EXPD-1 Guide de configuration

Havis-Shields

Havis-Shields Flip Down Rear Step Option KK-ST-FLIP Guide de configuration

Havis-Shields

Havis-Shields KR-153X-SP-KOV Manuel utilisateur

Havis-Shields

Havis-Shields Kwik-Kit KK-100-03 Manuel utilisateur

Havis-Shields

Havis-Shields KK-K9-C14-K-32 Manuel utilisateur

Havis-Shields

Havis-Shields 1996-2006 Ford Taurus C-TCB-10 Guide de configuration

Havis-Shields

Havis-Shields Vehicle Specific Console C-VS-1100-F150 Guide de configuration

Havis-Shields

Havis-Shields 2002-2008 Ford Explorer C-TCB-26 Guide de configuration

Havis-Shields

Havis-Shields Heavy Duty Trak Mount 2006-2009 Chevrolet Impala... Guide de configuration

Havis-Shields

Havis-Shields KK-100-01 Manuel utilisateur

Havis-Shields

Havis-Shields Telescoping Computer Base C-TCB-34 Guide de configuration

Havis-Shields

Havis-Shields C-D2300-FL1 Manuel utilisateur

Havis-Shields

Havis-Shields 1996-2008 Crown Victoria Driver and Passenger - Trunk Side Mounts... Manuel utilisateur

Havis-Shields

Havis-Shields P-MFK-9 Manuel utilisateur

Havis-Shields

Havis-Shields KR-SB-800 Manuel utilisateur

Havis-Shields

Havis-Shields 2000-2005 Chevrolet Impala Trak-Mount Kit... Guide de configuration

Havis-Shields

Havis-Shields K9/Prisoner Transport Unit KK-K9-C20-K-PT Manuel utilisateur

Havis-Shields

Havis-Shields Four Compartment Prisoner Transport Insert... Manuel utilisateur

Havis-Shields

Havis-Shields Telescoping Computer Base C-TCB-12 Guide de configuration

Havis-Shields

Havis-Shields P-MFK-5 Guide de configuration

Havis-Shields

Havis-Shields Motorola MW800/MW810 CPU Trunk Mount 1995-2009 Ford Crown Victoria... Manuel utilisateur

Havis-Shields

Havis-Shields 1997-2007 Dodge Dakota Telescoping Computer Base... Guide de configuration

Manuels Accessoires automobiles populaires d'autres marques

James Baroud

James Baroud Odyssey Manuel utilisateur

Motorola

Motorola i50sx Manuel utilisateur

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manuel utilisateur

Feniex

Feniex T3 Manuel utilisateur

Renault

Renault 77 11 423 180 Manuel utilisateur

Kia

Kia E8300-4D000 Manuel utilisateur

Brink

Brink 756843 Manuel utilisateur

Whispbar

Whispbar K085W Manuel utilisateur

v.link

v.link CI-VL2-PC-HSD Manuel utilisateur

Viking

Viking Stack-Rack Guide de configuration rapide

Aries

Aries 203015 Manuel utilisateur

Choetech

Choetech AT0005 Manuel utilisateur

ZZ2

ZZ2 ZZAIR-PRO Manuel utilisateur

Holman

Holman 4A80L Manuel utilisateur

Thule

Thule 2075 Manuel utilisateur

Motorola

Motorola T325 Manuel utilisateur

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guide d'installation

DV8

DV8 FBJL-02 Manuel utilisateur