2 of 7 Form H-1305-TSB Rev 1
PDF 1-20
TSB 2013.07.001 : Changing Roller Arm Positions: “N-Series” Spring Reels
Figure 2 - Reel with Rollers in the “VR” Position
1. Remove spring per Hannay TSB
2013.06.003 Changing a Hannay Spring
Motor, this can be found at www.hannay.
com. The reel should look like Figure 1.
2. Make note of the spring bracket
mounting location, which will be moved
to the other side of the center hub.
3. Remove the 3/8” nuts and bolts holding
the spring mounting bracket and roller
arms to the frame.
4. Swing the Roller Bracket up to the VR
position (Figure 2), until the holes on
the bracket line up with the holes in the
frame. Replace and tighten the bolts.
5. Reposition the spring mounting bracket
as shown in Figure 2, using two 3/8”-16
x 0.75 spinlock bolts and two 3/8”-16
spinlock nuts. The reel should look like
Figure 2.
6. Remove the bottom bolts attaching the
roller assembly to the roller arms and
loosen the top bolts.
7. Rotate the roller assembly so that is it
pointed in the same direction as shown
in Figure 2.
8. Check that all bolts and nuts are tight.
9. Replace the spring per Hannay TSB
2013.06.003 Changing a Hannay Spring
Motor.
10. To go from a “VR” to an “SR” simply
reverse steps 1 – 9, discarding the bolts
and nuts from step 5.
Changing Roller Position from “SR” to “VR” with a “J, K, or M” Spring:
Figure 1 - Reel with Rollers in the “SR” Position
