Hachette ALIEN PACK 7 Manuel
spectacular
1:2
scale
ALIEN
BUILD THE
TERRIFYING
XENOMORPH
FROM
ALIEN
EASY
ASSEMBLY
PACK 7
KITS 45 - 52
Non contractual visual
Hachette Partworks Ltd, 4 t h F l o o r, J o r d a n H o u s e ,
47 Brunswick Place, London N1 6EB
www.hachettepartworks.com
© 2023/2024 Hachette Partworks Ltd.
© 2023 20th Century Studios.
ALL RIGHTS RESERVED
All parts belong to a kit. Collectors item for adults.
Not suitable for children under 14.
PACK 7 | BUILD INSTRUCTIONS
ALIEN
KIT 45
THE RIGHT HAND &
THE SKULL (II)
KIT 46
THE RIGHT HAND &
THE SKULL (III)
KIT 47
THE RIGHT ARM (I)
KIT 48
THE RIGHT ARM (II)
KIT 49
THE RIGHT ARM (III)
STEPS & TIPS ONLINE
KIT 50
THE RIGHT ARM (IV)
KIT 51
THE RIGHT ARM (V)
KIT 52
THE LEFT HAND (I)
WARNING: Some parts are assembled using magnets. These magnets can cause serious
injury if they are swallowed. Keep away from children. If you suspect a magnet has been
swallowed, seek medical help straight away.
Some parts may have sharp edges, please handle them with care.
The installation of electronic parts must always be carried out by an adult. When replacing batteries,
use the same type of batteries.
Please ensure that the battery compartment is securely fastened before you use the model.
Used batteries should be recycled.
Please make sure to check with your local council how batteries should be disposed of in your area.
Batteries can present a choking danger to small children and may cause serious harm if ingested.
Do not leave them lying around and keep any spare batteries locked away at all times.
PB 1
ASSEMBLY GUIDE
In this kit you will continue to assemble parts of the right hand and install
a second LED assembly in the Xenomorph’s skull.
KIT 45: THE RIGHT HAND
AND THE SKULL (II)
45-1
45-7 45-8 45-9
45-2
45-5 45-645-445-3
PARTS SUPPLIED
Ref. Name Qty.
45-1 Radius O uter S k in 1
45-2 Righ t-b ack Part of Hand 1
45-3 Righ t Finger R4 1
45-4 Righ t Finger R5 1
45-5 Righ t Finger R6 1
Ref. Name Qty.
45-6 Connector 1
45-7 S k ul l LE D B 1
45-8 M agnets 6
45-9 2.3x6mm screws (1 spare) 4
23
23
KIT 45: THE RIGHT HAND AND THE SKULL (II)
1
2
45-8
44-8
45-8
44-8
44-1
45-1
45-8
45-1
Glue the six Magnets 45-8
into the circular recesses
inside the Radius Outer
Skin 45-1. It doesn’t matter
which way round (polarity)
they are fitted at this stage.
Next, take the six magnets
44-8 and the radius 44-1
which were supplied with
pack 6 - kit 44. Fit the radius
44-1 into the Outer Skin 45-
1. Place the magnets 44-8
into the circular recesses in
radius 44-1 ensuring that
they are attracted to the
magnets positioned below
on Skin 45-1. When certain
of their orientation, glue the
magnets rmly in place. Put
the assembly aside until it is
needed in the next kit.
23
23
KIT 45: THE RIGHT HAND AND THE SKULL (II)
3
4
45-4 (R5)
45-2
45-5 (R6)
45-3 (R4)
45-2
Take the Hand 45-2 and
check the t of Right
Finger R5 45-4.Once
certain of a good t, glue
in place.
Repeat the previous step
to add Right Fingers R6
45-5 and R4 45-3. As
before, glue in place.
45
45
45-9
44-2
44-6
45-2
5
6.1 6.2
6
3-13
3-13
3-12
3-12
45-7
45-7
9V 6LR61
9V 6LR61
KIT 45: THE RIGHT HAND AND THE SKULL (II)
The two halves of the hand are now joined
together. Take the hand assembly 44-2
from pack 6 - kit 44 and t the connector
44-6 over the raised screw socket on
hand assembly 45-2. (The connector may
need to be temporarily loosened whilst
tting.) Fix in place with a 2.3x6mm screw
45-9 (inset above). Keep the assembly
and the Connector 45-6 supplied aside
until it is needed in the next kit.
Next, the Skull LED B 45-7 is
tested. Lay out the LED strip 45-7,
the circuit board 3-12, the battery
connector 3-13 and the 9V battery,
as shown in the diagram. Connect
the Skull LED B 45-7 to the lower
right hand socket and the battery
connector 3-13 to the left socket.
Then connect the battery to test the
LED strip. Once satised that the
LEDs work, disconnect the parts and
store safely.
45
45
KIT 45 IS COMPLETE
7
45-7
44-7
3-1
FURTHER WORK HAS BEEN DONE TO
THE RIGHT HAND, MAGNETS FITTED
TO THE RADIUS AND THE LED LIGHTS
CONTINUED ALONG THE SKULL.
KIT 45: THE RIGHT HAND AND THE SKULL (II)
Study the diagrams carefully
and note the position of the LED
Strip 45-7 in the centre of the
skull 3-1. The socket at one end
of Skull LED B 45-7 connects
to the plug on skull LED A 44-7
which was fitted in the previous
kit. Once certain of the fit, remove
the backing film from the adhesive
strip and secure the Skull LED B
strip 45-7 in place, as shown.
PB 1
ASSEMBLY GUIDE
In this kit you will continue to work on the right hand and radius, plus install
a third LED within the skull assembly.
KIT 46: THE RIGHT HAND
AND THE SKULL (III)
46-1 46-2
46-3
46-7 46-8 46-9 46-10
46-4 46-5 46-6
PARTS SUPPLIED
Ref. Name Qty.
46-1 Righ t Radius 1
46-2 Pal m of Righ t Hand 1
46-3 W rist J oint 1
46-4 Pipe B 1 1
46-5 Pipe B 2 1
Ref. Name Qty.
46-6 B rack et 1
46-7 Pin 1
46-8 S k ul l LE D C 1
46-9 M agnets 6
46-10 2.3x6mm screws (1 spare) 3
23
KIT 46: THE RIGHT HAND AND THE SKULL (III)
1
2
46-3
44-2
45-2
46-7
46-3
46-7
Insert the Pin 46-7
into the central hole
of the Wrist Joint
46-3.
Take the right hand assembly,
which was worked on in the
last kit and t the Wrist Joint
46-3 into the corresponding
slot in the wrist area. The slot
in the hand 44-2/45-2 will
need to be temporarily opened
slightly for the part to t, and
the ends of the Pin 46-7
should rest in recesses on the
hand parts 44-2 and 45-2.
See also the diagram in the
next step.
23
KIT 46: THE RIGHT HAND AND THE SKULL (III)
4
3
44-2
46-10
45-9
45-2
44-2
45-6
46-10
46-6
45-2
Orientate the Bracket 46-6, as
shown and t the screw holes
over the raised screw sockets
on parts 44-2 and 45-2.
When sure of a good t, secure
in place with two 2.3x6mm
screws 46-10.
Take the connector 45-6 and
two of the 2.3x6mm screws 45-9
which were supplied with the last
kit. Fit the connector 45-6 onto
the raised screw sockets in the
hand assembly 44-2/45-2 and
screw in place.
Table des matières
Autres manuels Hachette Jouet
Hachette
Hachette ALIEN spectacular Manuel utilisateur
Hachette
Hachette ALIEN spectacular Fiche d'information produit
Hachette
Hachette ALIEN XENOMORPH Manuel utilisateur
Hachette
Hachette PACK 3 Manuel
Hachette
Hachette ALIEN PACK 4 Manuel
Hachette
Hachette Agora Models BISMARCK Manuel
Hachette
Hachette AGORA BISMARCK THE LEGENDARY BATTLESHIP Manuel
Hachette
Hachette Agora Models BISMARCK Manuel
Hachette
Hachette ALIEN Manuel utilisateur
Hachette
Hachette Agora Bismarck Pack 04 Manuel
