Virtual Pilot Operating Handbook
`
GF-T8 GFT8 2
8-Toggle Switch/LED Panel
Cockpit Control System
Congratulations on your purchase of a
GoFlight GF-T8 (8-Toggle Switch/LED
Panel Module), part of the extensive
family of GoFlight GF Cockpit Control
System modules.
The GF-T8 is designed to operate with a
wide variety of simulated aircraft and is
sure to make your flight simulation experience more realistic and enjoyable.
The steps below will assist in ensuring the GF-T8 will be easy to install, configure and use. Following
these instructions will help to get you up in the “virtual skies”as quickly as possible.
NOTE If you own other GoFlight hardware and have already installed the most
current
version of software on your system, you do not need to install the software
again.
Simply skip the software installation steps in the instructions
below.
Installing a GF-T8 Module
1. Using a web browser go to www.goflightinc.com.
2. On the GoFlight home page click Support.
3. Click on “GF Config x.xx”to download the latest module drivers and configuration
software.
4. Click “Run” or “Save” and then follow the instructions to install the software.
If the software installer detects that GoFlight software is already installed on your system, it will
prompt you to overwrite. Click the Yes button to overwrite the existing version of GoFlight
software. This is useful if you wish to keep the configuration settings for other GoFlight
modules installed on your system. However, you should first make sure that the software you
are overwriting is an older version and not a newer one.
5. If you are going to mount the GF-T8 module into a GoFlight module rack, install the module in
any desired location in the rack using the two thumbscrews provided.
