Glancetron GT15-Wide Manuel utilisateur
Touch Screen LCD Monitors
USER’s GUIDE
Rev.A
Glancetron GT15-Wide
www.glancetron.com
The information contained in this document is subject to change without notice.
This document contains proprietary information that is protected by copyright. All rights
are reserved. No part of this document may be reproduced,translated to another language
or stored in a retrieval system, or transmitted by any means, electronic, mechanical,
photocopying, recording, or otherwise, without prior written permission. Windows is a registered
trademark of Microsoft, Inc. Other brand or product names are trademarks of their respective
holders.
The test results show that this device meets the FCC rules. Those limits are set to protect
residential areas from the devices with harmful emission. This device will produce, use and
radiate radio frequency energy. In addition, failure to follow the user’s manual to install or use
this device might produce harmful interference with radio communication. Not withstanding
the foregoing, it does not guarantee that this type of harmful interference does not occur in
some special installations. The interference caused by this device to the reception of radio
or television signals may be verified by turning it on and off. Any changes or modifications to
this TFT LCD would void the user’s authority to operate this device.
Important Recycle Instructions:
Lamp(s) inside this product contains mercury. This product may contain other
electronic waste that can be hazardous if not disposed of properly. Recycle or
dispose in accordance with local, state, or federal Laws. For more information,
contact the Electronic Industries Alliance at WWW.EIAE.ORG. For lamp specific
disposal information check WWW.LAMPRECYCLE.ORG.
Table of Contents
Usage Notice
Precautions............................................................................................................................. 1
Introduction
About Glancetron GT-15Wide ................................................................................................ 2
Touch Screen for Glancetron GT-15Wide .................................................................... 2
Package Overview ...................................................................................................... 3
Installation
Product Overview ........................................................................................................ 4
Front View.............................................................................................................. 4
Bottom View (Without Stand) ................................................................................. 4
Kensington Security Slot.............................................................................................. 5
VESA Mount Your Monitor ........................................................................................... 6
Start Your Installation .................................................................................................. 7
Remove the Deskstand................................................................................................ 8
Connecting the Display (Figure 10.1)........................................................................... 9
(Figure 10.1)..........................................................................................................10
User Controls
Front Panel Controls...................................................................................................11
How to Use the OSD Menus .......................................................................................12
On-Screen Display Menus ..........................................................................................13
Appendix
Troubleshooting..........................................................................................................14
Warning Signal ...........................................................................................................15
No Signal ....................................................................................................................15
Going to Sleep............................................................................................................15
Out of Range..............................................................................................................15
Product Dimensions ...................................................................................................16
Compatibility Modes ...................................................................................................17
Touch Screen Driver Installation .................................................................................18
Glancetron GT-15Wide Optional Calibration Tool Install: .............................................18
Glancetron GT-15Wide Install Instructions: ............................................................19-20
1
Usage Notice
! Warnin
g
- To prevent the risk o
f
fi
re or shock hazards, do not expose
this product to rain or moisture.
! Warnin
g
- Please do not open or disassemble the product as this ma
y
cause
e
l
ec
tri
c
s
h
oc
k.
Precautions
Follow all warnings, precautions and maintenance as recommended in this user’s manual to
maximize the life of your unit.
Do:
• Turn off the product before cleaning.
• Touch screen surface may be cleaned using a soft clean cloth moistened with
mild window glass commercial cleaners or 50/50 mixture of water and
isopropyl alcohol.
• Use a soft cloth moistened with mild detergent to clean the display housing.
• Use only high quality and safety approved DC adapter.
Don’t:
• Do not touch the LCD display screen surface with sharp or hard objects.
• Do not use abrasive cleaners, waxes or solvents for your cleaning.
• Do not operate the product under the following conditions:
- Extremely hot, cold or humid environment.
- Areas susceptible to excessive dust and dirt.
- Near any appliance generating a strong magnetic field.
- In direct sunlight.
Introduction
About Glancetron GT-15Wide
The Glancetron GT-15Wide is a 39.6cm (15.6”) flat panel screen with an active matrix,
thin-film transistor (TFT) liquid crystal display (LCD).
Features include:
• Direct analog signal input
• Active matrix TFT LCD technology
• 1366 x 768 WXGA resolution
• 39.6cm (15.6") viewable display area
• 31.47 ~ 60.02 KHz horizontal scan
• 56 ~ 75 Hz refresh rate
• 0.252mm x 0.252mm pixel pitch
• Auto adjustment function
• Multilingual OSD user control
• Kensington security slot
• 75 mm VESA mount
• Removable base for flexible mounting solutions
• Audio - 1W x 2
Touch Screen for Glancetron GT-15Wide
• 5-wire resistive touch screen for finger and stylus input
• Surface: Anti-glare treatment
• Interface: Combo RS-232 Serial/USB controller
• Transmittance: 82%±5%
• Driver: Windows®7, VISTA, XP, 2000, ME, 98, NT4.0, CE, XP Embedded,
Linux, Apple®Mac OS
2
Package Overview
3
LCD Display Power Cord VGA Signal Cable
RS-232 Cable
USB Cable ( A to B)
Quick Start Guide
DC Power Supply
Touch Driver CD
Screw
Audio-in Cable
Installation
Product Overview
• Front View
• Bottom View (Without Stand)
POWER SWITCH
DC IN VGA RS-232
USB EARPHONE
AUDIO
4
Kensington Security Slot
The monitor can be secured to your desk or any other fixed object with Kensington lock
security products. The Kensington lock is not included.
5
VESA Mount Your Monitor
This monitor conforms to the VESA Flat Panel Physical Mounting Interface standard which
defines a physical mounting interface for flat panel monitors, and corresponding with the
standards of flat panel monitor mounting devices, such as wall and table arms. The VESA
mounting interface is located on the back of your monitor.
To mount the monitor on an UL-listed certified swing arm or other mounting fixture, follow the
instructions included with the mounting fixture to be used.
Slots ( x 4)
75.00
75.00 96.62
75.00 76.63
! Warning!
Please select the proper screws!
The distance between the back cover surface and the bottom of the screw hole
is 11 mm. Please use four M4 screws diameter with proper length to mount
your monitor.
Please note: the mounting stand must be able to support at least 11 lbs ( 5Kg).
6
7
Start Your Installation
Please follow these instructions so that you can hookup the cables to associated connector.
1. Lay the LCD flat on an even surface.
2. Move the stand into position as seen in the step 2 diagram.
3. Remove the cable cover as seen in the step 3 diagram.
4. Connect the cables to the appropriate connectors as seen in the step 4 diagram.
Use step 4-1 diagram if using the RS-232 serial connector. Use the step 4-2 diagram if
using the USB connector.
5. Position all cables under the cover lip as seen in the step 5 diagram.
6. Re-attach the cable cover. Remove the screw (CBM M3x6) from the accessory box,
and insert the screw into the cable cover and monitor as seen in the step 5 diagram.
Step 5
Step 2
Ste
p 2
Step 2 Step 3
Step 4-2
RS-232
VGA Audio
Power
Step 4-1
USB
VGA Audio
Power
Step 4-2
Step 3
Table des matières
Manuels Écran tactile populaires d'autres marques
IBASE Technology
IBASE Technology ASTUT-152-RE1S Manuel utilisateur
YASKAWA
YASKAWA TP 610C Manuel utilisateur
B&R
B&R Power Panel C Series Manuel utilisateur
Beijer Electronics
Beijer Electronics X2 control Manuel utilisateur
AXIOMTEK
AXIOMTEK GOT321W-521 Manuel utilisateur
TRIDONIC.ATCO
TRIDONIC.ATCO x-touchBOX Manuel utilisateur
