Getac T800 ANDROID Manuel utilisateur
Using the T800 RFID and Smart Card
Reader
Introduction
This snap-on module is a 2-in-1 card reader that can read:
Smart cards
RFID (Radio-frequency identification) tags of 14443-A, 14443-B,
and 15693 types.
Hardware Installation
1. Align the module with the back of T800, engage the module’s
bottom tab first and then snap the top tab into place.
2. Firmly press the connector area to ensure the connection. The
module has an icon indicating where to press.
3. Tighten four screws.
Inserting Smart Cards
CAUTION: Do not insert smart cards
when the temperature of T800 is high.
1. Open the cover of the smart card
slot.
2. With the smart card’s chip facing the
module and pointing toward the slot,
insert the card into the slot until
reaching the end.
3. Close the cover.
Reading RFID Tags
You can use the Getac Smart Tag program to read UID numbers
from RFID tags. The program is provided on T800 Driver Disc for
you to install. See the program’s online help to know how to use
the program.
This icon on the module indicates where the RFID antenna is.
For optimal reading of RFID tags, position T800 appropriately.
561812210001 R01
Chip on the
other side
Autres manuels pour T800 ANDROID
6
Table des matières
Autres manuels Getac Lecteur de cartes
