GEONFINO G5 Pro Manuel utilisateur
G5 Pro
Please keep and read these instructions before installation, we also
prepared an instructions video to help you on our Amazon Page. If you
need further assistance, please contact Customer Service by
email:[email protected]
11
12
13
22
23 Gateway management
LowPower/Emergenct Power
24
25
24
25
26
27
2
Installation Video
AboutGEONFINO and
Customer Service
Installation Video
SCAN ME
Please scan the QR code to watch installation
video for the smart lock before you install it.
SCAN ME
1. How to Confirm the direction
of the door
SCAN ME
2. How to add a RFID card
SCAN ME
3. How to restore Factory Settings
SCAN ME
4. How to add Fingerprint
TOP
F. Strike/Strike Box
G. Waterproof Rubber
Pad
TOP
TOP
TOP
1-2/5"
1" (25mm)
2-3/8"(60mm)
1-1/50"(26mm)
35
Measure to confirm that the hole
in the door edge is 1"(25mm).
And measure to confirm that the
door is 1-3/5" to 2"(35mm to
50mm) thick. Measure the size
of the square slot is 2-3/8"x 1-
1/50"(60x26mm).
TOP
TOP
TOP
TOP
180°
180°
TOP
TOP
b
TOP
TOP
TOP
TOP
TOP
×
TOP
TOP
TOP
×
TOP
TOP
The wired IC needs to
be under the deadbolt.
The wired IC needs to
be under the deadbolt.
1 1/2" ~ 2 1/8"
Put the mounting plate on the waterproof rubber pad
d
G
The wired IC and tail bar go through the hole
of mounting plate
Make sure the wired IC is
not too long.
Look at the door from the OUTSIDE
Adjust the Toggle Switch (in the bottom right
corner of the back panel) and Turn Piece.
Flip to L for Left-handle Flip to R for Right-handle
Horizontal for Left-handle Vertical for Right-handle
Table des matières
Autres manuels GEONFINO Verrouillage
